Question about 2001 Jaguar XJ8

1 Answer

Knock sensor location

Where is the knock sensor 2 bank 2 on a 2001 jaguar xj 8?
Thanks for the help.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 2 Answers

It's under the intake manifold. To access it you have to remove the manifold and injection rail.

Posted on Dec 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need info on knock sensor for Acura 3.5rl 2002.code p0330 bank 2. Location?


the knock sensor is located on a v 6 engine in the valley at no 5 piston position
there is another sensor directly opposite on bank 1 at no 2 piston position
for general information if your engine is not v 6 on a 4 cyl they are at no 1 and between 3 and 4 cylinders on the inlet manifold side and on a v 8 engine they are between 2-4 and 6-8 exhaust side and between 1-3 and 5-7 on the exhaust side

Aug 08, 2015 | Acura Cars & Trucks

1 Answer

Where is my knock sensor bank 2 located at on my jaguar x-type? (2002, 2.5 cylinder v6)


There are two knock sensors located on top of the Engine, approximately in the middle of the 4 cylinders at each bank.
To get access to the sensors the black plastic engine cover with the "Jaguar V8" imprinted on has to be removed.

There are two types of knock sensors.
The "old" ones that are of a "screw-in barrel type" and the newer ones that are just bolted on.

I describe the replacement of the bolt-on type knock sensor on Bank 2 in the following documentation on a 1999 XJ8 AJ27 engine.

Be careful!
Knock sensors are piezo electric devices that are very sensitive! If dropped, over-torqued or struck they will probably be destroyed.
As knock sensors are sensitive to a sudden temperature change they are also easily fractured by steam blasting a hot engine.
So handle the knock sensors with great care and let the engine always cool before fitting a new sensor!

Feb 20, 2012 | 2002 Jaguar X-Type

1 Answer

How do you change a knock sensors on my 2001 gmc 1500hd


Changing knock sensors on 2001 GMC 1500hd
1. Remove the intake manifold.
2. There are 2 sensors located on a plate under the intake manifold. These are the knock sensors.
3. Remove the wiring harness assembly from the knock sensor.
4. Install the new rear bank knock sensor and tighten to 15 lb ft.

If you find that this is information was helpfulto you, please rate me and leave a comment as this will encourage me to do morefree work for you and others. And please let me know if there's anything else Icould help you with. Without any inputswe cannot proceed assisting... Thank you for using FIXYA! Best regards,
Junior

Sep 14, 2011 | 2001 GMC Sierra 1500HD

1 Answer

Where are knock sensors located on my 2001 Buick LeSabre 3.8L engine


bank #1 knock sensor on lower front of engine block near starter, bank #2 knock sensor on lower rear of engine block next to oil filter.

Jan 15, 2011 | 2001 Buick LeSabre

4 Answers

Where is knock sensor located on 2001 silverado 6000 engine


Under the intake manifold. Make sure you get the harness for the knock sensors. and clean out all of the rust and junk you're going to find donw in the holes before and after you replace the sensors.

Nov 01, 2009 | 2005 Chevrolet Silverado

2 Answers

Knock sensor bank 2 sensor were is located? I can't find it, please help me locate the knock sensor ?


V6 or V8? On 4.8, 5.3 and 6.0 it is under the intake. You have to remove the intake manifold.

Sep 07, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Knock sensor location


bank one is the driver side 2 is on passenger side

Aug 27, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

How do you find and replace a 1rst bank knock sensor on a xk8


13mm socket in between intake tubes on right side of motor(pass side) very easy.

Mar 07, 2009 | 2001 Jaguar XK-Series

1 Answer

01 olds aurora


bank 1 sensor 1 will be in exhaust manifold by firewall in the middle. bank 1 sensor 2 will be behind convertor .bank 2 sensor 1 will be in the front manifold down at the end of it

Aug 20, 2008 | 2001 Oldsmobile Aurora

Not finding what you are looking for?
2001 Jaguar XJ8 Logo

1,432 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...