Question about 1996 Plymouth Voyager

1 Answer

96 voyager stalls won't turn over after some time it goes

This morning it started fine and I drove about 10 miles to work. about an hour later it wouldn't start( doesn't turn over) All electrics work so I tried to run codes. Nothing. After about 10 minutes I heard the fuel pump, and it started and ran fine all the way home. This has been doing this for years and is unreliable. Sometimes it will go for months without any trouble and then it will quit several times in a short time.

Posted by on

  • 3jays Nov 23, 2008

    It is not the relays. they've all been changed. Its not the fuel pump. There is no power to the ecm. Once power is restored to the ecm the pump starts and i'm good to go. I removed all the relays and fuses and cleaned the conections. put it all together and now it codes 66 and the ses light stays on. ???

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

1- under the hood their is a two relays Fuel pump and engine cut off. locate both relays. Next time the vehicle will not start have someone inside the vehicle turn the key to start and if feel with your fingers the top of the relay and listen for the CLICK. It is possible that one of the relays is sticky. I would just replacement as they are only 10-12 bucks from most dealers and auto parts stores. If this does corrected the problem next time the vehicle does not start bang the gas tank with a sometime and try it again. If it starts after banging then you fuel pump motor is sticking

Posted on Nov 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Dodge Intrepid stalling


Catalytic convertors' been bad for ten years?!! They're probably plugged.

Jun 04, 2013 | 1999 Dodge Intrepid

1 Answer

1997 Lincoln Towncar, cranks but won't start?


first you need to test for spark if there is spark then check for fuel if there iis no spark have your ignition module ckecked for fuel take the lifuel line off from fuel tank to fuel lilter it is not difficult.

Jan 24, 2013 | Cars & Trucks

1 Answer

The car turns over like it is going to start but won't. It is still firing, has good battery, alternator and gas in it. It is a 1996 plymouth neon. Started fine when I went to work this morning, b


tell individual working on it to check the crankshaft sensor voltage and signal when it wont start also check the fuel pressure and cam sensor, these are all possible problem with that particular car. it also has wiring issues that an expert tech would have to diagnose

Feb 29, 2012 | 1996 Plymouth Neon

1 Answer

On my trip form Houston to San Antonio last saturday around 2pm in the afternoon, While driving at over 70 mph constantly for about 1 hour the engine light came on and the red flash siymbol came on in my...


go t auto zone and have them run a diagnostic for free when the light is on , that will tell you the problem easy , or you can buy an OBD scanner,

Jul 25, 2011 | 2004 Dodge Ram 1500

2 Answers

Just recently bought a 2003 Mazda RX8. Everything fine until I came to set of traffic lights about 10 miles from home and the engine stalled and I could not re-start it. Got towed home and then tried the...


You say he removed the fuel pump fuse? Do you mean he changed the fuse? The fuel pump can't work without the fuse. Perhaps the fuse is blowing and causing the engine to stall and not restart. Find the fuel pump relay and swap it with another relay of the same type. Make sure the fuel pump fuse is good. If the engine starts, drive it around close to home until you think it's had time to stall out again. If it down'nt stall this time then the relay is bad and needs to be replaced.

Jan 05, 2011 | 2004 Mazda RX-8

1 Answer

Drove home - 45 highway miles, turned suv off. 10


make sure proper grade of oil was fitted check with toyota see if special grade oil is recommended

Jan 07, 2010 | 2003 Toyota Highlander

4 Answers

96 Blazer stalls when hot on hotest days


I had a similar problem on my 95 jimmy. It was something that took a lot of time and money to diagnose, but now 3 years later...no proplems. Emissions requires the truck to have an EGR valve (exhaust gas recycle) and this deposits gunk (carbon residue) on your MAF (mass air flow sensor) If you catch it in time you can use a carbon cleaner from Autozone or checker Lightly on the MassAirFlow sensor. If not in time you may have to have either the MAF or EGR valve replaced and these are expensive. After a long period of time being undetected eventually the EGR valve will start smelling like sulfer, this means its to late to clean and save!

Hope this helps

Jul 16, 2008 | 1996 Chevrolet Blazer

Not finding what you are looking for?
1996 Plymouth Voyager Logo

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...