Question about 1989 Lincoln Town Car

1 Answer

All my interior lights remain on when car switched off

When the key is in the off position all interior lights remain burning,i have too remove the fuse for them too go off.if its a bad fusible link where is it ? somebody help!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 193 Answers

It is not a fuse. the problem is in one of the door switches that is not grounding out when the door is closed. Each switch will have to be checked until the faulty one is found.

Posted on Nov 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My interior light won't come on in my 1999 Buick Lesabre. I have checked the bulb & the fuse. Can anyone help me with this problem? Any ideas are sincerely appreciated.


Courtesy Lights
The courtesy lights come on under the following conditions:
?€¢
Any door is opened.


?€¢
The interior lamp switch is in the ON position.


?€¢
The keyless entry transmitter unlocks the doors (illuminated entry).

When the key is removed from the ignition switch with all of the doors closed, the courtesy lights light for approximately 25 seconds before fading out.
Battery positive voltage (B+) is applied at all times through the IP fuse block CTSY LP/PWR MIR fuse 6A via CKT 640 (ORN) through the body control module (MALL) to the courtesy lights via CKT 1732 (ORN). The MALL provides a ground through CKT 156 (WHT) for the courtesy lights under the following conditions:
?€¢
The MALL receives an input from a door being opened.


?€¢
The MALL receives an input from the interior lamp being turned ON.


?€¢
The MALL receives an input from the doors being unlocked using the keyless entry transmitter.

The courtesy lamps then light.
When the courtesy lights are activated by opening and closing a door, the courtesy lights will remain on for approximately 25 seconds before fading out after all of the doors are closed. If the ignition switch is turned to START or RUN within the 25 seconds, the lights immediately begin to fade out. If a door is left open, the MALL removes battery positive voltage (B+) to the courtesy lights after 10 minutes. When the courtesy lights are activated by the interior lamp switch, the lights remain on as long as the interior lamp switch is in the ON position. When the courtesy lights are activated by unlocking the doors using the keyless entry transmitter, the lights remain on for approximately 40 seconds. If the doors are locked using the keyless entry transmitter within the 40 seconds, the lights immediately begin to fade out.
Body Control Module (MALL) Diagnostic Mode
For a detailed explanation of the MALL module diagnostic mode, refer to Body Control Module Cell 51.
What interior light ? Dome , courtesy lights etc....They don't work with switch, keyless entry , door opening ?
What

Dec 03, 2015 | Buick Cars & Trucks

1 Answer

My interior lights won't go out


1 ) check the position of ligth switch it is posible that is on ON position MOVE IT TO DOOR POSITION
2) in some case the dood push botton are lose check all of them

Feb 17, 2015 | 2003 Jeep Liberty

3 Answers

Where to begin troubleshooting why Interior lights remain on (remove fuse at 14 area; 2nd from top left) Door window on back passenger stuck in "up" position: could this be a problem?


This model Park Avenue has boo coo interior lights...they are triggered at both front doors, and limited with the back doors...Each door has a contact accentuator switch ...locate each one, should be on front side of door they make contact with the interior door trim...spray each one with PB Blaster and wipe way excess...this will assure they are not stuck...A radio on/off sometimes means a bad alternator or loose serpentine belt, be sure to have your system checked for free at your nearby auto parts store so you don't get stranded...Hope this helps.

Jan 19, 2015 | 1993 Buick Park Avenue

2 Answers

Chevy trailblazer problems


its either a bad door switch,or could be the dome override switch by headlight switch,or your interior light switch is all the way up

May 01, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

Manually turn of interior lights


check the door switches are not shorting out and leaving the light on. Check the position of the interior light switch and that it is in the doors position

Jan 05, 2014 | 2000 Pontiac Bonneville

1 Answer

Just bought a x reg ford puma but the key fob does not work, bought a new battery and fitted it, needs re-programming but don't know how to do it.


Telephone: Fax: VAT Registration No.:
Infrared remote control
NOTE: Infrared emitter can be seen at front edge of key.
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system.
Programming
When
Key batteries completely discharged. Key batteries not replaced within 15 seconds. Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Turn ignition switch to position I. Wait approximately 10 seconds. Ensure clock LED illuminates.
NOTE: LED illuminates for approximately 5 seconds.
Switch ignition OFF and remove key, while LED illuminated. Programming mode activated for approximately 20 seconds (LED illuminated). Proceed as follows: Point key at receiver (located near interior lamp). Press and hold unlock button Fig. 1 [1]. After approximately 1 second key LED will flash once [3]. Press lock button 3 times Fig. 1 [2]. Release unlock button Fig. 1 [1]. Continue to point key at receiver until LEDs in clock and key have flashed 5 times. Ensure LED remains illuminated. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode and extinguish clock LED: Switch ignition ON and OFF. Wait approximately 20 seconds.
NOTE: A maximum of 4 keys can be programmed. Fig. 1
Radio frequency remote control
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds.


Pressing tailgate release button twice within 3 seconds unlocks the tailgate - if fitted. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system. Interior lamp illuminates when disarming system.
Programming
When
Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Fasten seat belts and close all doors. From position I, turn ignition switch as follows: To position II. To position I. To position II. To position I. To position II. To position I. Programming mode activated for approximately 20 seconds. LED or fog lamps ON warning lamp illuminates (some models) or the system will emit an acoustic signal to indicate start of programming mode. Proceed as follows: Type 1: Press and hold unlock button Fig. 1 [1]. Type 2: Press unlock button Fig. 2 [2]. Ensure clock LED or fog lamps ON warning lamp flashes (some models) or wait for acoustic signal (indicates correct programming). Wait 2 seconds. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode: Switch ignition ON. Wait 20 seconds.
NOTE: A maximum of 4 keys can be programmed.

Aug 25, 2010 | Ford Focus Cars & Trucks

1 Answer

Interior lights cargo lights remain on when doors closed switches will not turn interior dome light off or cargo lights when engine turned off and key removed from ignition and doodrs closed.


you need to check the door switches make sure that they work you can disconnect them and check to see wich one is bad you do this by opening only one door at a time and disconnecting it the one that turns the lights off is the bad one. and you can also check the dimmer switch sometime the wheel gets turned all the way over and the lights stay on also

Feb 12, 2010 | 1996 Ford F250 Crew Cab

1 Answer

Grand vitara 1999 when door open inside lights do not turn on


There should be a switch on the dash that controls the interior lights on the vehicle. It might be part of the dimmer switch. Usually the switch will turn on the interior lights in one position, off but on when door is open in another, then off all the time in the third position. Check this switch and verify that it is not in the off position. If the switch is in the correct position then the door swicth located on the inside of the door might be sticking. Check the switch stem/button action and makes sure it fully pushes in and out. Also verify that the interior bulb is good(not burned out) and that the fuse for the interor light is not burned out.

Dec 30, 2009 | 1999 Suzuki Grand Vitara

1 Answer

Indicator lights stay on perminently


its the signal switch on the colunm NOT the hazard switch

Apr 13, 2009 | 2004 Audi A6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...