SOURCE: 1997 chrysler concord
My girlfriend's 95 concorde was having a problem that sounds like that. Some times when she started the car, the heater control console would not turn on but the heater would turn on full blast. I fixed it by replacing the control console with one that i picked up from the junk yard. Hope this helps you
SOURCE: 2001 pt cruiser no heat
did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.
SOURCE: the heater on my 2002 chrysler concord only blow
low on rad fluid, add, test n might be leaking
SOURCE: 2005 Chrysler Pacific-no heat and no fan-display works
replace the complete heater control unit was my only fix! over $700 in Cnada for control.
SOURCE: help 2005 chrysler pacifica heater and defroster
Your blend door actuator may have packed up. My manual says you have dual controls--true? If yes, is it cold on both sides?
Remove the silencer from beneath the driver side end of the instrument panel and take a look at the actuators. #4 and #6 are for the blend doors. Can you see if the little axle is rotating when you change the temp setting? If you can't tell, take one off and see if you can rotate the door by hand and get warm air to come out. If not, perhaps you have air in the cooling system. Check your coolant level and refill if needed. Then let's have a discussion about where your coolant may be leaking. OK?
Fig. Wire harness connector (1), mode door actuator (2), screws (3), drive blend door actuator (dual-zone) (4), heater core (5), blend door actuator (6)
197 views
Usually answered in minutes!
×