Want user manual for scantronic 9827 burglar alarm

It's kind of mix problems , there is two kind of alarms
1...one for burglars alarms if someone try to break window and unlock from Inside lock
2....alarms for car finder on key fob

The most common sensor that goes bad is the hood (bonnet) switch. Open the hood and look to the left of the microfilter housing. Circled in red is the switch (looks like a button). Unplug it and see if it solves your problem. You can leave it unplugged with no adverse affects.

That's not something that we would post in a public forum or anywhere else for that matter.

Your Sonata is equipped with a "Keyless Entry & Burglar Alarm" system. When the Burglar Alarm is activated, it KILLS the starting system through the used of a relay called the "Burglar Alarm Relay". This mode prevents engine starting with the key.
Solution #1
Disarm the system with the Keyless Remote (key fob) If you don't have this remote (or its battery is dead) replace the battery & try disarming again.
Solution #2
Enter the vehicle & insert the key in the ignition and turn the ignition switch to 'RUN'. Wait 3 to 5 minutes until the alarm stops. You should then be able to start the engine.

Have a qualified/certified Hyundai Service Technician properly diagnose this issue.

The 'Keyless Entry & Burglar Alarm System" is activated. You must 'Disarm' the system using the Keyless Entry Remove (Key Fob) to "Reset" the system. The reason the engine won't start is due to the burglar alarm - it has a "Starter Kill" circuit which is activated when the alarm is activated. The alarm must be DEactivated to DEactivate the 'Starter Kill' circuit.
Another way to start the engine is to get in the car, put the key in the ignition and turn it to 'ON" and wait 3 to 5 minutes until the emergency flashers stop/turn off. Afterward, you should be able to start the engine. NOTE: This does NOT reset the burglar alarm. It will go off again when you enter the vehicle without using the remote/key fob.

First of all, has the burglar alarm been activated? If so, you can enter the vehicle with the key, put the key in the ignition and turn it to 'RUN' or 'ON" and then wait 3 to 5 minutes for the burglar alarm to stop. You should then be able to start the engine. You still need to have a qualified/certified Hyundai Service Technician properly diagnose the problem with the remote (Keyless Entry & Alarm System).

I BELIEVE that it's a double press on the lock button for this model. This is what I'm being told, but I have no evidence to back that up. Give it a try!

The OE alarm is part of the ETACS
To disable it:
1) Sound the alarm
2) Put the key in the ignition and turn to start
3) Hold there until the alarm turns off
You should now be able to start the vehicle. The alarm will remain dis-armed until armed through RKE

Apparently the "LOCK" function is working normally because the burglar alarm is being activated when you 'lock' the car. Is this right?
The fact the engine won't start when the burglar alarm is activated is NORMAL If the doors will not UNLOCK front the driver's door manual switch, I believe you have a bad DOOR UNLOCK relay in the control module.

Here's a whole page about the alarm on the MKIII VW (1993-1999)
If you scroll down there's a link for bypassing your alarm.

http://faculty.ccp.edu/faculty/dreed/Campingart/jettatech/alarmcentralhelp/alarmhelp2.htm

Hope this helps!
Please rate/vote for me!
Thanks!