Question about 2000 Jaguar Den Plas Supercharged
What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.
Posted on Sep 19, 2008
no there is'nt enough pressure underneath to make it leak try tighting up the valve cover bolts or just getting a new gasket about a $6.00 to $10.00 dollar fix depending on where you go
Posted on Dec 02, 2008
By design, anything that is open or unlocked will close when you turn the key to lock the door....Not sure if its a problem?
Posted on May 22, 2010
SOURCE: I just bought a used
use wd-40 or liquid wrench and a tooth pick- use toothpick to hold the little metal flap in lock back and spray oil inside- locks weren't uses much as you have remote locks- lack of use can cause rust/lockup
key will start engine? if not- you might have gotten the wrong keys- or there might be a different one for the door locks from the ignition key
Posted on May 30, 2011
Tips for a great answer:
May 29, 2011 | Jaguar Vanden Plas Cars & Trucks
Oct 06, 2010 | 2006 Jaguar XJ8
Aug 31, 2010 | 2000 Jaguar Vanden Plas
Aug 05, 2010 | 1989 Jaguar Vanden Plas
Jan 15, 2010 | 2001 Jaguar Vanden Plas
Jul 17, 2009 | 1989 Jaguar Vanden Plas
Dec 01, 2008 | 2000 Jaguar Vanden Plas
Oct 06, 2008 | 1990 Jaguar Vanden Plas
59 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: