Question about Mazda Protege

1 Answer

When the car is idle it has a slight vibration and if i drive it long enough i loose power to for a second and if i press the gas pedal to the floor it won't accelerate. I took it to pepboys and they said they couldn't find anything wrong with it except a corroded battery. After they cleaned that the check engine light went off and i didn't have the problem again until 2 days later when the check engine light came on and stayed flashing

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

What happened is that when they took of the corroded cable then reconnected it , the ECM (computer reprogramed itself. then it started back up because the problem was not resolved. try this suggestion.
The problem may be a buildup of carbon or fuel varnish deposits in the idle speed control valve (also called the idle air control valve or IAC valve). The cure for this condition is to clean the valve with some aerosol throttle cleaner or engine top cleaner. disconnect the air ductwork from the throttle body. Start the car and run at about 1500 rpms spray the cleaner directly into the throat of the throttle body. Turn off the engine and let sit for a few minutes. Then repeat the process a couple of times. if that does not work, you can remove the IAC and clean it by spraying into the two holes on the underside of the valve. If not, then you need to replace the valve.

Posted on Nov 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vibration


It absolutely can be, but anyway you should hear that noise when accelerating the engine from idle dont need to drive, just press gas pedal from idle and if there is a strange noise in exhaust then the honeycomb will be loose

Apr 15, 2014 | 2002 Ford Thunderbird

1 Answer

Pathfinder vibration


check the "u" joints for looseness and wear especially the front drive shaft . check sliding splines . The vibration is a harmonic vibration normally associated with worn "U" joints --bent or out of balanced ---worn /seizing slip joints or being excited by a failing drive thrust bearing in the diff. ( big bearing directly behind the pinion gear that takes all the load on drive) check the magnet on the diff drain plug for metal bits.

Jan 28, 2014 | Cars & Trucks

1 Answer

2009 mini cooper clubman with sport button-delay when press on gas.


The fuel pressure and fuel system needs to be inspected.
-------
I suggest you few helk links.Click the link below and follow its troubleshooting procedure:------------------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down? http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html
-------------
Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
---------------
Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
-------------Car only starts when gas pedal is pressed? http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
----------1999 Ford F-150 Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html
----------Delay starting on Toyota Prius? http://schematicsdiagram.blogspot.in/2012/02/delay-starting-on-toyota-prius.html

--------
These will help.
Thanks.

Nov 26, 2012 | Cars & Trucks

2 Answers

I have 1999Chevy suburban with 6.5 turbo diesel motor.it idles up and down and when driving the gas pedal is real touchy Wat is the problem and were do i locate the problem


Check the help links related to this problem.Click the link below to go through its troubleshooting procedure :-----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html---------
Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
-------Complete loss of brake pedal then all gets normal? http://repairhelpcenter.blogspot.com/2012/01/complete-loss-of-brake-pedal-then-all.html
------Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
--------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down?

http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html

---------

After replacing brake rotors and pads, brake pedal remains on floor? http://technoanswers.blogspot.in/2012/02/after-replacing-brake-rotors-and-pads.html

---------

accelerator pedal sensor? http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

-------

For rough idle issues and problem troubleshooting,go through the help links provided below :----- van idles rough?

http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html

---------
will not idle when cold?

http://technoanswers.blogspot.in/2012/02/ford-explorer-40-will-not-idle-when.html

----------
runs lean and idles rough?

http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html

-----------
Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------
Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

----------
Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

---------
Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

----------
Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

------------
Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

This will help.

Thanks.

Mar 01, 2012 | 1999 GMC Suburban

1 Answer

Car starts after taking foot off gas car shuts down 2001 mit 3.0 v-6 spider


For this problem, i suggest you to go through this help links.Click the link below to go through the troubleshooting procedure :----Car Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------Car only starts when gas pedal is pressed? http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
-----------Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
---------Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
------------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down? http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html
-----------This will help.Thanks.

Feb 15, 2012 | 2001 Mitsubishi Eclipse Spyder

1 Answer

2004 honda, lost power and sputters. Will crank with gas pedal to floor but not enough power to move car. take foot off pedal and it dies


sounds like it is starving for fuel. check fuel pump relay to make certain pump is running. if it is, change fuel filter this may help. the best way to check to see if pump is running is to have someone turn car to on, not start. and feel the vibration at fuel tank with your hand. a pump only runs for a few seconds. until it gets pressure to engine. then when engine is running its on until you shut car back off. you may have to turn key on a few times to feel a vibration. good-day!!

Jul 26, 2011 | 2004 Honda Accord

2 Answers

1997 s10 2 wheel drive truck. 4.3L v6 makes a loud noise as the car accelerates fast or under load. When running 55 I can release the gas pedal and the noise is not audible. I can put the truck in neutral...


Your noise sounds like it is power train related,If you have eliminated the engine,Since it doesn't make the noise while moving and in neutral.
It sounds like a universal joint in the drive shaft.Do you notice a vibration
along with the noise?

Nov 17, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

Nasty vibration on the floor under the gas pedal


check the drive shaft between the intermediate transmission and the front transmission for miss alignement and defectivness of the telescopics system of this shaft. we had about the same problem on our 1996 same model...

Feb 25, 2009 | 1995 Nissan Pathfinder

1 Answer

Front end vibration


It sounds as though your car has two seperate problems. The first problem with the vibration that goes away when you let off the gas pedal is caused by a bad INNER CV joint. It only vibrates when you are accelerating because that is when the joint is under stress. Your vehicle has two axles, each with an inner and an outer joint. My suggestion is to have a competent shop determine which is the bad side and replace the entire axle. The second vibration which occurs at any speed is most likely cause by either a bad tire, or a bent rim.

Jun 03, 2008 | 1998 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

350 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...