Question about 2007 Toyota FJ Cruiser

Open Question

Installation of factory toyota trailer wire harness

I bought a toyota fj cruiser harness wiring kit and it did not come with the instructions

Posted by on

  • josh davis May 11, 2010

    if you bought it from the dealer just ask them to get it for you they wont charge you if you bought it there

  • Toyota Ed May 11, 2010

    I have the 12 page .PDF... I can e-mail it to you; genuine factory instructions.

    FixYa is not set up yet for me to post .pdfs.

    Post your e-mail, it will be sent to you today.



    Glad to help.



    Toyota Ed

×

1 Suggested Answer

  • 1 Answer

SOURCE: Problem with my 2007 Toyota FJ cruiser trailer light connection

There are two fuses for the tail light circuits. That bare wire caused a short, which popped the fuse for the trailer lights circuit. Look at the fusebox under the hood, and you will be able to fix it.

Posted on Nov 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wire up for trailer hitch


get kit on rock auto simple plug in or order from trailer store that sells reese hitches

Feb 10, 2015 | 2008 Toyota FJ Cruiser

1 Answer

How do you hook up trailer lights so i can pull a trailer


If you bought the Honda hitch kit, a wiring harness and instructions are included. If you bought a different kit, buy the wiring harness from Honda. The harness connects to a plug located in one of the accesses panels in the back. You will have to take off the. Bumper facia to route the harness to the hitch. Be sure to use the rubber grommets to prevent the sheet metal of the rear quarter panel from wearing through the wire insulation and causing a blown fuse.

Aug 07, 2011 | 1997 Honda Passport

1 Answer

I wired up a 4 pole trailer wiring harness up and went by instructions. i wired both turn signals up white to ground and tail light to tail light but i have no brake light wire on the harness so my brake...


You need to purchase the trailer wire kit that has a solid state module that will allow the lights operate correctly. It plugs right in the factory socket, no cutting of wires are needed, and it costs around 40 dollars. It is the only way to go for your vehicle.

Sep 18, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Fuse for my Tail Lights, licence plate lights, and instrument panel lights keeps blowing on my 2002 Toyota Land Cruiser


  1. Tail,Plate and panel lamps all work off the same fuse
  2. do you have a trailer lamp kit on the cruiser?
  3. check condition of trailer lamp wiring under rear
  4. if not remove and inspect all tail bulbs and their connections
  5. has anyone installed an aftermarket sterio setup possibly running a screw through a wiring harness?
  6. PLEASE RATE THIS POST

Jul 29, 2010 | 2003 Toyota Land Cruiser

1 Answer

How to wire trailer lights to a toyota tacoma


The easiest way is to get the kit that plugs into the taillight harness to adapt your plug. If one isn't easily available then you can use scotch locks to splice into your trucks harness. Use a test light to make sure you locate the right wires in your trucks harness and go by the wire diagram on the instructions from the plug to hook it up.
I hope this helps!

Jul 22, 2010 | 2002 Toyota Tacoma

1 Answer

Towing light problem on wiring them up.


It looks like there could be a service bulletin to fix this.

TO: ALL TOYOTA DEALER PRINCIPALS,
SERVICE MANAGERS, PARTS MANAGERS
SUBJECT: SPECIAL SERVICE CAMPAIGN 10H
(2000 TUNDRA AND 1999 - 2000 TACOMA TRAILER TOWING WIRE HARNESS
CONVERTER REPLACEMENT)
Toyota will initiate a Special Service Campaign to replace the Toyota Trailer Towing Wire Harness
Converter (converter) on certain 2000 model year Tundra and 1999 - 2000 model year Tacoma
vehicles equipped with a genuine Toyota Trailer Towing Hitch or Bumper Hitch. This accessory
is included in the Towing Hitch Kit installed at ports (PIO) and by dealers (***); it is also sold by
dealers as an over-the-counter or service part.
An electrical short or open circuit can cause a fault in the genuine Toyota Trailer Towing Wire Harness
Converter (converter). This can cause a failure of the converter, and if a trailer is being towed at the time,
non-operation of the trailer lights. In limited cases, the converter housing could become heat-deformed.
In the case of the Tundra, the circuitry utilized in the converter was inadequate to properly manage
vehicle and/or trailer-side voltage spikes. If the converter is exposed to a voltage spike it may cause an
electrical short or open circuit within the converter.
As for the Tacoma, due to deficient waterproofing and improper installation location of the converter,
which is mounted in the lower portion of the taillight cavity of the vehicle, an electrical short circuit will
occur if water enters the converter housing.
The following vital information is provided to inform you and your staff of the campaign notification
schedule and your degree of involvement.
1. Owner Notification Letter Mailing Date
The owner notification will be conducted in two phases:
• The first phase will be launched in late August and involve vehicles equipped with port
installed (PIO) genuine Toyota Towing Hitch Kits.
• The remaining vehicle owners, whose vehicles may be equipped with a dealer installed (***)
genuine Toyota Trailer Towing Wire Harness Converter, will be notified in the second phase
to be launched in early September.
We have attached copies of the owner notification letters for your reference.
If you are contacted by an owner of an involved vehicle, who has not yet received a notification,
please verify eligibility through TDN or TIS, inspect the vehicle to assure it is equipped with the
affected part, and perform repairs as outlined in the attached Technical Instructions.

Jul 12, 2009 | 1999 Toyota Tacoma PreRunner

1 Answer

Trailer light fuses can not be located


Open your hood, on the driver side of the engine compartment is your fuse panel, take off the larger black cover, and look under the lid, you should have a diagram which has trailer/towing on the right side and left side. Each side takes one 15amp Blue Mini Fuse.

Mar 20, 2009 | 2007 Toyota FJ Cruiser

Not finding what you are looking for?
2007 Toyota FJ Cruiser Logo

Related Topics:

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...