Question about 2000 Ford Focus

1 Answer

I need the spark plug diagram for a 2000 ford focus

I mistakenly taken of all the wires at one time

Posted by on

  • Anonymous Apr 11, 2009

    which wires go where?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 303 Answers

It should say on the coil what cylinders the wires go to. How many cylinders 4 or 6? If it's a 4 it runs left to right 1-2-3-4 if it is a six look at the valve covers they are not even.the one that is closer to the belt is # 1 cylinder and it runs 1-2-3 on one side and 4-5-6 on the other i hope this helps you

Posted on Nov 21, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 ford focus cranks wont start has fule and compression

Check for spark. Remove a spark plug and attach the wire back on, then hold the plug against the engine block and have someone crank the engine. Watch for a spark.

Apr 12, 2013 | 2000 Ford Focus

1 Answer

How do i replace my sparkplugs

if not mistaken you have a four cylinder truck with 8 spark plugs, if so. You will either need a monkey to help you, or have lots of patience and several sizes of spark plug sockets and extensions, but it is possible , it has taken me a little over two hr to do it.

Apr 07, 2012 | 2000 Ford Ranger SuperCab

2 Answers

I need ignition coil diagram ford focus 2000 LX (connections back 4321)

you have a single 3 or 4 pin connector to the coil pack. Someimes the wires get corroded and break off at the connector. Ford has a pigtail kit to fix that issue. Usually a misfire with the check engine light on.

Green/bluestripe is from ignition switch

Black/green stripe is to PCM (computer)

Black/orange stripe is to PCM

These last 2 wires are what the PCM uses to fire the spark plugs 2 at a time.

May 22, 2011 | 2000 Ford Focus

2 Answers

What would cause the spark plugs to bend in a 2000 ford focus

if its from the bottom the timing belt has slipped and made contact with the plugs

Jan 20, 2011 | 2000 Ford Focus

1 Answer

I think the spark plug wires may be mied up on my

2000 Ford Windstar 3.0 liter V-6 VIN "U"


2000 Ford Windstar 3.8 liter V-6 VIN "4"


Hope this help.

May 05, 2010 | 2000 Ford Windstar

2 Answers

No spark on one cylinder on a 2000 ford focus 2.0

The coil fires two plugs at one time, so if the other plug is fireing also the problem maybe a wire or plug. Or possible bad coil if fire is weak on one side. Common problem.

Dec 29, 2009 | 2000 Ford Focus

1 Answer

I have a 2000 ford focus and it just shut down as I was driving and wont restart. How do I determine if it was a timing belt? Or where do I start diagnosing the problem??

check for spark at spark plug first. remove a plug and leave the wire on, hold it against block. crank engine & see if plug sparks. also, listen for air pressure in spark plug hole. report back.

Oct 03, 2009 | 2000 Ford Focus

1 Answer

I need a diagram of an ford focus timing chain and cambelt for x reg 2000 i am tranferring a timing chain and a timing belt and diesel pump from one engine to another. im not sure how to get the engine to...

TDC has marks on the pulleys and engine block to line up, best bet is to get a haynes manual to show you exactly where. Too complacated to explain where they are on this

Sep 03, 2009 | 2000 Ford Focus

2 Answers

One of the four plugs is not firing. Spark plug

replace the coil pack for that plug that is not firing

Aug 05, 2009 | 2000 Ford Focus

1 Answer

Spark Plug Wires -- 2000 Ford Focus ZX3?

two options just pull them straight up or they make a special tool that you can buy to do this. if you are going to replace plugs you should go ahead and do the wires at the same time.

Jun 20, 2009 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

431 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides