Question about 1986 Nissan Sentra 4 Door

1 Answer

89 nissan sentra won't start...

I have a 89 nissan sentra 1.6L 2 door. i had hit a dear doing about 45mph(i dont know how fast i was going because the speedo dont work eather). I had replace the the head and other parts. About 4 days later i there was smoke coming from the moter. I had found a hole in the ratiator. Put more water in it and drove it home. i fix the leak( so i thought) with JB stick. Went to drive it to portland and had come to stop were it died... pushed it off to the side of the road were it sat for about 30mins. it finally start start to drive it back were it start to make a loud lifter nock... pulled it off to the side of the road and went to turn it off and it would not shut off. the key was out and the lights were off. it finally died and has not start sence then... it will turn over but not start. what is the problem... Please help...

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

If you hit a deer , and the car ran hot, it could hvae damaged the engine . the rings and bearings. thats where the knocking is coming from. Check for compression using a compression testor. it is put inside the spark plug hole. While the engine is cranked. it should mark about 55 on the dial. Check all the cylinders one at a time replacing the plugs back as you go.

Posted on Nov 24, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the dimmer relay located on a 89 nissan sentra


open hood, look next to battery, am I going to fast, do you see a black box , pull off lid, these are called relays, the lid should tell you which ones. good luck

Jan 12, 2013 | Nissan Cars & Trucks

1 Answer

My nissan sentra 2011 won't start and doors can't open


Its under warrenty for 5 yrs so call the dealer as it may have a fault with the key ,does it have a key hole that you can see try the manual key part in here and open with the key then it will start

Dec 06, 2012 | Nissan Sentra Cars & Trucks

1 Answer

89 nissan sentra axle going in and out of transmission when i had it up on a lift & engaged. What hold that in?


The axle (called a "Half shaft" in front wheel drive cars) is held in by a internal round Snap Ring, either this snap ring is damaged or the axle is badly worn or the groove the round snap ring expands into is worn and not retaining the axle. Replace the 1/2 shaft first, it the problem persists you will need to replace the transmission side case casting

Oct 07, 2011 | 1989 Nissan Sentra 4 Door

1 Answer

1992 nissan sentra starter replaced, inhibitor relay replaced still wont start. googled to replace the starter relay couldnt find location and was inform this year and model has none. Please help , has...


my 1992 nissan sentra will not start. It will trun and turn but will not start. when it does start.It missing alot and turn off very fast then it just turns but won't start

Dec 16, 2010 | 1992 Nissan Sentra 4 Door

2 Answers

1998 nissan sentra lost pick up speed and is jerking


first remove your map sensor and clean it with carburetor cleaner let it soak for a few hours and then reinstall it sometimes they get dirt or carbon build up and the pcm cant tell how much fuel to send

Jan 27, 2010 | 1998 Nissan Sentra

1 Answer

How do I get the outer cv joint apart on a 89 nissan sentra to put on a new boot?


u r better off buyin a rebuilt axle its cheap and comes with it and its less of a headache

Sep 10, 2009 | 1989 Nissan Sentra 4 Door

1 Answer

I wanted to know how to get the rotor cap off of a 89 nissan sentra.


look very close you will see screws at the bottom of your cap usually they are phillips head.Undue them and lift the cap off.remove and replace your wires one at a time Always.

Aug 03, 2009 | 1989 Nissan Sentra 4 Door

1 Answer

Just wondering what other nissan model hood will match up to my 89 nissan sentra


i found a website but i cant remember what but i googled it and a brand new hood was 40 bucks

Jan 11, 2009 | 1989 Nissan Sentra 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...