Question about 2002 Toyota Sienna

1 Answer

DOME AND DASHBOARD LIGHT BULB REPLACEMENT

How do i replace the drivers dome light bulb on a 2002 sienna?

How do i replace the dash lights on the same vehicle - it's on the speedometer l

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Just have your star screu driver take off the speedometer cover take out the speedometer and replace bulb. and also take out the door mat and replace bulb.

Posted on Nov 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i find a dome wiring diagram for a 1998 chevy cavalier ?


Do your dash lights work? Check the dash light switch to see if it rotates to control the dome light, it may be turned off completely or the dome light ground wire may be loose. If not the wiring will run from the back of the fuse block through the body post to the dome light Good Luck

Jul 27, 2014 | 1998 Chevrolet Cavalier

1 Answer

How do I remove dome light


Not sure what type car you have but most dome light covers will just pop off with a small flat head screw Driver. Then take the bulb to your local auto pats store . They will help you with the right type bulb

Nov 07, 2012 | Cars & Trucks

1 Answer

Replacig a light bulb for a dome in 2001 dodgegrandcaravan


Remove the screw holding the dome light cover in place by turning it counterclockwise with a screwdriver....Remove the old bulb by twisting it slightly to the left and pulling it straight out. Dome light bulbs can be fragile, so be careful not to break the bulb with your fingers...Slip the replacement bulb back into place by pushing it in and twisting it slightly to the right...Replace the cover. I hope this helps, thank you for using FixYa!

Jul 02, 2011 | 2001 Dodge Grand Caravan

2 Answers

How to replace interior dome light bulb?


1) Remove the key from the ignition. Make sure the doors are closed, so the new bulb does not illuminate when you are installing it.

2) Make sure the dome light switch is turned to the "Off" position. Pry the plastic lens away from the dome light. Use a small, flat-head screwdriver.

3) Push back the side bulb clamp. Pull out the old dome lightbulb. Wipe the area with a paper towel if it is dirty.

4) Wrap the new bulb in a paper towel (oil from your skin will shorten its life). Insert it into the dome lightbulb holder. Push it up gently to secure it.

5) Turn the switch to "On" to test the bulb. Reposition the cover and push up to lock the clips into place.

If the bulb doesn't work, you've got a bad switch somewhere, probably on the drivers door.

Dec 26, 2010 | 2006 Toyota Highlander

1 Answer

Have a 04 super cab ranger tremor and when i turn the dome light and the door ajar light comes on how can i fix that


turn off the dome light.


the door opens, it turns on the dome light, so the wire that goes from the door switch gets powered up and makes your dome light come on. if your door is closed, and you turn on the dome light, the same wire gets power and is actually sending power to your light bulb on the dash.
just ignore it , or get a diode and put it on the correct wire, and it wont allow the electricity to flow back towards the light bulb when you put the dome light on.

Jul 31, 2010 | 2004 Ford Ranger

1 Answer

How do I replace the dome light bulb in my sienna van? the housing does not pop out..


It's easy - the plastic covers will pop off if you gently use a screw driver to pry the three points of contact on each cover. There are 2 posts in the middle going into the outside edge, and one clip at the end. The covers come off and you can easily replace the bulbs - forget about opening the garage door oopener and removing the screws - that won't work (I tried!).

Dec 05, 2009 | 2002 Toyota Sienna

1 Answer

My license plate lights are out...what kind of bulbs do i need??


Check this reference guide...

2002 Hyundai Accent Car Lightbulb Size Guide
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 2357A
Front Turn Signal Light Bulb Size: 2357A
Rear Turn Signal Light Bulb Size: 1156
Tail Light Bulb Size: 1157
Stop Light Bulb Size: 1157
High Mount Stop Light Bulb Size: 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 1156
Front Side Marker Light Bulb Size: 2357A
Rear Sidemarker Light Bulb Size: 168
Map Light Bulb Size: DE3175
Dome Light Bulb Size: DE3175
Step/Courtesy Light Bulb Size: DE3022
Trunk/Cargo Area Light Bulb Size: DE3022

From Sylvania Lamp Replacement Guide
License plate
168
168LL Long Life Upgrade: Up to twice the life of the standard lamp.


I hope help you with this. Good luck (remember rated this help).


Sep 09, 2009 | 2002 Hyundai Accent

1 Answer

Dome light


The wire that runs to the dome light runs along the carpet retainer on the floor of the driver door opening. It then runs up the "B" pillar and over to the dome light.
Have you checked the bulb and the presence of voltage and ground at the dome light socket?
I would start there first before tearing anything apart and make sure all is good.
Let me know.
Regards,

Aug 27, 2009 | 1983 Chevrolet Silverado

Not finding what you are looking for?
2002 Toyota Sienna Logo

1,293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...