Question about 2000 Ford F150 Flareside SuperCab

1 Answer

F150 plug wires

You gave me a diagram for the wires, but not for the coil. another use sent me a link for a coil diagram, but it is for a 3.8 not a 4.2. i used this diagram anyway, but now have an engine miss. any suggestions?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi again,

Did read your post in your original problem but currently tied up with an old lady with her own problem(s). When I saw that it was emissionwiz I knew you are in good hands.
Should this help, pls see http://autorepair.about.com/library/graphics/92714671.gif
You can also reference http://www.ford-trucks.com/forums/210799-4-2l-piston-firing-order.html
http://www.f150online.com/forums/v-6-engine/69727-firing-order-4-2-a.html

Posted on Nov 22, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I was changing the spark plug wires on my 1992 ford ranger. one at a time.one wire came.i got mixed up i need to see a picture of the wiring from distributor to engine block


what size engine! ill type you a little diagram....





4
3
2
1
Front of vehicle


coils
3 1
2 4

4 2
1 3 this is for the 2.3, ill type you a little diagram....





4
3
2
1
Front of vehicle


coils
3 1
2 4

4 2
1 3 Just match the numbers you have on the coils to each side of the block? 2.3 engine

Aug 26, 2011 | Ford Ranger Cars & Trucks

2 Answers

Need a cylinder wiring diagram for 92 buick park avenue


Buick Park Avenue has Type I coil packs, three twin tower ignition coils are combined into a single coil pack unit, and Type II coil packs, the coils can be replaced separately and the ignition wires are all on the same side of the coil pack.

zjlimited_349.gif

What is yours?

May 05, 2011 | Buick Park Avenue Cars & Trucks

1 Answer

Who to hook up spark plug wire to the plugs and disbuter


the 1990 had a coil pack if that's what you mean. I gave you a diagram for it. If you do have a distributer cap, that would be a 1989 engine and the firing order for that is 1-3-4-2. I hope this helps and good luck.


clifford224_185.jpg

Apr 20, 2011 | 1990 Mitsubishi Galant

2 Answers

What is the plug wire diagram for a 2000 chevy lumina?


2000 Chevrolet Lumina 3.1 liter V-6 VIN "J"

zjlimited_276.gif


Hope helps.

Mar 29, 2011 | Chevrolet Lumina Cars & Trucks

3 Answers

1999 ford escort I changed the plugs, but broke a plug cap. Bought a generic replacement spark plug wire that had to be modified to fit into the head. I cannot get the firing order correct. The car...


Remove the plugs from the head. Insert into the coil wires. Make sure they are properly earthed on the engine. Crank the motor and check for spark at each of the plugs.
Refer to the diagram. Cylinders are connected as shown on the diagram in blue. 1 goes to cylinder 1(sparkplug furthest from coil pack), 2 to 2, 3 to 3 and 4 to 4(closets to coil pack).
To test the coil pack use a digital volt meter. Measure resistance between coil towers for coil 1(marked 1 in red on diagram) Value should be between 12000 and 14500 ohm. Do the same for coil towers 2.
Measure resistance between I and C1. If the measurement is more than 5 ohm the coil is defective. Do the same for I to C2.
Measuring voltage at I(Ignition start/run) to ground should be 10V.
I is connected to the 15A engine fuse. The radio interference capacitor is connected between this line and earth at the coil. Disconnect it to see if it cures the problem.
C1 and C2 connect to the powertrain control module.
Bear in mind that aftermarket coil wires may cause problems with misfiring, so see if you cant find an OEM coil wire to replace the broken one before replacing anything else.

suzman_16.jpg

Nov 15, 2010 | 1989 Ford Escort

1 Answer

Firing order diagram 1999 lumina


Hello Friend:

Firing Order is 1--2--3--4--5--6

Left Bank 1----------3---------5

Coils----<-5-2-><3-6->-<-4-1> Back of Engine

Right Bank-2----------4---------6

This diagram shows where your Spark Plugs/Cylinders Are.

And the 3-Coils each coil supplies Voltage to 2- Plug Wires.

Which i Show in the Center of above diagram ,#1 Plug wire goes to #1 on the Coil which in the Diagram is the Rear Coil and the farest back. So- on ! This should get you going. Hope this Diagram Loads Down Proper.

Thank You and Please let me know if the Diagram helped you.Or if it did'nt down load right please send a comment.to me.

From: d_hubbs

Aug 29, 2010 | 1999 Chevrolet Lumina

2 Answers

2002 ford f150 4.2l wiring diagram


The COIL PACK TOWERS are numbered : coil----3---4 pack---2---6 plug----1---5 ----------------------------------------------------------------- The engine cylinders / spark plugs are numbered : passenger side , front to rear , 1 , 2 , 3 -----drivers side , front to rear , 4 , 5 , 6 ------------------------------------------------------------------- The spark plug firing order is ( 1 -4 - 2 - 5 - 3 - 6 )

Apr 07, 2010 | 2004 Ford F150

1 Answer

Mercedes 2001 trunk lock fastener wiring diagram


Go back to the dealer and make sure they gave you the right part. Dealerships will also give you a wiring diagram, if you ask nicely.

Sep 04, 2009 | 2001 Mercedes-Benz C-Class

2 Answers

NEED SPARK PLUG WIRING DIAGRAM FOR A BUICK REGAL 2001 WITH 3.8 ENGINE


Firing order is 1-6-5-4-3-2
From the passenger to the drivers side radiator side 1-3-5 From the passenger to the drivers side firewall side 2-4-6
The coil radiator to the firewall #1 coil 1-4 #2 coil 5-2 #3 coil 3-6
Hope this helps, keep me posted, be glad to help answer more questions if was hard to understand. Harder to explain then to show. Good luck Friend

Jul 01, 2009 | 2001 Buick Regal

Not finding what you are looking for?
2000 Ford F150 Flareside SuperCab Logo

433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...