Question about 2000 Buick Regal

1 Answer

How to replace a coolant level sensor, 2000 buick century

2000 buick century how to replace a coolant level sensor

Posted by on

  • 2 more comments 
  • Anonymous Mar 15, 2014

    how to replace headlite switch on 94 model buick century

  • Anonymous Mar 20, 2014

    low coolant light will not go out even though the coolant level is sufficient.

  • Anonymous Mar 23, 2014

    When I turn my car on it heats up and the water is not circulating through my car

  • Anonymous Mar 31, 2014

    Buick Century 2001 3.1liter needs new waterpump,how to replace?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

TRY THIS. Good luck!

Posted on Nov 22, 2008

2 Suggested Answers

Papa Chan
  • 56 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Posted on Jan 04, 2009

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low coolant light comes on when rad and reserve are full


There's a sensor in the reservoir, it's probably bad. The Coolant Level Sensor is replaceable and should be available at your local parts store, or at RockAuto,com for around $36.00.

Oct 18, 2015 | 2000 Buick Century

2 Answers

Engine coolant light stays on


Check your coolant reservoir it maybe low on coolant.If its not then the coolant temperature sensor could be faulty.

Oct 25, 2012 | 2000 Buick Century

1 Answer

2000 Buick Century - water pump replace


The water pump is not the problem if the recovery tank is full and no coolant is being sprayed onto the underside of the hood. the problem is a defective low coolant sensor which is very common in this car model and year. The sensor is in the radiator side tank and easy to replace as well as cheap, personally i disconnected mine.

Sep 03, 2012 | 2000 Buick Century

2 Answers

Low coolant light blinks and it seems that there is enough coolant


There is a coolant level sensor either in the coolant tank reservoir or attached to the radiator that is malfunctioning. If coolant level is ok then most likely the sensor is going bad.

Nov 22, 2010 | 2000 Buick Century

1 Answer

2000 buick century fuel filter location


Regarding the coolant level sensor, I had to remove the battery on my 2000 in order to "tap" the new sensor in. It has two O-rings on it and I couldn't get enough leverage to press it in w/o removing the battery. Perhaps others can do it w/o removing the battery but that's what I ended up doing.

Mar 10, 2010 | 2000 Buick Century

1 Answer

2000 buick century, where is the thermostat located. and what level should the antifreeze be? the temp guage on dash is staying on the c side what may be the problem?


The thermostat is in a housing on the engine. It's located where the lower radiator hose attaches to the engine. The coolant level should be right near the top of the radiator when you remove the cap, and the overflow canister should be filled to the indicated line (there are markings on the canister). If your gauge stays on cold, you may have a faulty coolant temperature sensor. If it will get to normal operating temperature while sitting still, but starts cooling down when you drive, you have a thermostat failure - it's stuck open, and will need replacement.

Dec 11, 2009 | 2000 Buick Century

1 Answer

Low coolant light comes on and off when there is plenty of coolant in system in my 2000 Buick Century


Probably a problem with the sensor contacts. Try to get it out and clean.

Oct 24, 2009 | 2000 Buick Century

1 Answer

Buick 1999 century replaced the sensor light and still comes on.


your buick century has a low coolant level sensor located in the passenger side of the radiator , sometiomes the sensor get covered with coolant sludge and will show that the cooling system is not filled , sometime the radiator is just still low on coolant . check the radiator when the engine is cold ( IF HOT WAIT !!! 30 mins ) and make sure the level is above the sensor.

Feb 06, 2009 | 1999 Buick Century

1 Answer

How to replace a coolant level sensor, 2000 buick century


The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Dec 20, 2008 | 2000 Buick Century

1 Answer

Low coolant light


In the surge tank, there is a sensor that detects the level of the coolant. It's most likely the sensor is stuck on the low position. All this sensor does is slide up and down as the coolant level goes up and down. You can tap the side of the surge tank near where the sensor plugs in and see if it will dislodge. You'll see the 2 wire plug at the bottom of the tank towards the front.

Jun 13, 2008 | 1992 Buick Century

Not finding what you are looking for?
2000 Buick Regal Logo

1,653 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

71694 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7031 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...