Question about 2003 Kia Spectra

Open Question

How do you replace a 2003 Kia Spectra Blower motor

Blower in my Kia has went out and is just trickling. It pops on from time to time bur otherwise it's shot. I checked all the fuses and such and have no idea how to do this project.

Posted by on

5 Suggested Answers

  • 1 Answer

SOURCE: replace thermostat 2003 kia spectra

Hello, my name is Mario.

1. Disconnect battery negative cable.
2. Drain engine coolant
3. Remove bolt and nut for thermostat housing
4. Remove the old thermostat
5. Put a new thermostat and gasket (Install thermostat into cylinder head with jiggle pin positioned up.)
6. Place thermostat housing
7. Fill radiator with engine coolant
8. Connect battery negative cable
9. Start engine and check for leaks.

Good luck

Posted on Jan 10, 2009

tony chavous
  • 50 Answers

SOURCE: Kia spectra wont start

it is probably the starter assuming the engine isnt locked up. I would check to see if you have battery voltage at the starters solenoid wire with the key in the start position if you do i would check the fuses and starter relay

Posted on Feb 01, 2009

  • 57 Answers

SOURCE: 2003 kia spectra check engine code p0604

I have bad news for you
p0604 is a transmission control module

check the connection at the transmission control module if there are no connection issues than you will need to replace the transmission controll module "tcm" there is no other test for that code.

good luck

wesleyschacht@hotmail.com

Posted on Jun 14, 2009

  • 2926 Answers

SOURCE: 2002 Kia spectra heater blower

The blower is only secured to the housing by a few screws and drops out when the screws are removed.

abbf15b.jpg

Posted on Sep 26, 2010

simplesol907
  • 22 Answers

SOURCE: 2005 kia spectra blower dont come on for the

The 2005 Spectra heating system comprises 4 main components and its associated wiring.

1. Blower Relay- supplies power to the blower motor when the key is in the on position

2. Blower motor- Located in the right side dashboard area near the passengers right foot. ( photo attached)

3. Resistor- located on the ground side of the circuit to control speeds 1 thru 3. Note" High speed bypasses this component.

4. A/C Control Module- This is the control pad in the dashboard with the blower speed controls.

The easiest way to diagnose this circuit is to split the circuit in half to determine if you have a power supply problem, ground control problem or a failed component. From your concern I am going to assume that none of the speeds work. If some of the speeds work let me know which ones and I will revise the diagnosis tree I made for you.

Key state for all tests is Key on/Engine off. Heater on and blower setting between 1 and 4.

Step 1. Verify the 30Amp blower fuse in the underhood fuse box has power and is not "Blown.

Step 2. Locate the blower motor by removing the lower kick panel on the passenger side dashboard and glove box. You will need a Phillips head screwdriver.

Step 3. Disconnect the two pin connector at the blower Connector G-02 in the attached photo. The red and blue wire is the power supply wire to the motor so with the key on/engine off check for power with a test light or volt meter. Spec: Battery Voltage. If good proceed to step 4. If no power proceed to step

Step 3.a.- the blower relay above the blower (connector G-06) and verify you have power leaving the relay. This is the red and blue wire ( Pin 4) I attached a photo of the connector to help locate the correct wire. If you have power at this pin the relay is working and you have an open between the relay and the blower motor. If you do not have power at this pin proceed to step 3.b. Verify that the relay clicks when you disconnect it from the harness and plug it back in. If it "clicks" and you have no power at pin 4 you have a bad relay. If it does not click you will need to check the power supplies to the relay. These are pins 3 (blue wire) and Pin 5 (Red wire). Be careful to check the correct blue wire as the other blue is the ground for the relay. (Pin 1). If you do not have power at either wire you have an open in the harness and further diagnosis will be needed. If you do have power at these wires then check the remaining blue wire for a ground. If you do not have a ground you may have a bad control module. To check this remove the plastic cover around the control head and radio and remove the control head from its mounting but leave plugged in to the harness. Check the white and blue wire in pin 21 of the large connector. It is located 3 pins in from the bottom left of the connector. (See attached photo). If you do not have a ground then you have a bad control module. To verify this you can ground this wire with a test light or fused wire and see if the relay "Clicks". If you do have a ground at this pin then you have an open between the relay and control head.

Step 4. - Ground check- Go to the blower motor connector and check the green and red ground wire (Pin 2) for a ground with the blower switch set to 4. This bypasses the resistor easing diagnosis. If you have a ground then the blower motor is at fault. If you do not have a ground proceed to step 5.

Step 5. Access the control head large connector. Leaving it plugged into the control head check pin 23 (Yellow black wire in the lower left corner of the connector) and verify you have a ground. If you do not have a ground you have a faulty control module. If you do have a ground you have an open between the blower motor and the control head requiring further diagnosis. simplesol907.jpgsimplesol907_0.jpgsimplesol907_1.jpgsimplesol907_2.jpgsimplesol907_3.jpg

Posted on Jan 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Replace blower motor


It's under the passenger side of the dash. Before you replace it. Run 12 volts to the red wire and ground the black. If it comes on full force. Replace the resistor, located right next to it. Blowers do die, but not nearly as much as the resistors do. Resistors are what control the speed of the blower.

Dec 27, 2014 | 2003 Kia Spectra

1 Answer

2005 kia spectra blower only blows 1 & 4 speeds


Could be the blower motor resister,it's located by blower motor,2 screws hold it on,easy to remove,click here to see part.

Dec 30, 2012 | 2005 Kia Spectra

1 Answer

Kia 2004 Spectra EX heater blower fuse keeps going bad .


You will probably need to replace the blower motor itself since the motor is requiring too much current to operate. It will continue to blow fuses until repaired or replaced.

Jan 01, 2011 | 2003 Kia Spectra

1 Answer

I jst need to know were does th blowmotor for ac is instal 02 kia


Hello, most blower motors a normally mounted under the the dash on the passanger side foot area. It usually covered by abs plastc sheald, simply pop that off or un screw it to remove it.

Mar 24, 2010 | 2002 Kia Spectra

1 Answer

The heater fan stoped workin


Check the blower relay,and the blower switch.

Feb 06, 2010 | 2003 Kia Spectra

1 Answer

2003 Kia Spectra. My heater just stopped working,


Your manual ,in the glove box,will tell where the fuse panel is,and witch fuse,if the fuse is not blown,the blower motor has went out.Find the blower motor,and bump it with your hand,it may,or may not make it stat running again,but if it starts back up,then the blower motor is bad for sure,testing the motor with a test light will tell for sure if it is getting voltage to it,and if it is,then it is bad,if not,the blower relay,or the fan control switch is bad,test them with a test light also.

Jan 07, 2010 | 2003 Kia Spectra

2 Answers

AC Blower motor died


This is more than likely just the resistor as a bad motor wouldn't start at all,And low refrigerant(Freon) has nothing to do with the blower.

May 28, 2009 | 2001 Kia Spectra

1 Answer

My Heater Only works on high when it does work the belt squeaks


Sounds like the blower motor is going out. and need full voltage to run. Are you might have leaves or trash in the duct work causing to motor to drag at low speeds, and making it make the noise that it is making.

Jan 31, 2009 | 2003 Kia Spectra

Not finding what you are looking for?
2003 Kia Spectra Logo

Related Topics:

400 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

yadayada
yadayada

Level 3 Expert

64286 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...