Question about 2001 Dodge Caravan

1 Answer

Electrical problem 2001 caravan 62000 mi. 1B4GP25311B117937

While driving on 11/19/08 the turn signels,intire insterment cluster, brake lights sudenly quit. They will com on intermently but the spedometer does not worh and tough the turnsignel and every thing quits.

Posted by on

  • Anonymous Dec 06, 2008

    I have the same problems with my 1994 Caravan, but with much better spelling.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 76 Answers

The wiring on a 94 is drasticlly different than that of a 01. The 01 likely has a cluster issue and requires replacement or simple computer updating. The 94 is likely a circuit board issue.
Both vehicles should be taken to the dealer for proper diagnostics.

Posted on Dec 06, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 mercedes e500 brake lining light in insterment cluster how do i reset it


If the brake wear light on you can't reset the light without replace brake pads and sensors inside the pads must replace both after replace it will off automatically

Nov 13, 2010 | 2003 Mercedes-Benz E-Class

1 Answer

Installing Dash light bulbs in a 1993 S-10 Blazer


To replace the blubs you have to take out the insterment cluster. This is done by romoving the light switch trim plate and disconnect the wirering harness. The remove the A/C heater control panel. Remove the plastic trim from around the insterment cluster. The unbolt and remove the insterment cluster and uplug the wires and the speedometer cable. This speedometer cables can be a pain in the **** but depress the spring clip and pull. The bulbs are accessed from the back of the cluster.
Bulbs in this cluster don't burn out very often and if none of the bulbs don't work it probley isn't the bulbs. In this cause make sure the dimmer switch is turned up if it is play with the switch see if the dash light flicker.
Oh also in the mauals they always tell you to disconnect battery when pulling electrial apart.

Oct 20, 2010 | 1989 Chevrolet S-10 Blazer

1 Answer

I would like to know where I can find the (on board computer). I lost my insterment cluster and turn signals. I tried removing the (iod) fuse but that didn't work.


u have all the fuses in the fuse panel under the hood,they are marked for everything. use a test light to find the blown fuses and replace them. tail light fuses are 15amp

Mar 29, 2010 | 2002 Dodge Grand Caravan

1 Answer

2001 Dodge Grand Caravan. Dash board stopped


sounds like an electrical nightmare! start by removing the cluster,now try signals are they working if yes then bad cluster, also i had a few caravans that just had bad connections i removed the plugs and reconnected them and it worked fine, also with the light coming on with your foot on the brake may be a bad or in correctly installed bulb, check all brakeand signal bulbs, try all of this , good luck,hope this is helpful.

Nov 26, 2009 | 2001 Dodge Grand Caravan

2 Answers

My gauges (temperature, gas, speed, rpm) stopped working at the same time the turn signals and brake lights stopped working. I am assuming I blew something as it happened when I hooked my trailer up....


have a caravan ´93 3.0 motor mi problem is a temperature, gas,speed and tableboard light don´t work and the table indicates check gages
sorry i speak litle english
sincerity
a mexican friend
thak you..
jaibita2000@hotmail.com

Jul 09, 2009 | 1993 Dodge Caravan

2 Answers

2000 buick regal L.S. electrical problems.


check body control module fuse . check head light relay and the drl lights relay.

Apr 25, 2009 | Buick Regal Cars & Trucks

1 Answer

The insterment cluster stopped working


find 10 amp cluster fuse and change it

Apr 11, 2009 | 2000 Dodge Caravan

1 Answer

Speedomiter


their is a battery on the back of the insterment cluster that may be bad if not it may need a speed sensor on the tranz.

Mar 04, 2009 | 2000 Dodge Caravan

1 Answer

Electrical System Failure


Did you check all the fuses. There is one probably 2 that are for the entire instrument cluster.

Nov 10, 2008 | 2001 Dodge Caravan

1 Answer

I have a 2005 grand caravan that makes a clunk noise when I put it in park. Should I be concerned? It has 62000 miles on it.


check the front engine mount. it is probably worn.
have someone shift from reverse to drive to reverse to drive while holding their foot on the brake. if the mount is bad the engine will rock back and forth as the gears are shifted. i have a 1988 caravan and it is just a few bolts to replace it. the mount i bought last week cost $17

Jul 29, 2008 | 1988 Dodge Grand Caravan

Not finding what you are looking for?
2001 Dodge Caravan Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

71162 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6992 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...