Question about 1994 Buick Regal Gran Sport

1 Answer

How do I remove an alternator from a 1991 Buick Regal Gran Sport

I am having trouble removing the belt and the instructions that came with the one I purchased are not clear can you help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 67 Answers

Is it a serpentine belt? If so, there should be a small pulley, called a tensioner. Loosen that, and you should be able to remove & replace your belt.

Posted on Nov 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do you fix the brake switch on a 1994 buick gran sport


if the switch is not working it will have to be replaced you don`t fix them. but you don`t say what problem your having with it.

Feb 10, 2015 | 1994 Buick Regal Gran Sport

1 Answer

How to install a 94 buick regal ignition modulator


take the negative cable off the battery,unplug the plugs relaled to the ignition module.remove the ignition wire from the coils ;remember where they were removed from so that you don't cross the wires. once that you've done that remove each coil and the ignition module will be cler and available for you to remove the screws that holds the module in place. install the new module, be sure to follow all directions and repeat the removable instruction in reverse to install new module.

Sep 03, 2012 | 1994 Buick Regal Gran Sport

1 Answer

1994 Buick regal gran sport coupe did not come with a passenger


NOt an expert but my guess is no. First an airbag uses essentially a powder charge to deploy the airbag. Installation and removal is not recommended for joe shade tree mechanic,it can be dangerous. Secondly all that installation has to have a place to mount and a spot inthe dashboard through which it can deploy. Chances are it if didn't come with one an airbag would have no place to "live". If it is even possible to have it done it would probably approach 50% of the value of the typical car that age. Good luck.

Sep 07, 2009 | 1994 Buick Regal Gran Sport

1 Answer

Where is the oil pressure sending unit on a 1991 buick regal gran sport 3.8?


Under hood, passenger side, rear engine area, below valve cover, mounted in block
hope this helps

Aug 15, 2009 | 1991 Buick Regal

1 Answer

WERE IS SPEED SENSOR LOCATED ON 1991 BUICK REGAL CUSTOM


For the speedometer? It's on the transmission near the passenger cv axle.

Jun 27, 2009 | 1994 Buick Regal Gran Sport

1 Answer

Crankshaft Position Sensor and Camshaft Position Sensor


REMOVE OR DISCONNECT

  1. Serpentine belt from the crankshaft pulley.
  2. Raise the vehicle on a hoist.
  3. Right front tire and wheel assembly.
  4. Right inner fender access cover.
  5. Using a 28 mm socket, remove the crankshaft harmonic balancer retaining bolt.
  6. Crankshaft harmonic balancer using tool J 38192 or equivalent.
  7. Sensor electrical connector.
  8. Foreign object deflector.
  9. Sensor and pedestal from block face.
  10. Sensor from pedestal.
INSTALL OR CONNECT:

  1. Loosely install the crankshaft sensor on the pedestal.
  2. Position the sensor with pedestal attached on special Tool J 37089.
  3. Position the special tool on the crankshaft.
  4. Bolts to hold the pedestal to the block face, torque to 20-40 Nm (14-28 lb.ft).
  5. Torque the pedestal pinch bolt to 3-4 Nm (38-40 lb.in).
  6. Remove special tool J 37089.
  7. Place the special tool 37089 on the harmonic balancer and turn. If any vane of the harmonic balancer touches the tool, replace the balancer assembly.
  8. Balancer on the crankshaft.
    • Apply thread sealer (GM 1052080) or equivalent to the threads of the balancer bolt.
  1. Torque the crankshaft bolt to 140 Nm + 56°(104 lb.ft + 56°).
  2. Foreign object deflector.
  3. Electrical connector.
  4. Inner fender shield.
  5. Tire and wheel assembly, torque to 140 Nm (104 lb.ft).
  6. Lower the vehicle.
  7. Serpentine belt.

Jun 02, 2009 | 1994 Buick Regal Gran Sport

1 Answer

Need diagram of 1993 Buick Regal Gran Sport suspension


try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you or you can try www.schramauto.com or call them at 1-800-292-1032

Mar 19, 2009 | 1993 Buick Regal

1 Answer

1995 buick regal gran sport battery draining battery is new. car won't start. starts if jumped and runs fine. shut off and let sit for an hour and won't start again. any ideas


Check the Tension on the Belt. If it is even a Little loose it will not allow the Battery to Charge. Check the Alternator Also.

Jan 24, 2009 | 1995 Buick Regal

Not finding what you are looking for?
1994 Buick Regal Gran Sport Logo

749 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...