Question about 2000 Ford Expedition

1 Answer

2000 ford expedition

Hi i have a 2000 expedition and the heat will not work i just flushed the system yesterday and it still not hot but the air does work.. plz help thx

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 373 Answers

The heater on your Vehicle it can be a few problems.
I will mention the Importants.

First. Check the temperature, The temperature has to be At least 140 Farenheit.
Second. With a Temperature gace check the temperature of the 2 small hoses going to the Heater core. If the Temperature is almost the same on each of the small hoses, and Close to the temperature of the engine. The circulation is good.
But if only One of the hoses are Hot and the Other no. Is because is there a restriction in the Heater core, and will be nesesary to clean or replace.

Third.. Check the Blend door actuator motor. ( Is the actuator to move from cool to hot air )
Is located at center of the Instrument panel. at lower of the Hvac housing.
Is there behind the Center console.

Ok... Check the step I giving and letme know.
Thank you for use fixya...

Posted on Nov 20, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rear heat not working in 1999 ford expedition. the blend door is operating, is it a good idea to back flush rear heater core ? only one hose getting hot!

It won't hurt to backflush it, but be sure to isolate it from the rest of the system to prevent flushing the blockage somewhere else upstream. Don't be supprised if it won't flush out and you have to replace the core.

Feb 17, 2013 | 1998 Ford Expedition

1 Answer

2000 expedition with auto climate control no heat in front or back heater

check to be sure you don't have air trapped in the system. If engine temp is normal, then heater water valve may not be working (if it has one) or temp control on heater control head is not working for blend door.
If trapped air, have a shop with evac/fill equipment, flush & fill system to purge air.

Jan 11, 2011 | 2000 Ford Expedition

1 Answer

Heater was not heating properly, it would just get warn but not hot. I flushed the system and replaced the thermostat but now it doesn't blow any warm air at all. Its nothing but cold air, Help please!!

make sure your coolent is filled may have air in system after checking coolent repost if your still haveing problems will be happy to give you more ideas if you need them please check box below if this was helpful.

Nov 28, 2010 | 2000 Ford Expedition

1 Answer

Have some heat in 2000 ford expidition but not

have your heater core pressure checked. it maybe clooged even though you had system flushed. additionally did you buy the correct thermostat? the computer is a sensitive thing and alot of other components are activated because of the temperature. the opening temp is 188-195 degrees. so you should have bought the 185 degree thermostat. i had same problem and bought the higher temp thermostat. i couldn't believe that such a small change would make a big difference. good luck.

Jan 26, 2010 | 2000 Ford Expedition

2 Answers

I have no heat in my 2000 expedition. I have

check thermostat and both heater hoses

Jan 02, 2010 | 2000 Ford Expedition

1 Answer

1999 ford expedition,interior heat not working properly

have you checked the thernostat. sometimes it gets stuck in the open position and that will make your car run cool

Dec 08, 2008 | 2000 Ford Expedition

3 Answers

My heat in my truck doesnt work

the blendoor on the heater box maybe broken ck lines going to heater core and make sure they are hot. does the heat temp change at all from cold to hot?

Dec 05, 2008 | 2001 Ford Expedition

Not finding what you are looking for?
2000 Ford Expedition Logo

380 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides