Question about 2008 Chevrolet Impala

1 Answer

Help putting on 2008 exterior mirror

I have a 2008 chevy impala ls and I do not know how to chang them out. please help me

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 334 Answers

You have to take the door panel off on the inside. On your you probably have electric windows so unplug them. and anything else that keeps you from taking the panel off. Then remove the paper seal .Oh yeah before you start roll the door glass down ok now you will see two access holes on the inside part of the door. I believe it takes a 10 mm socket, 1/4 in drive ratchet and extension . take it off replace and put it all back just as you took it apart.
God Bless Greg

Posted on Dec 03, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What size allen needed to remove break pads


Allen wrenches usually come in a set, try 3/8.

Apr 30, 2016 | 2008 Chevrolet Chevrolet Impala LS

2 Answers

What does low oil pressure on 2008 Chevy Impala 3.5 V6 LS


Do you mean what causes low oil pressure? This is a very reliable engine for the most part. If the oil light is on or gauge is reading low, have the oil pressure sensor inspected for failure. These sensors do go bad.

Jan 27, 2016 | Cars & Trucks

1 Answer

2002 chevy impala ls are the any recalls several problems only 100,000 miles on it


Put in your search engine , Recalls on a 2002 Chevy Impala LS it will bring up quite a few good sites to pick from. They were more recalls then I could put down here.

Oct 31, 2013 | 2002 Chevrolet Impala

1 Answer

The wiper fluid pump is not working on my 2008 Chevy Impala LS. Does it have a fuse?


You can check that in the owners manual, all fuse diagrams are there. If you don't have the owners manual you can download one free HERE

Sep 17, 2012 | 2008 Chevrolet Impala

1 Answer

Help to Replace Driver AND Passenger Exterior Mirrors 02 Impala


I used google to do a search for this and typed in "instructions replace side mirror". There is a guide on e-bay that pops right up and it gives you pretty detailed instructions. They are not vehicle specific but should give you all the information that you need. The web page says How to replace a broken side mirror on your car-associated content. I hope this helps, it looked like it had plenty of great information.

Jan 12, 2009 | 2002 Chevrolet Impala

1 Answer

Where is the oil filter 07 Impala


The oil filter on the 2008 Chevy Impala 3.5 V6 is located to the front center of the engine and recessed underneath and slightly to the right (passenger) side just behind the front frame crossmember.

PLEASE RATE THIS INFO

Dec 01, 2008 | 2007 Chevrolet Impala LS Sedan New Cars

1 Answer

I have a replacement mirror for the passenger exterior for a 2008 impala. can you give me step by step details on putting it on


I'm going to assume the 2008 is similar to my 2006. The mirror is attached to the door with (3) 10mm nuts behind the triangle shaped interior trim piece that pops off easily with a screwdriver. If you have electric mirrors, the door panel has to come off to unplug the wiring harness from the mirror. There are three T30 torx screws and a 7mm bolt that need to be removed first...two torx bolts are under the rubber pad in the door grab well and the other is under the plastic trim piece behind the interior door handle. The 7 mm screw is behind the door reflector. Once the torx bolts and 7mm bolt is removed, pry the door panel at the bottom (there is a slot for this) and release the plastic connectors around the panel's edge...some effort is required to release them.

Nov 23, 2008 | 2006 Chevrolet Impala

2 Answers

Passenger side mirror


If you need to replace the entire mirror - it's a little involved. First you need to take the upper extension panel off from behind the mirror (black triangle) - just pull it of starting at the top. It will snap back on later. Next - remove the different screws holding the door panel in place (not the ones behind the mirror yet!) One is under the handle (pull it out and pull out the filler panel - small plastic thing that has a hole to pry it out). Then take off the rear red light - also pops off - and remove that screw. Finally - pick up the rubber filler where your fingers pull the door shut and remove these torx bolts.

Now is the tricky part. Snapp off the entire interior panel. It will pop off - but very difficult. It will sound like it is breaking! Start at the outer bottom corner - and use a door panel remover tool - check Amazon or E-bay - to keep from breaking things. Pull it out from all around the bottom and sides and then lift it up over the door lock. It good to have a friend help here. The panel will still be held on by a cable - that is your door release - leave it alone and let the panel hang by it (or better, put a box under it to rest on).

Now...remove the three bolts holding the mirror on - have a friend help hold the mirror while you do this or it will scratch your new car! Since the inner panel is off - you can also disonnect the mirror plus and remove it. It sounds silly - but the only reason to remove the door panel is to unplug it!

Get you new mirror and reverse the steps.

If you are just replacing the glass (non-heated) - get a replacement from the dealer. Adjust the mirror all the way to the inside and reach behind and pop it off. CAREFUL - put tape over the entire glass as it will likely break even more! Remove your connectors if heated - and replace (and reconnect) with your new glass. It just pops back on!

Replacing glass is easy - just be careful of cheap imitations on e-abay). And never use cheap flat glass on the passenger side! The DOT has special requirements for mirror glass - buy it from gmpartsdirect.com or your local dealer.

kb

Oct 30, 2008 | 2008 Chevrolet Impala

2 Answers

2004 Chevy Impala Brake Problem


I did a complet brake job on my 2004 Chevrolet Impala about two weeks ago, and i still have warning light on. Thw system is working great. So how do I turn off the warning Lights, Traction off light, Brake light, and in warning center Low brake fuild?

Jul 08, 2008 | 2004 Chevrolet Impala

Not finding what you are looking for?
2008 Chevrolet Impala Logo

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

71288 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7009 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...