Question about 1996 Ford Escort 4 Door

1 Answer

No spark i had to replace the timing belt did that put timing dots at 12oclock new plugs wires coil pack fuses are all good but no sparkcan u help me please

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 272 Answers

Set your engine to TDC and see if your rotor arm is pointing to number 1 cylinder. If not, slowly move the dissy until the arm is pointing to No 1 cylinder. Lock the dissy and turn over the engine. The HT leads needs to be the correct order.

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1990 hond accord will turn over but wont start can you please help


MAKE SURE SPARK PLUGS AND WIRES IN GOOD CONDITION, REPLACE DISTRIBUTOR CAP AND ROTOR,CHECK FOR SPARK AT SPARK PLUGS,IF YOU DONT SEE SPARK CHECK TO SEE IF POWER GOING TO COIL IF NOT CHECK IGNITION FUSE.IF FUSE OKAY AND POWER GOING TO IGNITION COIL,COIL FAULTY OR IGNITER UNIT FAULTY. CHECK FOR FUEL PRESSURE MAKE SURE FUEL FILTER BEEN CHANGED.FUEL PRESSURE SHOULD BE 40 PSI. IF YOU GETTING SPARK AND FUEL. YOUR IGNITION TIMING OFF OR VALVE TIMING OFF DUE TO A WORN TIMING BELT.

Nov 01, 2011 | 1990 Honda Accord

1 Answer

How do I change spark plugs and cables on my 05 Nissan sentra 1.8 special edition??and what else do I need besides the plugs ? Please write back at mailto:Marcomerino75@yahoo.com


Hello,
I am carsandcomps from Fixya.com. My name is Brandon. In order to replace your spark plug wires and spark plugs (best to do both) - do one at a time. Start from one side of the engine (ex: drive front/back) depending on your engine position; doesn't really matter, just start at one side.
1. Remove plug wire from plug (make sure new plug is gapped; auto parts dealer can give you this, and sell you a spark plug gap tool for cheap) 2. Follow the spark plug wire (existing one) to it's place on the distributor (if equipped) or coil pack (if equipped). 3. Pull the wire off from the distributor cap (or coil pack if equipped); insert new (gapped) spark plug, and put the new plug wire on.
Do this step for each one, as it ensures each one is placed properly and your engine will run as needed when finished. Also make sure they "click" when pushing them onto the plugs and distributor cap (coil pack) whichever is present.

Please let me know if you need further assistance.
carsandcomps

Aug 20, 2011 | 2005 Nissan Sentra

2 Answers

Can it have a short in we put cole packs on it new alternator batterie modulare ouder the cole pack but it is still like it is miss firing can you help us been broke down for 3 weeks realy need our car


If the coil pack did not resolve the issue you are experiencing, then you may either have an injector issue, or a faulty PCM-powerterain control module, also known as the vehicle's computer.

Apr 06, 2011 | 2003 Chevrolet Impala

1 Answer

Replaced spark plugs & wires now vehicle has no spark,help has plenty of fuel can smell it when cranking over,also tried to install new crank sensor,help please.


Hi and welcome to FixYa!

If that's the case then the coil pack can be faulty. If the coil pack is faulty it tends not to give current to the plugs. As a first course of action I strongly suggest that you replace the coil pack. It's located inside the engine at the side where the plug wires are connected. You will need to remove the cap first to gain access to the coil pack.

Hope this helps and thank you for using FixYa! Have a good one!

Mar 08, 2011 | 2002 Hyundai Santa Fe

1 Answer

Autozone says it's #4 not firing and to put some gas treatment in. and new plugs and wires. still misfiring.


Check ignition coil pack for spark, at ignition coil with engine running disconnect one spark plug wire at a time, they should all spark, if no spark out of any of the coil pack, replace coil pack.

Nov 09, 2010 | 2001 Hyundai Tiburon

2 Answers

Missfire # 5 cyl before and after plugs and wires ?I changed some vacume hoses still same what to ck nexed


i had that happen plenty of times. be sure that the new plug isnt bad and ohm test or see if you haave spark on the new wire. good luck

Jan 07, 2010 | 2001 Ford Explorer Sport

1 Answer

Engine wont start. Acts like it is hitting on two cylinders. Need advice on how to check the coil packs.


Start engine, used spark plug piler so you don't get shock, remove one wire at a time if you dot' have spark replace that coil pack, there is three coil pack on top of ignition module you don't have to replace all, just bad one.hope this help.

Nov 28, 2009 | 1995 Pontiac Bonneville

2 Answers

2001 Dodge Strutus will not start


yes it could be the ignition switch.

Apr 28, 2009 | 2001 Dodge Stratus

7 Answers

Hi, I was wandering if someone could tell me, what i need to do to fix my piaggio liberty 125, it has no spark. I have installed a new spark plug and still no spark.


Try removing the distributor cap and ceck to see if the rotor was broken. Please bear in mind this might not be the problem, but it's a start.

Dec 30, 2008 | Ferrari 420 Modena Cars & Trucks

Not finding what you are looking for?
1996 Ford Escort 4 Door Logo

Related Topics:

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...