Question about 2000 Chevrolet Corvette

1 Answer

Chevrolet corvette 2000,5.7L

The fan cant not run in high speed

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Change fan control switch on heater control panel has short

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The controles for the heater or a/c do not work. blower fan runs on high all the time


if the problem is the fan only runs on high no matter were the fan control switch is then this sounds like the blower motor resistor is the problem.

Jun 22, 2011 | 1989 Chevrolet Corvette

1 Answer

My 96 corvette runs hot,fan wont kick on,i have to turn on air and fans\r\ncome on,i replaced 3fan relays ,thermostat,coolant sensor,temp,switch


Recently had a camaro with the same issue.What I found was the fan itself causing the issue. It was creating so much resistance at the fan motor that the only time it would function is if it was forced to hi-speed by turning the air on. The different speeds hi-lo operate at different voltages. Would check this out and let me know me know if this helps.

Jun 22, 2011 | 1996 Chevrolet Corvette

2 Answers

I have an 85 corvette. the problem is the air conditioning. I have it on high speed but the air blows out very little like if its on low speed. and the compressor and evaporator is new so what could it be...


If your car has a cabin filter (check owners/service manual) it may be clogged.

You may also have a vacuum leak under the dash causing the vent flaps to not open all the way.

Jun 09, 2011 | 1985 Chevrolet Corvette

2 Answers

Cooling fan only comes on when engine starts to over heat .


Does it have an adjustable fan on it where you can set the temp that you want it to come on? The reason I ask is some people put them on there and if you buy it used later on this is a detail that often gets left out. check it for a control. If that not it it could be a thermostat sticking or a bad temp sending unit. Radiator may need to be cleaned and cored

Sep 19, 2010 | 1985 Chevrolet Corvette

1 Answer

1998 corvette cold air blows out driver side warm air out pass side cant change driver side also fan one speed


you need to replace the temperature actuator on the left side of heater evaporator case, also ck the blower resistor and connection that should fix ya up.

Nov 04, 2009 | 1998 Chevrolet Corvette

1 Answer

1976 corvette cooling fan vibrates


Check to ensure that all the bolts holding the fan to the water pump are equally tight.

May 31, 2009 | 1972 Chevrolet Corvette

1 Answer

Fan works on high only


Check your blower motor fan speed control switch. They go bad frequently. You could have checked the resistor by jumping the wires to the different terminals to be sure the resistor was good. That pretty much just leaves you will the fan speed control switch. Good luck.

Feb 24, 2009 | 1986 Chevrolet Corvette

Not finding what you are looking for?
2000 Chevrolet Corvette Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...