2001 Toyota Corolla Logo

Related Topics:

Anonymous Posted on May 22, 2012

Clicking on right side and hestattion on takeoff

Sometimes it drives well with out any problems and then sometime it hestates and makes a popping noise or some sort of clicking noise on what sounds to be driver side.

  • Anonymous May 22, 2012

    it hestates during takeoff,someone said it could be my o2 sensor.

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 6 Answers
  • Posted on May 22, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: May 21, 2012
Answers
6
Questions
0
Helped
551
Points
0

Ya Sunday like C.V. axle that will do that if tha boot os busted ill see sights of it busted grease ever where n the bearings r dry

  • Anonymous May 22, 2012

    it only does this sometimes during takeoff.it hestates real bad to the point it doesn't want to go.but once you get going over 35 mph it drives great.

×

5 Related Answers

Anonymous

  • 1861 Answers
  • Posted on Apr 07, 2009

SOURCE: Car will not start right away...makes awful noise

It looks like you have an issue with the starter not engaging the flywheel correctly. Does it make a BrrrrRRRRRRRRRRP noise? Best advice: Replace the starter. Do not get it rebuilt. If you replace the starter ASAP, you may be OK. If not, you are going to have to have the transmission pulled, and you will have to replace the flywheel; that is what is being damaged by the bad starter drive. This is, unfortunately, a common issue.

Thanks for choosing FixYa for advice!

A FixYa rating (4 blue diamonds) would be most appreciated, this is how we are scored. Thanks in advance.

Toyota Ed

Ad

Anonymous

  • 116 Answers
  • Posted on Apr 10, 2009

SOURCE: my 1998 standart tercel sometimes make noise from my front wheel

bad cv axle

bad engine mount

Anonymous

  • 91 Answers
  • Posted on Apr 12, 2009

SOURCE: drivers side brake smoking after driving and rubbing noise

Your caliper is locked up. Change the break hose and caliper, you will also need new pads as the ones thats on there will have glazed over.

Anonymous

  • 3600 Answers
  • Posted on Jun 19, 2009

SOURCE: 2006 toyota sienna thumping noise on drivers side

Has the upper strut bushing been replaced? Have you checked to see if the wheel is loose? To do so jack up the side you here the noise on and use a tire tool or piece of pipe and jack up the wheel when till it's off the ground about an inch enough to get you bar under the wheel. Next pull up on the wheel with the bar if you feel a clunk then get a second person to pull the lever up and down and see where the looseness is, if there is no looseness when prying up and down then you will have to wiggle the wheel from left to right to see if you can find the noise, a also you will have to pull on the drive axle to see if it's loose once you determine what is loose then you can tell me and I will tell you what has to be replaced.

Anonymous

  • 3600 Answers
  • Posted on Jun 19, 2009

SOURCE: thumping noise in front drivers side wheel and

Check your suspension bar and check your front strut assembly, jack up the side you here the noise on and pry against the tire to see if you have any movement between the strut housing and the frame, make sure the top strut nuts are tight, if they are next check tie rod ends to see if you have any play, next pull the wheel from the top and bottom to see if it's loose if it is watch while someone else wiggles the tire, you could have a tie rod loose or a king pin loose. Also it could be a wheel-bearing nut. Let me know what you find so I can tell you how to replace it.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Why does my 1995 Oldsmobile Cutlass Ciera (4 dr, V6) make grinding noises when starting to drive? It only happens during takeoff, and sometimes while driving and accelerating hard. Just replaced cv joint...

Sounds like either the Torque convertor, going bad. Could also be the clutches in the trans. Did you replace both the inner and the outer CV joints, both side ? Also check your the outer bearing where the CY joint goes through at the wheels
0helpful
1answer

Why does a 2003 monte carlo hestates when taking off from start

Ever do any Preventative Maintenance -or just drive it?
0helpful
2answers

Clicking noise

take a visual look under the car if anything loose. Any lights coming on? ARE left and right signals ok- sometime they make clicking noise.
0helpful
1answer
0helpful
1answer

1999 Ford Ranger jerking in the rear

The rear brakes may have some oil on them which will cause sticking/grabbing braking. Usually from leaking brake cylinders or calipers/wheel bearing seals. Pull each wheel and check. Another problem could be a bad 'U' joint at either end of the driveline. Make sure the emergency/parking brake is fully released. It's possible that a rear axle bearing is going out, but they will make a rough sound when moving. Make sure that the spring mounts are tight. Check the oil level in the differential. Shift from forward to reverse several times to see if this reoccurs each time. Get someone to watch and listen while you do this. Hope this helps!
1helpful
1answer

When im driving my truck i can here a clicking noise coming from the outside of driver's side. It would come off and on, or sometime when i reverse and sometimes depend on how fast the truck is moving....

Sounds like you have a bad CV joint. Roll down your windows and drive the vehicle slowly while turning to the left and right. If you hear clicking coming from your drivers side then your CV joint bearings are worn. Replace the CV arm.
0helpful
1answer

Once I start my 1994 Jeep Grand Cherokee it starts hestating.

check idle control valve mounting hardware & electrical connection on tbi. do not over torque bolts.
0helpful
2answers

Driver side window

window regulator stripped(driven gear) or motor teeth(drive gear)
1helpful
3answers

I have a 1989 Toyota Supra GA70, It has an A340E Autoatic Transmission. The problem is sometimes during takeoff it is very sluggish, this only happens sometimes, and other time it takes off normally. ...

EASY! first take down the valve body and remove the soleniods, they may not need replacing, inspect and cean them, it could just be debris! reinstall everything, if the problem still occurs replace just the solenoids
Not finding what you are looking for?

147 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...