Question about 2001 Volkswagen Passat

1 Answer

Location of cam position sensor 2001 passat 1.8 turbo

I had my car on a diog. machine to troubleshoot

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 67 Answers

In under top half off timing cover under cam gear

Posted on Nov 30, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What years was the White 1477 made


The White 1477 is a sewing machine. (although posted among cars & trucks). I have not found its date of manufacture. There is a picture of it: http://www.doubleveil.net/zssmp/eyecandy.htm


Possibly you can find the date of the machine by contacting the below with a query.


For White/Viking Sewing machines:
31000 Viking Parkway
Westlake, OH 44145
440-808-6550
440-847-0001 (fax)
800-446-2333

http://ismacs.net/white/white-sewing-machine-company-history.html

Jun 11, 2017 | Cars & Trucks

1 Answer

Abs light on went to auto elect diog right hand front brake caliper is it sensor or caliper


Dear Brian,
It is highly unlikely the caliper, as I know of no car with the electronics telling you of a defective caliper, yet.
It could be a sensor, however, I have replaces several sensors with brand new parts and the light does not turn off.
You might try a computer reset first, before replacing the sensor.
God bless our efforts.

Feb 17, 2017 | Cars & Trucks

1 Answer

Daewoo sewing machines


Problem with Cars & Trucks Daewoo sewing machines

put machine in the trunk of CAR and drive. be happy

Oct 16, 2013 | Cars & Trucks

1 Answer

Bosch ACS601 ac machine


check the inline filter in the cars system

Aug 14, 2012 | Cars & Trucks

1 Answer

Red alarm light takes a while to go out, then come's on again for a short spell after driving for a few minutes. Oil level is full. The car is a 1988 mitsubishi galant, 1600 manual.


MEP sencer is throwing a warning code. Find the sevice plug in you need to cross diog and ground to kick the codes for the computer. once the codes are kicked watch the light for blincks. and count the flashes. sample !!! !!!! !!! 343 ok?

Dec 06, 2009 | 1988 Mitsubishi Galant

1 Answer

Gas gage flips back and forth and low fuel light flashes


sounds like you have a bad fuel gauge sending unit common problem it is located inside the the fuel tank with the fuel pump Auto Zone should be able to pull codes to verify this it should say you have a bad fuel level sensor code

Jun 05, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

Vehicle turned off, cant restart.


This is a shot in the dark, and I use it a lot, but the ONLY think I can think of that may be happening is that it has gone into security mode. At least it does not cost anything to try! Put the key in the driver door and lock and unlock it 5 times, then try to start it. It works on MOST cars in security lock down.

Dec 22, 2008 | 2003 Dodge Grand Caravan AWD

1 Answer

Oldsmoble 1994 will not always start


there are two likley probs. the ignition module or the crank shaft posistion sensor. both of these are very prone to failure. it is very hard for the shop to diog the prob when it does not act up in the garage. good luck also if you can check your fuel pressure when it wont start. if no pressure your prob lies there. the pump probley the problem. the hotter they get the harder it is to start the pump.

Nov 09, 2008 | 1994 Oldsmobile Ninety Eight

Not finding what you are looking for?
2001 Volkswagen Passat Logo

Related Topics:

474 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...