Question about 1994 Oldsmobile Cutlass Supreme

1 Answer

How to prime injector port to get car home need fuel pump

1994 cutlas supreme I believe needs fuel pump where would I prime the injector port to start car and get it home. The engine has massive covering over the normal carborator location.

Posted by on

  • terrancebens Nov 23, 2008

    Thanks for the tip I was able to get the vehicle home.

  • jesse777 May 11, 2010

    If the fuel pump is not working you cannot drive the car. You could prime it to start the engine briefly, but all this would prove is lack of fuel pressure or injector pulse.

    Have you checked for spark?

    A bad fuel pump can occassionally be (temporarily) brought back to life by banging on the bottom of the gas tank USING A BLOCK OF WOOD OR RUBBER HAMMER>>NO SPARKS!!!



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Oldsmobile Expert
  • 293 Answers

Sometimes you can get lucky and have someone rap on the bottom of the fuel tank when you are crankig the engine and it will start if it starts don't shut it off this is only tempoary you will need to replace the pump

Posted on Nov 20, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the cumputor located on the 91 olds cutlas

Should be on the passenger side of the engine compartment.
You would need to check for spark at the plugs and fuel pressure before looking at the computer.

Oct 09, 2012 | 1994 Oldsmobile Cutlass Supreme

2 Answers

My 92 cutlass supreme wont stay started whats wrong with it

Most of the time when it starts for 1-5 seconds then dies, its a failing of the antitheft system. Read about it thru this link. Some possible solutions too.

May 20, 2011 | 1992 Oldsmobile Cutlass Supreme

1 Answer

1994 cutlass supreme..fuel pump wont turn on/prime

Check/replace the fuse pump relay.

Replace fuel filter.

Check for 12V at the pump power wire.

A poor condition fuel pump will have more problem pumping fuel when the fuel level is below 1/3 of a tank.

Apr 24, 2010 | 1994 Oldsmobile Cutlass Supreme

1 Answer

1994 Chevy Astro 4.3L Vortec will not start. Has new fuel pump, filter and completely rebuilt distributer. Has spark and fuel but will not start even with Starting fluid. Any ideas?

yep!!! the main port injector is either stuck!! or its screen is topped up!! its under the top plenum assembly in the center of the intake valley

Jan 17, 2010 | 1994 Oldsmobile Cutlass Supreme

2 Answers

Engine will Turnover but it will not fire up

To check injector pulse, you need 2 people. One is to crank the engine. The other is to watch the voltmeter connecting to the plug delivering the electrical signal to an injector. If during a period of cranking, there is no voltage displayed that means there is no injector pulse. Here is an image of connector port going into the injector to open its valve as needed.d63fc52.jpg

Aug 13, 2009 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

1994 s-10 2.2l Filling with fuel

you have one or more injectors dumping very common with the 2.2

May 08, 2009 | 1994 Chevrolet S-10

1 Answer

Need to get car started to get it home

sometimes you can get lucky if you have someone rap on the bottom of the gas tank while cranking it may jar the fuel pump to get it started have done this in the past but is only temporary

Nov 20, 2008 | 1994 Oldsmobile Cutlass

1 Answer

1994 olds cutlas supreme 3.1

First thing to check is the fuel pressure. The port to do this is on the top of the engine, it looks like a tire valve stem, but metal, you may be able to borrow a tester from Kragen or another parts store like it, they loan tools, no charge, pressure at idle should be around 40 PSI

Sep 19, 2008 | 1994 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1994 Oldsmobile Cutlass Supreme Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides