Question about 2004 Dodge Ram 1500

1 Answer

Lampout start the vehice and the lampout warning light comes on the cluster panel.

Posted by on

  • yadayada
    yadayada May 11, 2010

    Check the lamp and make sure the lamp works, which I assume you have already done, does the lamp seem dimmer than othere like it? Did you recently replace a bulb for this problem?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 74 Answers

I have owned 3 dodge rams and this happened to me also and tap the tail light and its works again, the bulbs dont go bad to often unless you have a cracked tail light, the tail light bulbs have poor connection there are 2 per side and usually one of them ends up bad connection and comes loose remove tail light clean and grease connections slightly pinch the connectors to tighten them up this should solve the problem

Posted on Nov 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Warning lights panel doesn't come on. No warning lights.


Check your ground connection to the warning light cluster. Either the ground wire has come loose or the connection to the chassis has corroded.

May 07, 2015 | 2000 Dodge Caravan

2 Answers

Is it normal to have a red triangular warning light come on after pressing the start button and then go off as soon as the other lights(car seat, air bag, break etc) go off..


It's normal. It's part of the instrument cluster module doing what's called a "bulb check" on initial start up, and it should go off in under ten seconds, since it does, there is no problem

Feb 17, 2015 | 2015 Toyota 4Runner

1 Answer

2001 rodeo check engine light does not come on at start up, Suspect the bulb needs to be changed. However the past two days it did come on at start up. But not this morning..? Idk wht to do.


A light bulb usually does not come and go, but it could be the lamp socket or something in the circuit board in the cluster.
You might be able to tap into the circuit for the warning bulb before it gets to the cluster and use a test light to check it.

Feb 21, 2013 | 2001 Isuzu Rodeo

1 Answer

1999 dogde dakota sport electical problems


DASHBOARD WARNING LIGHTS ARE ON

Yes it may be the wires are shorting or its actually the problem with instrument cluster.


Also get the vehicle scanned for any error codes stored in computer this will confirm whether is short circuit issue or actual problem:------


I suggest you help link with accurate solutions to refer/go through:----

Click the link below:------


http://alltypesofpartsreplacing.blogspot.com/2012/12/dashboard-warning-lights-are-on-engine.html

==========

These will help.

Thanks.

Dec 09, 2012 | Cars & Trucks

1 Answer

All warning lights on dash come on and all electrics stop working


The common problem with the dashes on the Jeep is contacts. Remove the cluster and try cleaning the electrical contacts with a Q-tip and alcohol replace cluster and try again.

Aug 02, 2009 | 1995 Jeep Grand Cherokee

1 Answer

The turn on lights does not flash


Check out this recall below:
Bulletin No.: 04098A

SPECIAL POLICY
Subject:
04098 - Special Policy Adjustment - Turn Signal/Hazard Warning Flashers 

Condition
Some customers of 1999-2002 Chevrolet Malibu, Oldsmobile Alero, Pontiac Grand Am, and 1999 Oldsmobile Cutlass may have turn signal/hazard flashers that become inoperative.

Special Policy Adjustment
This special policy covers the condition described above for a period of 10 years or 150,000 miles (240,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership. The repairs will be made at no charge to the customer.

Good luck and hope this helps:
HAZARD WARNING SWITCH REPLACEMENT - ON VEHICLE 
REMOVAL PROCEDURE 

Remove the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent. 
Remove the instrument panel cluster. 
Remove the hazard warning switch bezel from the instrument panel using a small-flat bladed tool to release the retainers.
Remove the left side bolt from the hazard warning switch through the instrument panel cluster pocket Remove the right side and center lower bolts from the hazard warning switch through the center air louver deflector pocket.
Reposition the hazard warning switch from the instrument panel to access the electrical connector. 
Disconnect the electrical connectors from the hazard warning switch. 
Remove the hazard warning switch from instrument panel. 

INSTALLATION PROCEDURE
Connect the electrical connectors to the hazard warning switch.
Position the hazard warning switch to the mounting points in the instrument panel. NOTE: Refer to Fastener Notice in Service Precautions.
Install the left side bolt to the hazard warning switch through the instrument panel cluster pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the hazard warning switch bezel to the instrument panel pressing into place until fully seated. Install the instrument panel cluster. 
Install the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent.

May 24, 2009 | 2000 Oldsmobile Alero

1 Answer

It beeps and there is no lights on the dash


make sure your air bag light is operating. if the airbag light is burnt out on the instrument cluster, it will beep an audible tone to let you know there is a problem since there is no working warning light. turn key on (but dont start vehicle) and see if the air bag light comes on and shuts off (its called "prove-out") if it does not come on at all, chances are... the light for air bag warning on cluster is burnt out

May 07, 2009 | 2001 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...