Question about 1991 Peugeot 405

1 Answer

106 electrical my indicators and wipers have both stopped working at the same time .anyone know why please

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 193 Answers

The first and most obvious step is to check the fuses. Peugeot did not have the greatest electrical system on the 405. If the fuses are good, try to check the wiring harnesses to each of these components.

At one time I was a factory training Peugeot technician.


If you would like to correspond further with me on this or any other issue, please feel free to do so.
Bill
ASE Master Technician


Posted on Nov 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Service electrical system is flashing what does it mean my car is a Cadillac Seville 2003


WHEN SERVICE ELEC SYSTEM IS FLASHING. PLEASE CHECK FOLLOWING:-

1. Check for a voltage drop to the Power Train Control Module (PCM) and Electronic Brake Control Module (EBCM) when the problem is happening.

2. If the voltage is less than Battery Voltage (B+) when the problem happens check for a voltage drop through the ignition switch. Tech Tips: SERVICE ELECTRICAL SYS - 106
The IPC illuminates the SERVICE ELECTRICAL SYS -- 106 message in the DIC when one of the following conditions exist:

• The Dash Integration Module (DIM) detects a malfunction that is related to the ignition switch.

The IPC receives a class 2 message requesting illumination from the DIM.

• There is a Powertrain related code present.

The IPC receives a class 2 message requesting illumination from the PCM.

Conditions for Setting the DTC P1574
A 2.5 mph or greater decrease in non-drive wheel speed in 0.4 second and extended travel brake switch or TCC brake switch indicating brakes applied and no transition noticed in the stop lamp contacts of the stop lamp switch.
ALSO CHECK FOR FAULT CODES IN THE OBD.

Apr 05, 2015 | 2003 Cadillac Seville

1 Answer

I have a 2008 jeep rubicon that the headlights the indicator lights the wipers and air condition stop working the same time


LIGHT INDICATOR AND WIPER ALL PART OF YOU SWITCH ON THE STEERING COLUMN .BUT FIRST READ YOU MANUAL AND CHECK ALL THE FUSES.INSIDE AND OUTSIDE THE JEEP.NEXT FOLLOW THE GROUND WIRE FROM THE BATTERY AND MAKE SURE THE WIRE IS CLEAN AND TIGHT TO THE BODY.MORE GROUND WIRE WILL FIND UNDER THE DASH BOARD CLOSE TO THE DOOR HINCH.
GOOD LUCK

Mar 27, 2014 | 2008 Jeep Wrangler Rubicon

1 Answer

Rear wiper, rear defroster & rear wiper fluid all stopped working at the same time. bought a new rear wiper motor installed it and nothing... anyone having or had the same problem in the past?


Check fuse panel ...if fuses for those rear devices are OK look at the wiring at the rear hatch. Possibly inside that door, or a ground condition that is not functioning or disconnected connector related to electrical devices in the rear hatch door.
Good luck!

Oct 20, 2013 | 2004 Ford Explorer

3 Answers

When i turn my wipers off they stop in an upright position the wipers work but when off they wont go to home position


There is a piece in the motor that tells them to go home - so try this
take the entire wiper blade off the car - turn on the motor - and then shut it off - now
put the entire units back on where they should stop
please let me know if this fixes your problem.

Mar 25, 2010 | 2002 Chevrolet Impala

1 Answer

Indicator problems when it rains on a Peugeot 106


is ther water getting into your lamp units

Feb 25, 2010 | 1991 Peugeot 405

1 Answer

Windshield wipers on 1998 chevy venture


that was probably because it wears the engine that drives them to work. carry some internal contacts are called brushes and these are over. may also be that your system is damaged electrical wiring. or the alternator current nesecitas fail to bring a workshop to review electric luck

Aug 24, 2009 | 1998 Chevrolet Venture Cargo

1 Answer

Which fuse controls the windshield wipers??


There is no separate fuse for intermittant. You have a wiper fuse, and that's all. If that part has stopped , you have a probel with the switch, or the circuit board for your wiper motor.

Jun 06, 2009 | 1998 Isuzu Amigo

1 Answer

1987 Volvo 240 Wiper motor to wiper turning mechanism problem


It's the part which contains the electrical connections and the park switch.

May 05, 2009 | 1987 Volvo 240

1 Answer

Rear Lights and Wiper Problem


any time you have a crazy electrical problem always check ground connections

Jul 23, 2008 | 2002 Dodge Dakota Club Cab

Not finding what you are looking for?
1991 Peugeot 405 Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...