Question about 1989 Lincoln Town Car

1 Answer

Location of the oil pump

5.0 Liter Engine

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

The oil pump is inside the oil pan on the bottom of the engine

Posted on Nov 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of Crankshaft sensor on 2005 Dodge Caravan SE: 2.4 Liter. Is crankshaft sensor location the same as 3.3 Liter?


The crankshaft position sensor mounts to the engine block behind the alternator near the oil filter.

Jul 12, 2014 | 2005 Dodge Grand Caravan

1 Answer

Adding to my question about the correct location of the oil pressure switch. The car is a 2002 Hundai Accent GL. I need a PICTURE OR DIAGRAM of the location on the engine to make sure I'm working


location of oil pressure sensor on 02 hyundai accent gl with a 1.6 liter engine is driver side front of engine. lower near the bottom of the radiator.mind you that is for a 1.6 l

Apr 18, 2013 | Hyundai Accent Cars & Trucks

2 Answers

What is the plug wire diagram for a 2000 chevy lumina?


2000 Chevrolet Lumina 3.1 liter V-6 VIN "J"

zjlimited_276.gif


Hope helps.

Mar 29, 2011 | Chevrolet Lumina Cars & Trucks

1 Answer

How long and easy is it to rebuild oil pump on 94 grand caravan 3.8l


Don't bother. Replace the unit.
3.0 liter
The oil pump assembly used on this engine is mounted at the front of the crankshaft. The oil pump also retains the crankshaft front oil seal.
  1. Remove the accessory drive belts.
  2. Remove the timing belt cover and timing belt. Refer to the timing belt removal and installation procedures in this section.
  3. Remove the crankshaft sprocket.
  4. Remove the oil pump mounting bolts (5), and remove oil pump assembly. Mark mounting bolts for proper installation during reassembly.

To install:
  1. Clean the oil pump and engine block gasket surfaces thoroughly.
  2. Position a new gasket on pump assembly and install on cylinder block. Make sure correct length bolts are in proper locations and tighten all bolts to 10 ft. lbs. (14 Nm).
  3. Install the crankshaft sprocket and timing belt. Recheck engine timing marks.
  4. Install the timing belt covers. For more details, refer to the timing belt cover installation procedures.
  5. Install the accessory drive belts.
  6. Refill the crankcase and start the engine.
  7. Check for correct engine oil pressure and for any oil leakage.
3.3 and 3.8 liter engines


  1. Disconnect the negative battery cable. Remove the dipstick.
  2. Raise the vehicle and support safely. Drain the oil and remove the oil pan.
  3. Remove the oil pickup.
  4. Remove the chain case cover.
  5. Disassemble the oil pump as required.

To install:
  1. Assemble the pump. Tighten the cover screws to 10 ft. lbs. (14 Nm).
  2. Prime the oil pump by filling the rotor cavity with fresh oil and turning the rotors until oil comes out the pressure port. Repeat a few times until no air bubbles are present.
  3. Install the chain case cover.
  4. Clean out the oil pickup or replace as required. Replace the oil pickup O-ring and install the pickup to the pump.
  5. Install the oil pan.
  6. Install the dipstick. Fill the engine with the proper amount of oil.
  7. Connect the negative battery cable and check the oil pressure. Check for any oil leaks.
for the 3.3 you can rebuild, 3.0 - replace.

Feb 15, 2011 | 1994 Dodge Caravan

1 Answer

Location of oil pump


Inside the engine front cover on a 3.8 liter motor
d51e774.gif

Oct 20, 2010 | 2003 Chevrolet Impala

1 Answer

Location of oil pump on a 3.8 liter ford


It should be inside the oil pan. You will need to somehow get the oil
pan offf, in order to remove the oil pump. Make sure you check the
oil pressure to make sure that is the problem, before you go through
all that trouble getting to it?Good luck.

Mar 29, 2010 | 1985 Ford Thunderbird

2 Answers

1997 4Runner oil quantity


For a V6 # Liter engine, you will use a galon and almost half (that is about 6 Liters of oil). I use a Toyota camry V6 3 Liter engine that shares the same engine with the Toyota 4Runner.

Rate this Fixya!

Mar 21, 2009 | 1997 Toyota 4Runner

1 Answer

7.4 liter mpfi engine starts, then shuts down.


The oil pressure sending unit should be located behind the distributor way in the back angled away from the engine, fuel filter been changed?
www.aceautomotive1.com if you findd this information helpful please give me a good rating
if you like i can email you a diaggram and location of the sensor you need
my email: fixincars@yahoo.com

Aug 10, 2008 | 1999 Chevrolet K2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...