Question about 2006 Hyundai Sonata

Open Question

Remote battery need to change battery for remote entry 2006 sonata

Posted by on

  • Rod Clark May 11, 2010

    do you mean you need to change the tiny cell inside the handheld keyfob remote ?

×

5 Suggested Answers

shaggyrat
  • 1224 Answers

SOURCE: Ford battery operated remote entry keypad

if it looks like a sealed remote either at top or bottom take a quarter or penny there should be a little **** on the form line big enough for the quarter or penny this is how you open the key remote other type is a screw type and i dont believe you have this type cause your asking how to open it

Posted on May 20, 2008

Punky_1981
  • 75 Answers

SOURCE: Keyless Remote 2008 RAV4

You can take it back to the dealer, and have them change the battery, or go to Autozone, buy the battery and do it yourself. They can show you how to do it. And which battery it takes. It's not hard to do. Good luck.

Posted on Jan 27, 2009

  • 1 Answer

SOURCE: My 1998 hyundai sonata keyless entry alarm is malfunction.

Where to buy 1998 Hyndai Sonata 16V ECU KESICO 39110-38640

Posted on Jun 15, 2009

Sgt Fluffy
  • 157 Answers

SOURCE: got an used Hyundai Sonata 2002, need to program the remote for k

The dealer uses a little computer to do that. Shops that install remotes and alarms can also do it. OK?

Posted on Jun 17, 2009

ghost45
  • 1280 Answers

SOURCE: change the battery of the alarm remote control?

open it up and replace the battery... simple

Posted on Oct 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW PROGRAM THE KEY LESS ENTRY FOR SONATA 2012


  1. Cars
  2. Car Maintenance
  3. General Car Maintenance
  4. How to Program Keyless Entry Remotes in a Hyundai Sonata
How to Program Keyless Entry Remotes in a Hyundai Sonata By Christian Killian, eHow Contributor
20Found This Helpful The keyless entry system in your Hyundai Sonata is part of the factory alarm system. If you have to replace a lost or damaged remote, reprogramming will be necessary. The remote is important because not only does it lock and unlock the doors, it also arms and disarms that factory alarm when you open or close your car doors. New remotes are available from any Hyundai dealer. While they will program it for you, you can do it yourself and save a programming fee.
How to Program Keyless Entry Remotes in a Hyundai Sonata(Kleophaus Livingston/Demand Media)

Other People Are Reading


Step 1: Locate the fuse panel under the dash on the driver's side of the car. Just below it is the control module for the factory alarm system. Open the cover on the alarm system control module and locate the memory switch inside.
(Kleophaus Livingston/Demand Media) Step 2: Verify that the switch is in the "Off" position; if it is not, switch it to the "Off" position. This is important for the system to understand what you want it to do when you move to the programming mode.
(Kleophaus Livingston/Demand Media) Sponsored Links
Step 3: Insert the key into the ignition of your Sonata and turn the key to the "On" position. Wait for 60 seconds, then move the memory switch inside the control module to "Set."
(Kleophaus Livingston/Demand Media) Step 4: Depress and hold the "Lock" button on your remote for one full minute. This allows the remote and the control module to communicate and sync. Release the "Lock" button and turn the memory switch in the control module back to the "Off" position.
(Kleophaus Livingston/Demand Media) Step 5: Turn the ignition switch to the "Off" position and test the remote by pressing the "Lock" or "Unlock" button, verifying that the doors do lock or unlock.


Read more : http://www.ehow.com/how_6362326_program-entry-remotes-hyundai-sonata.html

Mar 29, 2015 | Hyundai Sonata Cars & Trucks

1 Answer

I have a romote starter in my 2006 Sonata...battery died had use jumper cables and then sarter stopped working. Is thea way to reset them ? It was not factory installed thank you


Sounds like a job for the company that installed the remote starter. As we all know there is only 1 company that makes remote car starters, but i do not remember what it is and you aint giving up the information. Try the installer of the remote.

Apr 14, 2014 | 2006 Hyundai Sonata

1 Answer

I need instructions to program keyless entry remote for 2002 Hundai Santa Fe


For a 1994 to 2006 Sonata, a 2001 to 2006 Elantra, a 2000 to 2006 XG350 or a 2001 to 2006 Santa Fe, you will need to access alarm system control module. On most of those vehicles it is located on the driver's side fascia panel. But on the Sonata, the facia panel is in the center.

  • 2 Once you have found this module, you will want to ensure that the memory switch is in the OFF position. Then turn the ignition on.
  • 3 Wait 5 seconds and set the memory switch to SET position and then press the remote transmitter lock button to send the code to the alarm system control module.
  • 4 If you would like to program a second remote transmitter then you will need to press second remote transmitter lock button.
  • 5 Next set the memory switch to off, then turn the ignition off. You can confirm your programming by locking and unlocking the vehicle with both of the remotes. good luck my friend
  • Feb 08, 2012 | Hyundai Cars & Trucks

    1 Answer

    I added a new battery to what i think is the keyless entry remote for my 2000 hyundai sonata(just purchased), and when i pushed a button to try to figure out how to work it, it has caused to key not to...


    are you sure you got the right battery replacement? sounds like you've changed the size or shape of your key.put the old battery back into your remote and then try to manually unlock doors with your key.or if you've thrown the old battery away try putting the remote back together with out any battery in it,at least you'll be able to gain access your car again until you can get the right battery. hope this helps! thank you for choosing fixya.com let me know if this works please. thank you

    Jan 10, 2011 | 2000 Hyundai Sonata

    1 Answer

    Change the battery of the alarm remote control?


    open it up and replace the battery... simple

    Aug 25, 2009 | 2006 Hyundai Sonata

    1 Answer

    My 2003 sonata dont lock the door with power switch and the remote but i heard a relay'clik' but nothing happen the actuator in the door dont recieve a signal to lock the door and the 2 other


    dear friend-if you say that none of the doors are working with the remote it possible that your keyless entry lost its code or the main motor is faulty.try recoding first.

    Jul 08, 2009 | 2006 Hyundai Sonata

    2 Answers

    Sonata 06 keless programing


    Hi,

    I have heard of a site that would help you regarding programming your remote :-

    http://keylessride.com/

    Hope that i helped you.

    Thanks for using "Fixya".

    Jun 23, 2009 | 2006 Hyundai Sonata

    1 Answer

    My remote for Hyundai sonata 2006 dose not work


    you shud have 2 remotes. If one works & one doesn't, try changing the battery inside the bad one first.

    If neither one works, you need the dealer. They are not available any other way.

    Apr 19, 2009 | 2006 Hyundai Sonata

    Not finding what you are looking for?
    2006 Hyundai Sonata Logo

    Related Topics:

    97 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Hyundai Experts

    yadayada
    yadayada

    Level 3 Expert

    63801 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21990 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Hyundai Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...