Question about 1984 Ford F 150

1 Answer

1984 Ford F150

Just curious did you get your 84 f150 running smooth I am having the same problem with my 84 ford f150 4x4 i see theres a hose with a screw in it and i brought it to a mechanic to fix the throttle cable and asked em to look at anything else that might be wrong they said the main cylinder is leaking and the vacuum hoses need fixed or replaced got any suggestions for me? email me back at michaelrussell00@yahoo.com Thanks any help would be appreciated....

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 122 Answers

If the vacuum lines are deteriorated and cracked, they will make the engine run rough, uneven, and hesitant. All you have to do is take the lines off one at a time (so you don't mix them up) and change them out with new lines.

Posted on Nov 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is relay? RY71T is part # for 84 ford f150


LOOK IT UP ON LINE. RY71T FIR 84 FIRD F150 MANUAL

Feb 03, 2015 | 1984 Ford F 150

1 Answer

1984 FORD F150 PISTON COMPRESSON


you can use three different gauges and get three different results with a calibrated gauge the readings 125-165 with a no variance greater than 15 psi for smooth idle 25 psi slight rough idle. test calibration against a air compressor blow a air chuck into gauge and compare to compressor gauge.

Nov 07, 2013 | 1984 Ford F 150

1 Answer

WHAT IS THE TIMING FOR A1984 FORD F150 PICKUP?


spark timing on 84 ford f150 10 degres btdc

Dec 31, 2012 | 1984 Ford F 150

1 Answer

Clutch pedal was ok, 84 Ford F150 4x4 351 W w/4speed, then went to the floor?


Sounds like the slave cylinder went out. If it's inside the bell housing...do a complete clutch job while you are at it.

Jun 06, 2012 | 1984 Ford F 150

3 Answers

What causes the computer to read bank 1 to lean, bank 2 to lean. It also idles rough and will stall out while stopped. Runs great at operating speeds. It's on a 2004 F150, 4x4, 5.4 vin code 5.


More than likely you have a vaccume leak.Check arround the intake looking for any broken vac.hoses(especally the PCV hose) all the way up to where it connects to the intake.Could be a bad mass airflow sensor, but more likely a vac. leak.

Apr 21, 2011 | 2004 Ford F150

1 Answer

What line runs to your front drivers side hub on a 2004 ford f 150


there may be two to three lines running to that: 1-brake hose, made of strong rubber & connected to a steel pipe. 2- wiring for wheel speed sensor that has a conduit around it for protection, & if 4x4 will be a vacuum hose straight to top of hub, used for 4x4 engagement, if loose 4x4 will not engage.

Feb 11, 2011 | 2004 Ford F150

1 Answer

Where can I find the fuel filter on a 1984 Ford F150?


A 84 should still be carburated. And someone could have added a filter between the gas tank and fuel pump or between the pump and the carb. If not there should have a screw in filter where the line comes into the carb.

Sep 20, 2010 | 1984 Ford F 150

1 Answer

84 ford f150 only goes in reverse


means either ur tranny is toast or needs tranny fluid.

Jun 02, 2010 | 1984 Ford F 150

2 Answers

Why does my 1984 ford f150 302 v8 cut out while moving


84 ford f 150 cut off while driving, but i can pot the clutch and i runs, but when i turn the key i does nothing

Nov 07, 2009 | 1984 Ford F 150

1 Answer

84 f150 started location


Its on the right rear bottom corner of the engine. No they can not freeze.

Nov 13, 2008 | 1984 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...