Question about 1997 Chrysler Sebring

1 Answer

P0302 Engine Code

1997 Chrysler Sebring Convertible, 2.5 L. V-6. 109,501 miles. Last month I had all of the spark plugs and wires replaced (they are supposed to last at least 90,000 miles). The car has been running fine, but yesterday the Check Engine light came on. Autozone pulled a P0302 code. My car isn't running rough, in fact it feels the same way it felt after the plugs and wires were replaced - I don't feel any difference from before the Check Engine Light came on to when it came on.

Posted by on

  • Anonymous Mar 22, 2014

    Why is my fuel gauge reading different at different times? sometimes almost full, and than a little over half full? filled it up it shows full. drive 7 or 8 miles and it reads 3/4 full??
    The only thing i did recently was to change the spark plugs to the correct replacement of the new E.3 plugs. and that is when i noticed difference's?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Acroding to the codes it is a # 2 cylinder miss fire , sounds to me like there is a lot of carbon build up

Posted on Dec 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 04 sebring touring with flashing engine light. Code says #2 misfire. Replaced the fuel injector and coils but still runs ragged. What next?


Kimberly, Change the spark plug, if you have not done so. Check the links below for a long list of what could cause misfire.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

http://www.obd-codes.com/p0302
P0302 OBD II Trouble Code
Diagnose Engine Misfire

Jun 01, 2016 | 2004 Chrysler Sebring

1 Answer

97 acura 2.2 cl engine light p0302 code


A P0302 is indicating that cylinder # 2 is misfiring...Cylinder # 2 is the second plug counting from the front to rear of engine...Main causes for misfire are: defective spark plug, spark plug wire...When was last time plugs were changed? if it has been awhile I would suggest changing them...Also the spark plug wires should be replaced...Changing one plug and/or one wire isn't a good idea; change them all...Plugs cost two or three dollars apiece and a set of wires around $15...Standard motor products wire set # 4717...Spark plugs; Bosch platinum gaped at .044

Nov 13, 2015 | Acura Cars & Trucks

1 Answer

How often do I need to change the oil on my 2001 Chrysler Sebring Convertible?


Engine oil is every 5,000 miles or 12 months.
I think the owners manual says 7,000 miles.

Sep 06, 2013 | 2001 Chrysler Sebring

1 Answer

My 1997 chrysler sebring convertible turns over but will not start. The check engine light has been on since we bought it a month ago. we were told it was because of the o2 sensor.


you'll need a code reader to see the code no start issues can be many things check all your fuses does the engine crank is fuel flowing is do you have spark start by trying to get the codes

Sep 04, 2012 | 1997 Chrysler Sebring

1 Answer

1999 chrysler sebring convertible jxi code p1495 intermittant shut off while driving. Replaced fuel pump and filter, distributor, spark plugs and wire. Was advised by ZJLimited to remove connector from the...


replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...
  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Jun 03, 2010 | 1999 Chrysler Sebring

1 Answer

1999 Chrysler Sebring Convertible code P1495. I


Code 1495 = Leak Detection Pump Solenoid Circuit

Remove the connector from the solenoid (should be on the back wall, just to the drivers side of the air-hat). You will have the solenoid to check and the harness. What you want to measure is the voltage coming from the harness and the resistance of the solenoid.

Turn the key to the "ON" position but do not start the motor; the voltage at the connector should be at least 10V or more,.now, check the resistance of the solenoid (should be around 35 ohms).

Hope helps.

Jun 03, 2010 | Chrysler Sebring Cars & Trucks

1 Answer

Is it difficult to change the spark plugs on a 2004 Chrysler Sebring Convertible V6


Yes. Yopu must remove the plenum, which means a new gasket.

The plug wires go down into the valve covers. The circular gaskets there often leak, so I would replace the wires and gaskets around them at the same time because it is all exposed.

Dec 01, 2009 | 2004 Chrysler Sebring

1 Answer

97 crysler sebring convertible wont start cranks but no fire replaced the timing belt and pullys distributer cap and rotter button the plugs and wires were replaced last month it has no fire the symptoms...


Hmmmm...are you sure when you changed the timing belt that all the timing marks were ligned up correctly?

Did you check to make sure you had no damaged valves?

Nov 16, 2009 | 1997 Chrysler Sebring

2 Answers

My 2004 chrysler sebring electical is not working.


Check around the MAP sensor area for any connections that may have been disturbed while you were replacing the sensor. Most or all of those functions are controlled by the body control module. I would think that a fault like that would show on the scanner readouts.

Aug 23, 2009 | 2008 Chrysler Sebring Convertible

2 Answers

Have a 03 pt cruiser with a trouble code P0302, stubbles bad and smells rich.


The P0302 Code points to a misfire detected on the # 2 cylinder. If its stumbling, I would first suspect the plug or wire is bad. I believe the ignition coil on that vehicle is a single coil pack with four terminals, so if only the P0302 code is coming up I would start with the plug and wire. May be time to do a tune up and just replace all the splugs and spark plug wires.

Dec 28, 2008 | 2002 Chrysler PT Cruiser

Not finding what you are looking for?
1997 Chrysler Sebring Logo

Related Topics:

555 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...