Question about 1994 Chevrolet Sportvan G30

1 Answer

Removing the starter.

How do you remove the starter from a 1994 chevy S-10 pick up

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 62 Answers

Jack the truck up crawl under the truck unbolt the starter and unhook the wires, pull the starter out and put the new one in. I hope that helps you out man.

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Removing a starter from a 1991 chevy s-10 blazer 4x4 , 4.3L v6...


The starter is under the vehicle on the passenger side. The best way is to turn your wheels to the left so you can reach the top of the starter solenoid behind the passenger tire. First undo the nuts from the solenoid terminals, second loosen the bolts holding the bell housing for the flywheel and slide it over enough to make room, third undo the starter mounting bolts and the starter should come out easier. And just reverse the steps for installation.

Jan 07, 2011 | 1991 Chevrolet S-10 Blazer

3 Answers

Where is my fuel pump located in a 1994 cheyenne chevy pick up 4x4 5.7 v8


Hello
The fuel pump is elelctic and it is located inside the fuel tank, the fuel tank must be removed to service the fuel pump.

Nov 11, 2010 | 1994 Chevrolet C2500

2 Answers

Trying to locate the ignition module for chevy blazer s10 1994


Ignition module sits in the ignition distributor, remove distributor cap, there will be two elec. harness plugs, the one with two wire's is for the pick up coil, the other one is for the ignition module, just unscrew module out of distributor and install new one.

Sep 23, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

How do i remove a starter from a 1994 s10 pick up with a 4.3 v6


<0001>
Disconnect negative battery cable. Raise and suppor
t vehicle. Disconnect electrical wiring from starte
r
solenoid. Remove mounting bracket and wiring from b
rush end of starter. Remove skid plate (if equipped
).
Remove 2 brakeline-to-crossmember brackets.
<0001>
Remove 6 crossmember bolts and remove crossmember.
Remove transmission cooler line-to-flywheel
housing bracket. Remove brace rod to flywheel housi
ng. Remove lower flywheel housing cover (if necessa
ry).
<0001>
Remove starter bolts. Note location and number of s
hims for reassembly. Remove starter. To install, re
verse
removal procedure.

Jun 22, 2010 | 1994 Chevrolet S-10

1 Answer

Removing starter from a 2000 3.4 chevy impala? I


try sliding it backwards and let the nose fall first, may require pressure but it should work

Jun 09, 2010 | 2000 Chevrolet Impala

2 Answers

Wont start


could be switch on back of ignition lock?

Jul 09, 2009 | Chevrolet 1500 Cars & Trucks

1 Answer

91 chevy s10 2.8 motor


you should remove a exhaust brace arm there are three bolts it clears a lot of space and also you can get back to the nuts on the starter through the fender well just take of that plastic

Jan 30, 2009 | 1991 Chevrolet S-10

1 Answer

1991 s-10 starter removal


whats blocking it? i need a lil more info...il try to help as much as possible.

Sep 30, 2008 | 1991 Chevrolet S-10

2 Answers

Removing starter from S10 blazer


Have you removed the 2 nuts making electrical connection to the starter? I just did this and was able to get the starter out. Could not get it out until I removed the 2 nuts.

Jun 21, 2008 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
1994 Chevrolet Sportvan G30 Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...