An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: speaker level converter
Is this meant for hooking up an amp and still using your factory stereo head unit? If so, you only need to use the four speaker wires. Go into the trunk and tap them into the rear speaker wiring per the labels on the converter's wires (right and left, plus and minus). Then plug your RCA cables into it and connect them to the amp.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
SECTION 309-00: Exhaust System
2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION
Dual Converter Y-Pipe -3.0L (2V)
3 Bar Engine Support 303-290A
Engine Lifting Brackets (3.0L 2V) 303-050 (T70P-6000) or equivalent
Disconnect the negative battery cable. For additional information, refer to Section 414-01 .
Remove the bolts and engine roll restrictor.
Remove the bolt, ground strap, and nut.
Raise and support the vehicle. For additional information, refer to Section 100-02 .
Remove the splash shield and the air deflector.
Disconnect the catalyst monitor sensor (CMS) electrical connectors.
Remove the nut and position the heat shield out of the way.
Remove the nut.
Remove the nut.
NOTE: Support the exhaust with mechanic's wire. Remove the nuts and disconnect the three-way catalytic converter from the dual converter Y-pipe.
Lower the vehicle.
Remove the nuts.
Remove the bolt.
Using the special tools, raise the front of the engine.
Raise the vehicle.
Remove the bolt.
CAUTION: The sharp edges on the converter can cut the CV joint boot. Make sure to protect the half-shaft boot with a suitable covering before removing the converter assembly. Remove the dual Y-pipe converter assembly.
Remove the gaskets and, if necessary, the catalyst monitor sensors (CMS).
Here are the factory wire colors, please rate this solution to your problem, a note any stereo store that sells auto decks has adapter wiring harnesses to do a direct plug in of your DIN standard radio you are trying to install, no cutting of the factory harness, they are cheap
2000 Ford Taurus Car Radio Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Green/Black Car Radio Accessory Switched 12v+ Wire: Black/Pink Car Radio Ground Wire: Black/Green Car Radio Illumination Wire: N/A Car Stereo Dimmer Wire: N/A Car Stereo Antenna Trigger: N/A Car Stereo Amp Trigger Wire: N/A Car Stereo Amplifier Location: N/A Car Audio Front Speakers Size: N/A Car Audio Front Speakers Location: N/A Left Front Speaker Positive Wire (+): Orange/Green Left Front Speaker Negative Wire (-): Blue/White Right Front Speaker Positive Wire (+): Tan/Green Right Front Speaker Negative Wire (-): Green/Orange Car Audio Rear Speakers Size: N/A Car Audio Rear Speakers Location: N/A Left Rear Speaker Positive Wire (+): Gray/Blue Left Rear Speaker Negative Wire (-): Brown/Yellow Right Rear Speaker Positive Wire (+): Black/Violet Right Rear Speaker Negative Wire (-): Orange/Violet