Question about 2003 Jeep Liberty

1 Answer

Light flashes on low setting when turning heated seat on

The light flashes and the seat does not warm. Eventually the light stops flashing. Any idea what could be causing this problem.

Posted by on

  • sharkbait005 Apr 16, 2009

    I have the same problem on my 2004 liberty...



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 74 Answers

(bad factory design) First keep large items from under your seat make sure nothing is hanging down or loose check each wire manually softly wiggle from side to side and up and down if something is loose more than likely that particular wire is the problem under there second make sure your passengers aren't placing shoes /feet under you seat and kicking the sensors or motor. you may need to change the seat temp sensor it has a fuse in it that is going bad from wear n tear or from leaving heated seat on after exit and shorting out when you turn on vehicle may be cheaper to go to junk yard and replace your seat(s) electronics for about $15- $35 when you clip the sensor wires make sure you leave enough wire to work with when you install same thing leave some existing wire to work with and cap off any loose wires with heat shrink wire protectors or gel wire protectors also change your fuse for your seats heat feature located in the fuse panel box remember to disconnect your battery before performing any electric maintenance. now here is the trick you need to get some tie straps and strap everything you see under seat up away from pesty passengers feet and from anything you may place under your seat If this doesnt work change out your seats from Junk Yard the seat wires my have a short in them and you cant get to all of em without destroying the seat(s) integrity light flashes on low setting when turning heated s - 1ak+f4pj7cbm32cuniyi2gaaaaaelftksuqmcc

Posted on Apr 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2010 Lincoln MKS Heated Seat on driver's side stopped working (Light in button turns off on its' own)

The most common cause of this problem is that the drivers seat heater grid is open or burned out. That is based on 25 years as a Ford dealer technician.

Feb 27, 2017 | Lincoln Cars & Trucks

1 Answer

2002 Chevrolet Blazer won't accelerate past 30mph

A flashing check engine light means the engine is misfiring. This flashing light will eventually set a code in the low 300's. When you get the code it will tell you which cylinder. If you get a straight 300 it means multiple misfires. Right now if the light is only flashing, check the secondary ignition for loss of integrity. It's more than likely there. I hope this helps.

Mar 29, 2014 | Chevrolet Blazer Cars & Trucks

2 Answers

Dasboard lights flash and warning beep operates (Seat Leon 2001)

flashing dashboard lights when the ignition is turned off

Dec 01, 2009 | 2001 Volkswagen Golf

2 Answers

Dash board lights on grand voyager flashing when engine on. car would not start so charged bat over night. Then bought a new bat. have changed battery and still happening. Did altinator test lights dipped...

the controls always click when you change the setting as it is electronic, don't panic, but you should ask your ex as he is well up in voyager' s and the back seat not folding down properly!!!!!

Jun 20, 2009 | 2000 Chrysler Grand Voyager

3 Answers

97 saturn sl2 temp light flashing and low coolant light flashing what could be the problem ? coolant is full and the heat works.

If the temp gauge is reading normal, the lights are flashing, and the coolant level is full, the level sensor in the coolant bottle is the problem. I'm a service consultant for a Saturn dealer and I've run across this many times.

Apr 17, 2009 | 1997 Saturn SL

1 Answer

Passenger seat won't heat

Hi my name is Allen!

The most probable cause for your problem is the heating grid that is mounted on the set for heating it, it is under the seat cover, the light will act weird because it is not completing the circuit. Raise the seat cover and visually look at it, it should be burnt.

For further asistance you may reach me at FixYa!

Dec 27, 2008 | 2001 Dodge Ram 2500 Truck

2 Answers

Heated seats button blinks and heated seat doesnt work Hi All I just bought this 01 ram 1500 Laramie,as with the others I hit the button and all it does is blink. Any suggestions on how I can fix this...

there is a problem in the circuit...if both the low and high lights are flashing there is a short in the element. if the high light is the only one flashing there is an open n he element and if the low light is only one flashing the heated seat sensor is out of range.

Nov 24, 2008 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Mark 4 golf, heated seats and central locking

basic but have you checked the fuse.

Sep 17, 2008 | 2001 Volkswagen Golf

Not finding what you are looking for?
2003 Jeep Liberty Logo

328 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides