Question about 1999 Kia Sephia

1 Answer

Emission problems my check engie light is on and im not sure what to do. it still runs and isnt over heating. i believe its a snesor but im not sure so how do i tell??

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 56 Answers

First thing is to check all of your fluids. Oil, antifreeze, brake fluid, etc...
Auto parts stores like Autozone and NAPA have a small computer that they can plug in under the dash of your car and tell you what the problem is. The Auto parts stores where I live will usually do this for free of charge. If it is a sensor they should be able to tell you which one and how to get to it!

Posted on Nov 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

P0455 is there error code im getting

You can't do anything but a repair shop with Evap System
Schematic,Evap Smoke Machine & Scan Tool can find the
problem in ten min & resolve in half hour if they have a parts
needed & delivered to install

If it is a hose your done in 20 min

Jan 31, 2013 | Cars & Trucks

1 Answer

Check engie light is on my 1998 BMW Z3 . The car has around 145,000 miles. The gas tank has around a quarter of a tank. I was driving down the road and stopped at intersection and started to acceralate and...

If it is running that rough , I would not be driving it no farer then to a BMW Delership to have it scran, Before you do serious damage to the (Engine) Unless you have money to (Burn)

Nov 10, 2012 | Cars & Trucks

2 Answers

Gas cap light is on

ok fords have always had this problem since early models but only would display as a check engine code. it grew so common that a secondary light was installed in the clusters to warn you. it means either your gascap seal is bad or you have a ruptured line or bad snesor or selenoid somehwere along you vehicles emission control system. this system maneges vapors and fumes from the gastank back and fourth pressurizing and vise versa the fuel tank as well as allowing your engine to swallow these fumes. youd need a shop or your trusted dealer to tak a look at it because otherwise you might end up changine part after parrt without pinpointing a solution.

Feb 06, 2011 | 2006 Ford Explorer

1 Answer

I have a Jeep Grand Cherokee Laredo 2007(3.7),with 33,000 miles in it. The OBD-Code diagnose was P0430 B (Catalyst System Efficiency Below Threshold(Bank2). I change the 2 oxygen sensors on the...

If the diagnostic code wasn't cleared with a scan tool and thus turning off the engine light; it will stay on for this code until the engine computer no longer detects a problem. For emissions control parts that will take a predetermined number of warm up and run cycles, usually about 30.

In other words if the problem was fixed then your computer will clear the code and the engine light will shut off automatically. That is what your dealer service should have told you.

Jan 12, 2011 | 2007 Jeep Grand Cherokee Overland

1 Answer

Im not getting heat in my 1989 ford bronco II. i replaced the thermostat< and still only getting luke warm. im not getting drips in the passenger floorboards, and my windsheild isnt fogging, so i...

You could have an air bubble in the system. It is also possible that the heater core has debris blocking the flow of water. I would check to see that you are getting good circulation by checking the heater hoses near the firewall. If they are both getting hot then you may have an air baffle issue inside the heater box.

Dec 03, 2010 | 1989 Ford Bronco II

2 Answers

I was driving down the highway last nite with the a.c. on and the cruise on and listening to radio and all of a sudden my cruise control kicks off by it's self and the check engie light came on!? The check...

possably a vacuum leak. the check engine light comes on with an emmissions issue, ie vac leak, and it will not allow the cruise to work. once the error is fixed, your cruise should work properly again

Jun 20, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Runs good with ecm un-plugged in, but when plugged in runs rough

Static timing should be 10 deg btdc you can check that timing when you disconect the tan/black trace wire there should be a weatherproof connector for this wire near the Left hand inner skirt this wire is called the set timing connector and when disconnected stops the ecm from adjusting the timing.

Apr 23, 2009 | 1987 Chevrolet Camaro

1 Answer

1996 doge intrepid wont pass emission test because IM monitors ar

Just maybe your O2 sensors are not operating properly. They may be requiring your engine to heat them up to get upper temperature readings but not lower. You can easily diagnose these and all other sensors and problems by purchasing a Hains manual at your local Auto Zone or Advance auto store which will greatly aide you in diagnosing all your auto needs. And the fault symptom index at the beginning of the book will ease your troubles with professional one on one advice with step by step instructions. Its like having your own ASE certified mechanic at your finger tips. Good luck.

Jan 04, 2009 | 1996 Dodge Intrepid

2 Answers

Failed smog cause check engine light

I can tell you for sure that all US models of the Ford Ranger came with a emission system that incorporated a MIL or check eng light, go to the dealer and have them run your VIN on the Ford on line information service, that will give you the engine Calibration of the emission system, you can then find out what emission system was used, export or US.

Oct 06, 2008 | 1987 Ford Ranger

2 Answers

Im trying to locate the knock sensor.thank you

there are 2 knock sensors located under the intake on the V8 engines.

Jul 15, 2008 | 1990 Chevrolet C1500

Not finding what you are looking for?
1999 Kia Sephia Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

81294 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides