Question about 2000 Plymouth Grand Voyager

1 Answer

Where is the water pump located on a 2000 plymouth voyager 2.3l?

4 cyl

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 899 Answers

The water pump will be in front of the engine and the belt will go around its pully , there will be the radiator hoses connected to it and also the heater radistor hoses

Posted on Nov 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 plymouth voyager will not start and i have changed the crank shaft sensor and the plugs even the cole pack still will not start about a year ago i even did the timing belt what can i do


not sure what size motor you have? is it getting fuel? have you checked the fuses? if so there is a cam sensor that can cause a no start on the 4 cyl the 3.0 and the 3.3. hope this helps

Jan 25, 2011 | 2000 Plymouth Voyager

1 Answer

WATERPUMP location


zjlimited_324.jpg

Fig. 1: Water pump location on 2.4L engines




zjlimited_325.jpg



Fig. 3: Water pump mounting detail-3.0L engine




zjlimited_326.jpg



Fig. 4: Water pump location-3.3 and 3.8L engines

When installing the pump, make sure that the O-ring is properly seated in the groove in the pump body.

Hope helps (remember to rate and comment this answer).

Dec 28, 2010 | 1996 Plymouth Grand Voyager

1 Answer

How do I remove oil pump on 2000 Plymouth voyger


The oil pump removal procedure for Plymouth Voyager 2000.
A oil pump is usually located in the oil pan. If you want to change the oil pump and replace it with a new one, roll up your sleeves and get ready for some dirty work.
The procedure to remove oil pump is as follows:--
  • Drive your vehicle up onto ramps or lifts so you have room to work as you pull out the oil pump. You could also use a jack, but make sure you brace the front wheels so they don't roll. In addition, set the emergency break firmly into position so the car doesn't roll.
  • Remove the engine front cover then drain the engine oil and take out the oil pan. It is under the engine and looks like the bottom of the motor.
  • Unscrew the oil pump mounting bolts with a wrench and proceed to remove the oil pump itself by pulling it down and out of the engine. Avoid getting any contaminants into the oil pump assembly while removing.
The Water pump removal procedure for Plymouth Voyager 2000.
The water pump is the heart of the Plymouth Voyager's cooling system, circulating the coolant. When the water pump is faulty, it can cause serious damage to the engine of your Plymouth Voyager.
  • Disconnect the negative battery cable.Place a drain pan underneath the radiator. When the engine is cool, drain the cooling system from the radiator into the pan.
  • Remove the right inner splash shield and the accessory drive belts. Support the engine underneath and remove the right motor mount with the bracket.
  • Take off the front cover and remove the timing belt along with the timing belt idler pulley. Also remove the camshaft sprockets, the rear cover to the timing belt and the alternator with its bracket.
  • Loosen and remove the bolts to the water pump and remove it from the engine.Install the new water pump after inserting a new o-ring gasket. Tighten the bolts to 105-inch lbs. Make sure that the pump can move freely by rotating it by hand.
  • Replace all components in reverse order. Tighten the camshaft sprocket bolts to 75 foot pounds and the timing belt idler pulley to 45 foot pounds.
  • Refill the cooling system with coolant and reconnect the negative battery cable. Start the engine and check for leaks when it reaches normal operating temperatures.

Loud noises coming from the cooling system could be a sign that your water pump needs replacing. A leak in the coolant may also be an indicator. You can expect that a water pump will need to be changed every 70 to 100 thousand miles or so in a Plymouth Voyager vehicle.
Thanks. keep updated for any more query.you can rate this solution and show your appreciation.

Jun 13, 2010 | 2000 Plymouth Voyager

1 Answer

I have removed the alternator& water pump form


you can do some searching on web and library but chances are slim u find a diagram for that so u have 2 options

1. play with it and eventually figure it out (very time consuming and hair pulling involed)

2 . go to a junk yard and see how it is on a van or car

Jun 03, 2010 | 1987 Plymouth Voyager

2 Answers

How do you set the timing on a Plymouth Voyager ? I have to repace a broken timing belt. I was also told to replace the water pump is that true.


It is recommended because if you have to change the water pump belt change since you have to remove it and you save work in the future as we recommend changing the camshaft seals and crankshaft as it saves time and money

Feb 03, 2010 | 1992 Plymouth Voyager

2 Answers

How to replace water pump for 2000 plymouth voyager


You just have to take the pasenger tire and the dirt guard to get too it, Remener to lose the elt 1st.

Jan 28, 2010 | 2000 Plymouth Grand Voyager

2 Answers

Where's the crankshaft position sensor located in 98 plymouth voy


Guessing it's a 6 cyl, 3.0L, but should be located on transaxle housing above vehicle speed sensor.c937fe4.jpg

Aug 31, 2009 | 1998 Plymouth Voyager

2 Answers

Where is the water pump located on a 99 plymouth voyager, 3.0Lit?


It is driven by the timing belt. You'll need to support the front of the engine, remove the mount and timing covers. The pump sits in the center between the heads and has a tube running into the back of it that sometimes is difficult to get out. If you are uncomfortable with setting up the timing belt you may want to have a professional do the job.

Jul 18, 2009 | 2000 Plymouth Voyager

2 Answers

Water leaking next to pulley not at hoses


The water leak coming from behind the timing belt cover is the water pump leaking. Rebuilt pump with liftime warranty at Advance Auto cost me 35 bucks. Pain to change without a lift though.

May 30, 2009 | 2000 Plymouth Voyager

Not finding what you are looking for?
2000 Plymouth Grand Voyager Logo

Related Topics:

172 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...