Window fault the individual switches for the windows wont work, but the switch to put all four windows down at the same time is working fine. i have tried all of the fuses. any ideas? thanks. Martyn.

hummm strange
does the master switch have a other door lock button

so central locking and windows dont work as they should

driver side window motor faulty

individual door lock actuator motors not getting power


it is possible the central locking module wont work unless reset to the other cars electronics with the correct scanner

dsdsdfafds4343rfefaefw34f3asdfa34radwecdq34rf43efwgqf2fq3ew

If you can hear the motor turning on the window, then your window motor is fine. In all likelihood, your main window switch (driver's door) is bad and requires replacement. I would also check each individual window to make certain they open and close with each window's switch.

Another potential problem could be the window hardware that moves your window up and down. The only way to determine if there are problems with the hardware is to remove the door panel.

replace window regulator and motor

Change switch....but check relay in door.

You need to have the BCM scanned for faults.

if you told the problem to the dealer this should of been fixed take it back to him and tell him your not satisfide with the work that as been done if he his huming and aring tell him that you are going to see a trading standerds officer.. then go from there

You might have a faulty switch in the master!! Sounds like the lock and unloc has gone bad on you!!

there should be a switch right on the master window switch that may be "on" to prevent anyone but the driver to operate windows. is this car a convertable? is the switch between the seats in center console? do you have an owners manual? it may have it in there. i will try to find more info. for you if there is no "lock out".

Remove and clean the carbon tracks off the switchpack. Complete illustrated tutorial here on my Cardomain webpage: http://www.cardomain.com/ride/2666481/7