Unhook the blower and hook up the wiring to a 9-volt battery and if it turns then your'e free and clear my friend... i HAD the same problem and i disconnected mine and just hooked it back up and she worked just fine...
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Don't know how the ABS light would be related to the blower motor, you said you checked everything - did you check the blower motor circuit for power and ground with a meter or a test light ? Is the resistor getting power from the relay ?
check the fuse first with a test light, then, check the voltage to the 2 wires for the blower motor also with ignition on without running the engine. let me know how that turns out for the rest of the instructions
If the blower works check for coolant in the cooling system. Test operation of thermostat. Check heater control valve for proper operation if equipped. Pressure test cooling system to ensure system holds pressure (this will help you identify a leak, if any. If car does not over heat and cooling system is in good working order, then the heater core is clogged.
If the blower does not work Check fuse, relay, wiring for short to ground, apply direct battery voltage to blower motor. If blower motor turns on and fuse/relay and wiring are ok replace the switch.
REMOVE HEATER BLOWER MOTOR HOT WIRE BLOWER MOTOR IT.IF IT WORKS.YOUR AC AND HEATER CONTROL SWITCH IS FAULTY.CHECK HVAC FUSES AND CHECK BLOWER MOTOR RELAY.IF BLOWER MOTOR DONT WORK WHEN HOT WIRE REPLACE IT.IF ALL CHECK OUT GOOD.HAVE DEALERSHIP DO A DIAGNOSTIC TEST ON YOUR CLIMATE CONTROL SYSTEM.
The front blower motor is controlled by the blower resistor module.This is usually the problem with the front blower not working.I looked up the schecmatics and I don`t see separate fuses for the front and rear.But the fuse for the front blower is in the under hood fuse block.If this is good then The problem is probably the resistor module.It is next to the blower motor.The connector from the resistor connects to the blower motor.If you want to confirm this you can check for power and ground at the blower motor connector when you activating the blower switch on.This can be done with a test light.Make sure you have power going into the resistor module also.If you have power going in and no power at the blower motor then replace the resistor.Hope this helps.Good luck.
three things left to check, using test light see if you have power at motor with key and switch on,if you do replace motor,if not locate blower motor resistor it will be close to motor,check for power going in,last is the heater control assembly