Question about 1996 Chevrolet Blazer

1 Answer

Trans will not shift good on take off drags

SHIFT PROBLEM ON TAKE OFF. REPLACED 2-3 SHIFT SELENOID PER TROUBLE CODE AT AUTO ZONE.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 324 Answers

Make sure your drag link is adjusted correctly, loosin the bolt and let it kind of slip into it's own position.

This should make it shift correctly, and as an extra measure, put a bottle of lucas trans fix in it....

Posted on Nov 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does i have to have it flashed after replacing selenoid d code 765


Hi Grace , no you don't need to have it flashed , reprogramed ! How to Test Diagnostic Trouble Code P0765 Shift Solenoid Malfunction P0765 Chrysler Underdrive Solenoid Circuit Fault You need to see if there is a open circuit too , broke wire that goes to that solenoid !

Mar 22, 2015 | 2001 Chrysler Town & Country

1 Answer

DTC TROUBLE CODE 1776


replace transmission shift solenoids on the trans valve body.

Jun 17, 2012 | 2003 Jeep Liberty

1 Answer

On my 1997 Lexus SC300 w/ auto trans. I read the trouble code "shift solenoid B" I would like to know exactly where solenoid B is located. Can you help


I sure can. The shift selenoid is in the transmission. This component uses hydrolic pressure to change the gear ratio and exchange higher gears. You will need to remove the transnission in order to gain access to the shift selenoid. My advice is to get the fuild change or run a detergent/cleaner in the transmission to try and salvage it.

Jun 18, 2011 | Lexus SC 300 Cars & Trucks

1 Answer

2003 Ford Focus p1747 short solenoid error


THIS IS A COMMON CODE.. THIS IS A PRESSURE SELENOID LOCATED INSIDE THE TRANSMISSION.... SOMETIMES CALLED A SHIFT SELENOID... THERE IS A FIRST TO SECOND SHIFT SELENOID AND A SECOND TO THIRD AND A THIRD TO OVERDRIVE... THE SHORT CIRCUIT CODE CAN BE TWO THINGS.. FIRST A BAD SPOT IN WIRING HARNESS CAUSING SHORT CONDITION.. DOUBTFULL... OTHER CONDITION IS THE SELENOID ITS SELF COULD BE GOING BAD DRAWING MORE CURRENT THAN NORMAL. THIS WILL REGISTER THIS CODE....YOU HAVE TO REMOVE THE TRANSMISSION PAN TO EXSPOSE THE VALVE BODY.. THERE YOU WILL SEE SEVERAL SHIFT SELENOIDS...WHEN YOU PURCHASE THE REPLACEMENT IT WILL GIVE YOU A GOOD IDEA WHAT TO LOOK FOR....THEY JUST PLUG IN AND 1 OR 2 SCREWS HOLD THEM IN.... LET ME KNOW IF MORE HELP NEEDED

Aug 31, 2009 | 2003 Ford Focus

1 Answer

Transmission not shifting on its own.


check the shift solenoids by using a OHM METER .the both solenoid connectors has 2 terminals 1 and 2 .take ohm meter measure terminal 1 resistance to body ground it should be 14-30 ohms.if less or more replace it.then number 2 terminal to ground.do both the connectors that you disconnect.they should be 14-30 ohms.if less or more replace them.if they check out good .your valve body in transmission is going have to be removed.

May 25, 2009 | 1992 Honda Accord

2 Answers

2002 Kia Sedona XL suddenly downshifts


What was the codes exactly that Auto Zone gave you.??? it might just be a simple wire harness that may have gone loose since you did some work on the speed sensor.
Here are the trouble codes for your car.  Good Luck and get the car scanned again for a more define information.

P0751 Shift Solenoid A Performance or Stuck Off

P0752 Shift Solenoid A Stuck On

P0753 Shift Solenoid A Electrical

P0754 Shift Solenoid A Intermittent

P0755 Shift Solenoid B Malfunction

P0756 Shift Solenoid B Performance or Stuck Off

P0757 Shift Solenoid B Stuck On

P0758 Shift Solenoid B Electrical

P0759 Shift Solenoid B Intermittent

P0760 Shift Solenoid C Malfunction

P0761 Shift Solenoid C Performance or Stuck Off

P0762 Shift Solenoid C Stuck On

P0763 Shift Solenoid C Electrical

P0764 Shift Solenoid C Intermittent

P0765 Shift Solenoid D Malfunction

P0766 Shift Solenoid D Performance or Stuck Off

P0767 Shift Solenoid D Stuck On

P0768 Shift Solenoid D Electrical

P0769 Shift Solenoid D Intermittent

P0770 Shift Solenoid E Malfunction

P0771 Shift Solenoid E Performance or Stuck Off

P0772 Shift Solenoid E Stuck On

P0773 Shift Solenoid E Electrical

P0774 Shift Solenoid E Intermittent

P0780 Shift Malfunction




May 05, 2009 | 2002 Kia Sedona

2 Answers

Trans will not shift


Speed sensor and neutral safety switch need to be checked and or replaced.

Apr 05, 2009 | 1994 Chevrolet Caprice Classic

1 Answer

1998 TOYOTA 4 RUNNER SHIFT SELENOID


Shift solenoid E is considered the dead solenoid //// cheaper to replace trans

Mar 16, 2009 | 1998 Toyota 4Runner

1 Answer

1999 DODG 3500 AUTO TRANS SHIFTS TO 2ND WITH A LITTLE HELP


I have a 1999 Ram B 1500 Van, auto transmission, 5.9 L engine.
Same problem, trans hesitates in 2-3 upshift, sometimes 1-2
to 2-3 upshift. Posts trouble code P1756 - Transmission Govenor pressure too low at below 15 to 20 Psi. Transmission pump shot or valve body leak stops trans from reaching proper pressure to shift, which is minimum 15 Psi.
Either trans is leaking in valve body, valve is stuck, shift solenoid on valve body is sticking, or pump is shot.

Feb 14, 2009 | 1999 Dodge Ram

1 Answer

Fault code


The information I can find on this shows a code 15, not 16. It shows it as a problem with the #1 shift solenoid or it's harness. Causing different internal transmission concerns. The book I found shows no code 16,this could be a miss print. Either way, this is a concern that appears to be an internal trans. problem.Good luck.

Aug 19, 2008 | 1990 Subaru Legacy

Not finding what you are looking for?
1996 Chevrolet Blazer Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6879 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...