Question about 2002 Pontiac Bonneville

1 Answer

Heat/AC blower not blowing air

There is heat, but no fan to blow it

Posted by on

  • Anonymous Dec 23, 2008

    heater works but blower will not work. have checked fuse for blower & it is good.

  • Anonymous Mar 21, 2014

    climate control will not work what is set to. control does not turn on ac nor heat and will not blow where needed



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Pontiac Master
  • 81,400 Answers

Heck the blower fan speed control resistor, it is located near the blower motor, they are cheap to replace and the most common cause of this issue

Posted on Nov 24, 2008


5 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 66 Answers

SOURCE: 1995 chevy blazer heat, ac will not blow air

yes the heater controls are vacum however the blower motor is not. a new control panel is an option and may fix it. if it was my blazer i would first check the fuse boxes onder the hood and in the side of the dash driver side. if they are good i would go to the nearest auto parts store and buy a test light. this will aid you in making sure what the problem is before you go spending money on replacement parts. the blower motor is in one of two places. its most likely under the dash on the passenger side. there is a cover that you will have to remove directly under the glove box. once removed you should see a large red and a large black wire. these are the power and ground for the blower motor . in some gm's these wires go into a resistor. the harness plugs into the resistor and the blower motor wires come out of it. ok now that we are a little bit familiar with our suroundings the red wire i told you about is the hot wire if you ground the clamp on the test light to the door hindge. (make sure its a good ground by touching the positive batter terminal. if the test light lights its a good ground )now unplug the blower motor and touch the metal posts in the end of the plug that belong to the red wire. if it lights when the key is on and the blower control is on in all posisions you need a blower motor. if it does not then you need a blower motor resistor.

Posted on Jan 24, 2009

  • 308 Answers

SOURCE: 1998 BMW 328i heater/AC blower is not running

You have clean the blower unit , may be its dirty then . and then check the blower resistor unit for malfunction.

Posted on Aug 04, 2009

  • 11800 Answers

SOURCE: The blower works blowing only cold air no heat? I

The heat is generated by a radiator located in your dash using engine coolant. You don't have heat because the valve that is controlling the coolant flow is closed - either it or the commands that is controlling it are broken - find which and fix them.

Posted on Nov 22, 2009

Testimonial: "Is this valve easily accessible? How do you keep it open? Commands, is that computer realted?"

  • 4376 Answers

SOURCE: No heat coming out fan blows but no heat

you could have air trapeed in the cooling system. If so, go to shop with evac/fill equipment to burp the air.

ALso, feel the heater hose going into the heater core and out of the heater core. They should be hot. They are about 1 inch round and go into the firewall behind the engine.

Is the engine temperature normal? If not, replace the thermostat.

I assume you have electronic system since you said you push a button. Perform this test and get codes

  1. If inspection reveals obvious concern(s) that can be readily identified, service as required. If the concern(s) remains after the inspection, perform the following EATC On-Board Diagnostic:
  1. NOTE: If sent to this section from Section 18-04, perform the EATC On-Board Diagnostic, record any or all diagnostic trouble codes (DTCs).

    • The EATC On-Board Diagnostic will detect concerns in the system control functions found during the On-Board Diagnostic and will display (DTCs) in addition to intermittent (DTCs) for concerns that occur during system operation. The vehicle interior temperature should be between 16° and 27°C (60° F and 80° ) F when performing the On-Board Diagnostic. If the temperatures are not within the specified ranges, false in-car temperature sensor error codes will be displayed. Record all error codes displayed during the test.
    • If any (DTCs)appear during the On-Board Diagnostic, follow the diagnostics procedure given under ACTION for each DTC given.
    • If a condition exists but no (DTCs) appear during the On-Board Diagnostic, refer to the Symptom Chart Condition: EATC System Inoperative, Intermittent or Improper Operation .
    • The On-Board Diagnostic can be initiated at any time with any resulting DTCs displayed. Normal operation of the system stops when the On-Board Diagnostic is activated.
    • To enter the On-Board Diagnostic, press the OFF and FLOOR buttons simultaneously and then press the AUTOMATIC button within two seconds. The display will show a pulse tracer going around the center of the display window. The test may run as long as 30 seconds.
    • To exit On-Board Diagnostic and retain DTCs, push the blue (cooler) button. The control will exit On-Board Diagnostic, retain all DTCs and then turn OFF (display blank).
    • To exit On-Board Diagnostic and clear all DTCs, press Defrost button. The vacuum fluorescent display window will show 000 and all function symbols for one second. Then, the EATC Control will turn OFF (display blank) and all DTCs will be cleared.
    The On-Board Diagnostic should be deactivated before powering the system down (system turned OFF). Intermittent DTCs will be deleted after 80 ignition switch ON cycles after the intermittent condition occurs.

    EATC SYSTEM ON-BOARD DIAGNOSTIC TROUBLE CODE CHART Trouble Code Detected Condition Action 024 Fault in blend door calibration during self test GO to Pinpoint Test B . 025 Intermittent fault in blend door calibration GO to Pinpoint Test B . 030 On-Board Diagnostic indicates automatic temperature control sensor shorted GO to Pinpoint Test G . 031 On-Board Diagnostic indicates automatic temperature control sensor open GO to Pinpoint Test G . 040 On-Board Diagnostic indicates ambient sensor short GO to Pinpoint Test C . 041 On-Board Diagnostic indicates ambient sensor open GO to Pinpoint Test C . 042 Ambient sensor intermittent short GO to Pinpoint Test C . 043 Ambient sensor intermittent open GO to Pinpoint Test C . 050 On-Board Diagnostic indicates sunload sensor short GO to Pinpoint Test D . 052 Sunload Sensor intermittent short GO to Pinpoint Test D . 115 Intermittent engine coolant temperature signal GO to Pinpoint Test N or Pinpoint Test P . 125 Intermittent vehicle speed signal GO to Pinpoint Test N or Pinpoint Test P .

Posted on Feb 28, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1977 Buick blower / fan comes on however NO heat blower / fan also blows very low.

Buick LeSabre Heater - RepairPal > Problems > Buick > LeSabre
Buick LeSabre Heater blows only cool air...even w/ defroster on. This is a ... Heater fandoesn't come on . ... The blower works but there is no heat coming out.

Blower Motor Problems ' Auto Repair Help - YouTube

? 4:22
Sep 27, 2009 - Uploaded by mgittelman
The blower motor is a common heater/AC repair within the skill level of ... However if the power wire is a single light purple wire and the ... for blower motor and fuel and relay good but no powercoming on both any ideas? ... my o5 seira, when i start the engine with the air switch on it blows my blower fan ...

Car Air Not Blowing, Heat & Air "How to" Test Testing ...

? 6:22
Apr 5, 2013 - Uploaded by Fixbook
Here I show how to determine the problem if your air, or blowermotor is not ... Click here to check out the the "Car Runs on 2 cylinders" series: ... How to Fix Over-Heating engine & No Heat in car - Buick (2000 yr) Park Ave . ... Car fan / AC only works on high - Replacing the Blower Resistor - Duration: 4:24.

Buick Park Avenue Questions - NO HEAT!!! - CarGurus

Jan 30, 2016 | 1977 Buick Electra

1 Answer

My AC some times blows cool air with good pressure but most of the time blows air with low pressure. I have checked the AC pipe also. Its cool.

I'm wondering if it's NOT the AC but the blower fan, how does the heat side blow? if it's good on all blower settings then, it's more than likely your blender door is not opening and closing all the way. When the blender door stays open a little bit it'll let warmer outside air mix with the cold AC air causing it not to be as cold as it should.

Sep 19, 2015 | 2005 Toyota Corolla LE

1 Answer

Heater doesnt work

To troubleshoot this types of problem,click the link below :---
Car heater blowing warm, but not hot air?

Engine Overheats and heater blowing cold?

Heat blows cold on drivers side and hot on passenger side?

No heat on car?

Heater blows intermittently and temp gauge goes erratic?

Heater blows cold?

Heater/AC blower motor not working?

A/C, heater, defroster fan, not working? Heater problem?


This will help.Thanks.

Mar 27, 2012 | 1994 Volvo 960

1 Answer

My heater is not working except on one side in my 2007 impala driver side it blows warm passenger cold

To troubleshoot this types of problem,click the link below :----
--------Go through the procedure to confirm the issue.

Engine Overheats and heater blowing cold?

Heat blows cold on drivers side and hot on passenger side?


No heat on car?

Heater blows intermittently and temp gauge goes erratic? blows cold?
---------Car heater blowing warm, but not hot air? Heater/AC blower motor not working?

A/C, heater, defroster fan, not working? Heater problem?

This will help.Thanks.

Feb 27, 2012 | 2007 Chevrolet Impala LS Sedan New Cars

3 Answers

My sc1 over heats when at idle and only if ac or heat is turned off as soon as i turn onn ac heat drops imediately

you may want to check on the radiator fan. The AC has its own fan and once AC is on, the fan would help bring down the temperature. It is either the fan is not blowing or has become weak. You can check on the fan by pulling out the temp sensor on the lower radiator hose. The fan should blow at full speed when doing this.

Check on the water reserve the water inside it goes down, if not there may be a leak somewhere. Water vapor may be escaping and lessening the effectiveness of the cooling system. This may be a reason why the engine cools down after the AC fan is on.

Jun 16, 2009 | 1995 Saturn Sc

1 Answer

2002 Nissan Maxima Heat/ AC Blower Noise

I have a 2002 nissan Maxima. The AC controls only blow on level 4. No air or heat blows from level 1-3. What do I need to do to repair this problem?

Jan 20, 2009 | 1991 Nissan Maxima

2 Answers

Heater/AC won't blow out air

blower motor is behind the glove box. also check the blower resistor it should be nex to the blower motor

Oct 02, 2008 | 1995 Mercury Tracer

Not finding what you are looking for?
2002 Pontiac Bonneville Logo

460 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides