Question about 2003 Hyundai Accent

1 Answer

AC works, Heater not working, 2003 Hyundai Accent.

I have Hyundai Accent 2 Door Manual 2003. The AC works but the Heater doesn't work. What could be the problem ?

Posted by on

  • 4 more comments 
  • sidcooper Dec 15, 2008

    I have a 2001 Accent and there is a valve control that got broken when my cd player was jacked. I had a friend move it around and it worked for awhile, but now its cold outside and this thing decided to stop working. Help!

  • Noodleclwn Dec 30, 2008

    I have replaced the thermostat, flushed the radiator (twice). Found a lot of rusty gunk. Found out a new heater core will cost $700.00. Yikes. This is on a 2002 Hyndai Accent. Also weather stripping on windows leaks.

  • Anonymous Mar 15, 2014

    my fuse for my ac is blown where is the fuse for my ac

  • Anonymous Mar 17, 2014

    2003 hyundai accent wont shift properly

  • Anonymous Mar 18, 2014

    2003 hyundai accent takes off very slow

  • Anonymous Mar 23, 2014

    light for the door sensor wont turn off

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

Check the coolant level, do this with a cold engine. Or if you have recently used it. let it cool down for about 25 minutes before removing the radiator cap. if it is low, refill with coolant. If it does not, check your thermostat. Or better yet replace your thermostat. Be sure to get the right one . the same degrees as your old one. Just ask the teller to give you one for your engine size and car Model.And year.See where the radiator cap is. Then drain some coolant to where it will not spill from the radiator cap. Remove the hose nearest the radiator cap and you will get to the thermostat housing. Remove the housing and note how the thermostat is placed. Take of the thermostat housing and the old thermostat. Clean the housing and around the hole where the thermostat goes of any deposits. Get some grease and cover the new gasket with grease on the housing to hold it in place. replace the New thermostat and make sure it is flush with the engine and the housing. If it is off , you could break the housing upon tightening the housing.replace the hose and refill with coolant slowly to eliminate any air spaces.. Also check the coolant reservoir and fill it to the indicator line. Restart the car and chek for any leaks. Then check the heater after the engine heats up. If that does not do the job it could be the temperature sensor or the heater core.The heater core will take more time to check and clean or replace.

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ac light doesn't work


If the ac is working and the light is not then must be a shorted bulb.Replace bulb

Jul 03, 2012 | 2006 Hyundai Accent

1 Answer

Ac works fine but the heat and defogger doesn't work


you need 2 check fuses heater a seperate system

Sep 08, 2011 | 2003 Hyundai Accent

1 Answer

My ac/heater fan stopped blowing. There were no previous problems with the ac. How can I tell if it's just a blower fuse or the fan/motor itself. And where is the blower motor located?


Does it work on all speeds, or has it only stopped on #1 speed for instance....the blower motor is located at the passenger side footwell...

Sep 20, 2010 | 2003 Hyundai Accent

1 Answer

01 Accent AC problems


1. Discharge/Recover the refrigerant. 2. Remove the tension bolt. a4c16f6.jpg 3. Remove the V-belt and magnetic clutch wire harness connector.
d768bec.jpg
4. Remove the suction hose and discharge hose from the compressor. 5. Remove the 4 mounting bolts on the compressor.
3bb9fac.jpg 6. Remove the compressor downwards.

INSTALLATION IN REVERSE ORDER
1. Tighten the 4 compressor mounting bolts.
2. Connect the suction hose and discharge hose to the compressor. 3. Connect the V belt. 4. Adjust the V belt tension.5. Reconnect the magnetic clutch wire harness connector.

Jun 04, 2009 | 2001 Hyundai Accent

1 Answer

2003 Hyundai Accent wippers not working


You must have used a wrong fuse in it. Please check some other fuses that might be the problem.

It is a minor issue.

rate this.

Mar 24, 2009 | 2003 Hyundai Accent

1 Answer

Window glass handle


If no screw in center of handle, push in on door panel & look behind handle for a clip snapped into back of handle. They have a tool for removing if you can't get to it, which should be pretty cheap at auto parts store.

Dec 28, 2008 | 2003 Hyundai Accent

Not finding what you are looking for?
2003 Hyundai Accent Logo

1,029 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...