Question about 1998 Chevrolet S-10 Pickup

1 Answer

98 s-10 2.2 liter wont crank

Had trouble with it not starting right , i really had to stand on the clutch to get it to crank ,turn the key and all the lights come on the dash but it wont crank.where is the safety switch located ,someone told me that was the problem

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 68 Answers

It is located by the spare tire and on the side hope that helps

Posted on Nov 19, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

It turns over but it wont start


Engine cranks but won't start. Troubleshooting tips

www.samarins.com/diagnose/index2.html
In this guide, we are going to look into no-start problems when the car engine cranks,but won't start. If your engine won't crank at all, check the first part No-start: ...‎Why a car won't start - ‎Crankshaft position sensor - ‎Check Engine light

Engine cranks but won't start - YouTube

? 8:03
https://www.youtube.com/watch?v=1L4nB2NdA0U
May 16, 2014 - Uploaded by jimthecarguy
2003 Ford Taurus 3.0 liter 24 valve no start cranks OK.You will not ... Car will not start trouble shooting guide, wont crank, wont turn over, etc.

Problem 5: Engine Cranks But won't Start



Jan 01, 2016 | Cars & Trucks

1 Answer

Red light came on under the right turn signal, and now it won't start


the operators guide is free, and shows the meaning of all lights.
wont crank or does and wont start.
check all fuses in cab end engine bay first
if its a no crank?, wiggle the shift stick, A/T
or wiggle clutch held down if M/T
RTM !
http://justgivemethedamnmanual.com/honda/honda-cr-v-owners-manuals/

page. 65, see page 65?
easy huh? door open indicator is said
and say go to page 70 , so.....
im not sure, but may be they dont want the car started, with doors open?

page 85
When you turn the ignition switch to
ON (II), the Immobilizer System
indicator should come on for a few
seconds, then go out. If the indicator
starts to blink, it means the system
does not recognize the coding of the
key. Turn the ignition switch to
LOCK (0), remove the key, reinsert
it, and turn the switch to ON (II)
again.

so is the IMMO killing starts.?
no?
then page 200, shows how to start, the car.
if you cant crank, say so, if it cranks but wont start
is the IMMO blinking
is the CEL on key on? no started , in not there is a fuse blown.

Sep 28, 2013 | 2003 Honda CR-V

1 Answer

2004 nissan frontier cylinder wont crank over sometimes


First thing to check would be the starter solenoid-mounted on the starter. In the starting circuit, that is the most high use/high wear item. A tech would wait for the no start condition, then check the solenoid wire for power when key is held in the cranking position. If power is there, it indicates a faulty solenoid. If no power, trace the signal back to the ignition switch-from solenoid to starter relay to clutch switch to ignition switch.
There are contact points (plates, really) inside the solenoid that become pitted and burned from use, and eventually wear down or out.

Nov 22, 2012 | 2004 Nissan Frontier

1 Answer

Have a 04 excursion 6.0L diesel. have been driving it with no problems then after a rain storm it will not start. Batteries are fine, no fuses blown, but won't crank. Ideas?


When say wont crank..Do you mean it will turn over but not start,,or do you mean it wont even turn over..I work on 6.0 liters all the time,,and you really need a scanner to see if your FICM has gone bad or other electronics...Plus your high pressure oil pump could have went out..They dont really give you much warning on them engines when something goes out..

Sep 17, 2011 | 2004 Ford Excursion

1 Answer

Turn ignition key and motor starts up, next day turn ignition key and motor just turns over and wont start. could it be anti theft problem its a 2002 f150 4 wheel drive with 4.6 liter


This could be caused by either a faulty Crank Shaft Position Sensor or the anti-theft system. Try put key in, turn to ON position for EXACTLY 10 minutes, As SOON as anti-theft light shuts off or stops flashing, then IMMEDIATELY start the engine.

Jan 13, 2010 | 2002 Ford F150 Regular Cab

2 Answers

1999 ford contour that wont crank


You mean wont CRANK or CRANKS but WONT RUN???? 4 cyl or V6 auto or manual trans????????? The 8th VIN digit would be most helpful as there are 4 different engines for that car. Its really cheaper to check items before you replace them. The starter should have a smaller BLACK wire that should have power on it when trying to crank the car. You say it wont crank, then check the neutral switch on the trans. Try putting it in neutral to start it. If it has a manual trans, the clutch switch on the pedal may be bad. There is a starter relay in the fuse box under the hood that powers the starter, does it click if you turn the key to start? if it does then the relay is at least trying to work, but doenst mean the contacts inside are good, If it does not click, then the neutral switch may be bad.Check the BLACK/YELLOW wire at the trans switch, if it has power on it, the switch may be bad, ground that (Black/Yellow)wire and see if it cranks. I dont know if there are any other relays in the fuse box that you can swap for the starter relay for test purposes.

Dec 14, 2009 | 1999 Ford Contour

1 Answer

Trouble starting & stalls when coasting


for starter problem check wire connection at starter,theres a single plug in wire that forms some corrosion clean it and it should work fine after.for other problem is check engine light on or came on,does it idle ok?

Jun 22, 2009 | 1993 Toyota Tercel

1 Answer

Car wont start up right away


Crank or cam sensor probably as plugs bad plugs would start but miss the sensor will either give a start or no start condition and on 1 truck the crank sensor went out and it would run cold but miss like crazy when warm,I work in a chyrsler shop and have never seen that happen and even a scan tool didn't pick it up.

Mar 09, 2009 | 1998 Jeep Cherokee

2 Answers

Turn the key on and the starter will not engage.


check fuel pressure.if not above recomended spec. replace fuel pump. for starting have solenoid 0n starter checked.

Jan 26, 2009 | 1994 Cadillac Fleetwood

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...