Someone broke my window with a rock, possibly in an attempt to steal my radio.
SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: 2004 chrysler sebring.The driver side rear door electric window
you have a bad window regulator assembly
SOURCE: Crank sensor and camshaft sensor
The crank sensor is in the top of bell housing of the transmission towards the back of the engine compartment. The cam sensor is built into the distributor.
SOURCE: Driver Side Window not working in 2006 Sebring
cable that lifts it up could have broke you will need to remove door panel and take it out to have a look.Does it make a noise when you operate the switch
SOURCE: I HAVE A 2005 CHRYSLER SEBRING AND DOME LIGHT,RADIO ALL POWER LOCKS HAVE QUIT WORKING
me too! - looking at fuse #5 red 10 Amp one but has black thing on it.
Can't get if off..
Have read the manual is wrong and to use panel on side of fuse box for fuse locations...
100 views
Usually answered in minutes!
×