Question about 1992 Mitsubishi Diamante

1 Answer

My mitsubishi diamante cuts off during idle.

Theres a clicking sound under the dash on the passenger side just before it cuts off, it starts right back up but chokes back out with the clicking.

Posted by on

  • Anonymous May 02, 2009

    My car does exactly the same problem, we've tryed wiggleing wires, and pulling off connectors just trying to find what sensor could actualy kill the damn thing!, everytime the click starts, the "check engine" light comes on, and then it will click back on, and switch the light off, and then sometimes it will continuously click on and off, only leaveing me at a standstill on the side of the road =(

    everytime it clicks, and puts the error light on, its as if the ignition has just been cut out on me ?


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi i have the same car same problem try changing plugs and wires car is over heating then starts again when it cools off

Posted on Jan 19, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Mitsubishi diamante electronic door switch problem

the following checks need to be made.
All listed components are all share a fuse , and all share the same ground, G200.
Check the fuse/circuit breaker for power on both sides, if OK, follow the harness to connector C214 a 12 pin connector to the right of the glove box opening to see if there is a problem there.
Ground 200 is located on the toe plate at the front edge of the passenger's front door. Check for bad connection there.
If everything is good up to this point you will check The Black/White wire that runs through the main harness under the dash, and splits into several Black/White wires at splice S245, in the main wire harness under the driver side of the dash.

Info from:

Apr 08, 2014 | 2000 Mitsubishi Diamante

1 Answer


if its smoking thats a shorted system..if you feel safe with fixing it do so otherwise get rid of that deathtrap..

Dec 25, 2013 | 1992 Mitsubishi Diamante

1 Answer

How to install a computer, injector pulsation in a 2000 Mitsubishi Diamante and where is it located in the car

the PCM (computer) is located under the dash board in the middle the passenger side and driver side remove the 2 plastic caps and will be a black box with 4 connections

Sep 04, 2012 | 2000 Mitsubishi Diamante

1 Answer

When i start my 1993 mitsubishi diamonte the rpms drop and the car shuts off.

try ajusting the idle cable under the bonet by loosening the 2 nuts and tighten them when the engine is idling at the right rpms which is around between 8 & 10 when engine is hot

Jul 30, 2010 | 1993 Mitsubishi Diamante

1 Answer

Location of heater blower motor

Normally located on passenger side under the dash behind the glove box.

Dec 11, 2009 | 1992 Mitsubishi Diamante

4 Answers

Where is fuel filter located on 1992 Diamante?


On the first gen diamante its located in front of the passenger side firewall closer to the middle close to the bottom.if in doubt follow the fuel line.


Jul 31, 2009 | 1992 Mitsubishi Diamante

2 Answers

Mitsubishi Diamante 1995

might I suggest dynamite. Wait till you try to do a tune up. Try looking at

Jan 08, 2009 | 1992 Mitsubishi Diamante

1 Answer

I have a 2003 mitsibishi diamante that has a loud clicking coming from the passange side dash at start up. i can not see that it causes any mechanical problems with the car, but is very annoying for about...

Its the electric actuator motor that opens and closes the fresh air door for the a/c. You will notice the clicking stops when you adjust the a/c temperature setting during the clicking. I got a replacement for my 99 from a junkyard and changed it out. I've seen dozens of complaints of this problem online.....i had thought it was only mine. I guess it was a poorly manufactured part.

Aug 29, 2008 | 2001 Mitsubishi Diamante

Not finding what you are looking for?
1992 Mitsubishi Diamante Logo

Related Topics:

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

68032 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22011 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides