Question about 1990 Isuzu Trooper

2 Answers

Need engine diagram for a 1990 trooper 2.8 v6

I dont want to mess nothing up, kindly request a diagram for the engine.
removing starter i dont normaly remove starters

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Www. myisuzuparts.com has great parys break down

Posted on May 27, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I would go to www. my isuzu parts.com
and view their index. It takes a little getting used to
but you can find oiut where a lot of stuff goes and how it connects.
Other than that go to a library and try to view a Haynes,Chilton
or Mitchell maintenance manual for more specific stuff.
If you go to my isuzu parts besure to notice the tabs at the top of each diagram --they will tell you if the diagram is for
a 4 cyl, a deisel or the v6.
good luck

Posted on Nov 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My 92 lincoln town car will not start i have replaced the starter, the neutral safety switch and the battery but when i turn key nothing happens but can jump starter and will crank


Yes there is a starter relay in the wiring diagram.
The yellow and lite blue wire goes from the starter solenoid to the relay. There is a yellow wire from the relay to a 30amp fuse. The key switch powers thru the neutral safety switch and then powers the relay on.

Jan 29, 2013 | Lincoln Town Car Cars & Trucks

1 Answer

Starter


For step by step starter removal on your vehicle, with diagrams,Click the link below:----

Nissan Maxima Starter removal

http://technoanswers.blogspot.com/2012/11/nissan-maxima-starter-removal.html

==========
These will help.
Thanks.

Nov 28, 2012 | 1997 Nissan Maxima

1 Answer

Where is the starter? and How do I replace it?


Hello! It's under the engine on the right side under a cover...See diagram below...Guru...saailer
  1. DISCONNECT BATTERY NEGATIVE TERMINAL
  2. REMOVE ENGINE UNDER COVER RH...

    1. REMOVE STARTER ASSEMBLY...
    (a)Disconnect the starter connector....(b)Open the terminal cover....(c)Remove the nut, then disconnect the starter wire...(d)Remove the 2 bolts, then remove the starter....
    1. INSTALL STARTER ASSEMBLY Torque: 37 Nm (378 kgf-cm, 27 ft-lbf) for bolt 9.8 Nm (100 kgf-cm, 7 ft-lbf) for nut...
    2. INSTALL ENGINE UNDER COVER RH...
    3. CONNECT BATTERY NEGATIVE TERMINAL Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)...


1_9_2012_9_36_14_am.gif

Jan 09, 2012 | 2004 Toyota Corolla

1 Answer

Does a starter come out the top of a 2000 infinity q45??? or the bottom????


bottom, but the manual mentions a couple different procedures. See below.

4.1L Engine
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove or disconnect the following:

    Negative battery cable Steering gear and linkage assembly Harness connector Starter retainers Starter

To install:
Install or connect the following:

Starter Starter retainers. Tighten the starter retainers to 30-37 ft. lbs. (40-50 Nm). Harness connector Steering gear and linkage assembly Negative battery cable
Alternate procedure:

  1. Remove or disconnect the following:

    Negative battery cable Engine undercover Harness connectors Starter motor mounting bolt and nut
  2. Remove engine mounting insulator bottom nuts, and lift engine approximately 2 inches with a transmission jack
  3. Remove starter motor

To install:
  1. Installation is in reverse order of removal; observe torque values shown in diagram


jturcotte_2457.gif

Fig. Starter motor mounting and torque specifications-Q45 & 2004 M45

Oct 31, 2011 | 1997 Infiniti.5 Q45

3 Answers

I AM TRYING TO REPLACE MY STARTER ON A 1997 CHEV LUMINA 3.1 V6. I NEED A DIAGRAM OF THE STARTER


Hello Larry...Here are the steps to take. Detach the ground (black) battery cable. Lift the front of your vehicle with a floor jack, support it with jack stands and chock the rear wheels.
Unfasten the retaining nuts holding the heavy (battery) cable and the thin wire to the back of the starter solenoid (the small cylinder mounted on top of the starter motor) with a wrench. Move the heavy and thin wires out of the way.
Loosen the two mounting bolts holding the starter motor to the engine block with a ratchet, large ratchet extension and socket. Hold the motor assembly with one hand and finish removing the two starter mounting bolts. Make a note of the position of each mounting bolt, since they are of different sizes, and of any shims located between the starter motor, mounting bolts and engine block.
Remove the starter motor from the vehicle

To Install:
Position the new starter motor in place with one hand and install the two mounting bolts finger tight with your free hand, along with any shims installed with the original starter. Failing to replace the shims may cause the starter to grind against the flywheel or engage and fail to start the engine

Tighten the two mounting bolts with the ratchet, extension & socket.
Install the heavy cable and wire in their respective mounting studs at the back of the starter solenoid and install the retaining nuts finger tight. Tighten the nuts with the wrench; (careful not to overtighten)
Lower your vehicle off the jack stands...Attach the ground (black) battery cable.

There you have it, included is a picture of the starter, good luck, i hope this helps.

http://www.autopartswarehouse.com/sku/Replacement/Starter/REPB320102.html?tlc=Engine+%26+Drivetrain

Jul 29, 2011 | 1997 Chevrolet Lumina

1 Answer

I need to remove the starter on my 2001 saturn 1.9 litter engine? i need to find a diagram on how to do it?


disconnect the battery lead from the starter plus any other wires,undo the bolts on the starter motor flange & the starter should pull straight out providing there is nothing in the way if there is it will have to be removed first.....hope this helps.....cheers

Aug 02, 2010 | 2001 Saturn SC

1 Answer

Do you have a diagram of the engine of the 2002 Kia Spectra because I need to replace the starter


You don't need a diagram.Lift the car disconnect the battery and the wires to the starter solenoid remove the starter bolts and check the shims placement.Replacement starter is reverse to what is listed in removal

Sep 28, 2009 | 2002 Kia Spectra

3 Answers

How to replace the starter for a 95 buick lesabre


Be sure to disconnect the battery first. There are HOT wires connected to the starter. Disconnect three wires and two mounting bolts. It can be difficult to reach a wrench in there.

The new starter will come with shims, thin strips of metal. These are for getting the right distance between the starter gear and the flywheel. Hopefully you won't need them. But if the new starter is noisy when mounted, shim it some.

Jun 02, 2009 | 1995 Buick LeSabre

1 Answer

Need to remove and replace starter, would like to be able to see a diagram


Your best diagram is the starter itself...make notes on where wires are attached and what you removed from where. Always remove the positive cable from battery before you begin and never allow wires on one starter terminal to touch ones from adjacent terminal when you replace them.
Remember...your starter turns the engine so it can start...it does not start your engine. Always have your battery charged and load tested to avoid changing the starter because the battery is bad.

Mar 14, 2009 | 1989 Buick Park Avenue

Not finding what you are looking for?
1990 Isuzu Trooper Logo

Related Topics:

459 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...