Question about 1990 Ford F150

1 Answer

Car will only start with map sensor unplugged

My mercury villager 1997 van won't start, unless i unplug the map sensor. when i try to plug it back in, it stalls.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 85 Answers

Have you replaced the map yet good luck

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the pcv on 1997 Mercury VILLAGER AND HOW DO I REPLACE IT?


1997 Mercury Truck Villager Van 3.0L SFI SOHC 6cyl
The PCV Valve is located under hood, center, upper engine area, mounted in rear of intake manifold.

If I find one graphics, I send you (remember rated and comment this).

Mar 23, 2010 | 1997 Mercury Villager

1 Answer

My 1998 Mercury villager van 6 cylinder 3.0eng keeps cutting off


it could be faulty fuel pump or coil pack transistor.

Dec 10, 2009 | 1998 Mercury Villager

2 Answers

1997 Mercury Villager car will turn over, but will not start. Used ether but nothing. Can't get spark. Installed another coil-- nothing. Installed electonic ignition module--nothing. Any ideas???


if you can get a scan tool, hook it up and check to see if you are getting engine RPM while cranking. if not than you may have faulty cranck sensor.

Nov 26, 2009 | Mercury Villager Cars & Trucks

3 Answers

How many oxygen censor in 1997 mercury villager van I have to change new one some one told me more than two censor problem is check engine light is on


I have a 1997 Mercury Villager with many miles. We get poor gas mileage. The check engine light is on. I want to replace the 02 sensor but cannot locate it on the engine. Is there a link with photo of physical location of the sensor and what are the steps to replace it?

Oct 19, 2009 | 1997 Mercury Villager

1 Answer

Engine trouble after warmed


Try this first.Take off the distributor cap and rotor button,Then remove the 2 screws holding the cover on under this. You will then see a sensor and a wheel with a bunch of slots in the end of the wheel this is the ignition photo cell.You will probably see a black film built up on it.Clean this with electrical cleaner then blow dry or let it totally air dry before putting it back together. This usually solves the concern you have.

Mar 20, 2009 | 1997 Mercury Villager

Not finding what you are looking for?
1990 Ford F150 Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...