Question about 1998 Jeep Cherokee

2 Answers

Missing in idle

93 jeep cherokee 4.0 , just started missing, changed plugs, wires, cap, rotar button, and still missing. from idle to 2000rpm, under 45 mile and hour misses very bad , over 2000rpm, at 45 mile an hour miss seems to clear up little.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 189 Answers

Check for vacume leak, there could be a hose off somewhere

Posted on Oct 08, 2011

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check the EGR valve it is open maybe

Posted on Nov 21, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How I can fix miss fire cilender #2, Jeep Grand Cherokee 2004


change the plugs if it continues to do it replace wire/ coil if I remember correctly these have individual coil/wire for each cylinder its not like older models with cap, rotary button, and individual wires


hope this helps

Aug 30, 2014 | 2004 Jeep Grand Cherokee

1 Answer

Jeep starts but immediately dies off


run fault codes and check for MAF/MAP and VAF sensor problems

Feb 22, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

My 1995 jeep grand cherokee laredo 4.0 inline 6


Something mechanical, ignition, or fuel.
It can run rough under a load such as in gear and ok in neutral with no load. Have you checked the plugs and dist cap ?

Feb 11, 2014 | Jeep Grand Cherokee Cars & Trucks

1 Answer

My 93 ford f250 5.8L started missing. I changed plugs wires cap rotar and coil but still missing


You may have a blown head gasket or burnt valve. Run a compression test on all cylinders. If you find one or more that is low then there is your miss.

Feb 08, 2011 | Ford F-250 Cars & Trucks

2 Answers

96 jeep cherokee, inline 6 4.0... runs fine... after shut off (5-10 mins) acts like its chokeing out, wont start acts like its missing, no combustion (fuel injected) let sit for 20 mins, fires up fine......


Try the pick-up coil that is under the distributer cap.Remove the cap and rotor button then remove the plate that is under the rotor button.Next you need to take off the relucter wheel that is in the way so you can take out the bolts and remove the pick-up coil.

Nov 24, 2009 | 1996 Jeep Cherokee

1 Answer

93 jeep cherokee will turn over but wont start I have spark at the distributor but nothing at the spark plugs.


check the rotor inside the distributor,, it could be open circuit??? or the caps a dud one,, the little center carbon brush may be broken or the little string is missing,,,

Oct 27, 2009 | 1993 Jeep Cherokee Country

1 Answer

Slight miss, starts a little hard then runs fine rough idle from time to time


It sounds like its out of time move the distriutor a little bit

May 10, 2009 | Jeep Cherokee Cars & Trucks

1 Answer

Idles poorly


OR MAYBE YOUR GAS FILTER LOCATED UNDER YOUR OIL FILTER, PANEL UNBOLTS UNDER RIGHT FENDER WELD FOR EASY ACCESS, THE BIGGEST FIX FOR ME WAS TO TAKE OFF THE ADVANCE AUTO BRAND NEW SPARK PLUG WIRES AND INSTALL NAPA WIRES, DISTRIBUTER, ROTAR BUTTON, AND NGK ORIGINAL SPARK PLUGS. ROB

Jan 28, 2009 | 1991 Toyota Pickup

1 Answer

Engine miss above 2000 rpm


sounds like a valve problem. check compression running and non-running. valve sealing at higher rpm is usually a valve spring problem is if runs ok at idle.

Oct 22, 2008 | 1990 Jeep Wrangler

Not finding what you are looking for?
1998 Jeep Cherokee Logo

Related Topics:

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...