Abs system keeps going off and resetting each time i start my truck

A tip, when the ABS light comes on it usually means the ABS system has sensed a problem. Unless you are trained with ABS stay away it is dangerous to work with. I have bleed the brakes at the wheel only and it reset itself or some parts houses like Auto zone, advance have free testing on this type system. and also they can reset the light for you if it was only a slight reset needed.Good luck and if someone else can give you better advice listen to them OK Mike L

Abs does not reset. Every time you start the car the ABS goes through a self test.

Hello
Whenever the ABS warning light comes on in the instrument cluster and it stays on it means the systems electronic control module (computer) has detected a problem in one or more of the inputs to the module, an ABS fault code is present as long as the ABS light is on. So what must be done to correct this? You must have the ABS electronic control module scanned with a special tool to read the fault code, then a trained technicain will diagnose and repair the defective part or wiring. Most times this is a wheel speed sensor (one for each wheel) that gives an erratic signal. While the light is on all you have is regular non-ABS brakes. I assume here the light is on all the time? Until the problem(s) are fixed that are keeping the light on are repaired it will no go off, it can't be reset manually.

If the abs light is on than there is a problem with the abs. If the problem was fixed the light would go out on it's own once the self test completed successfully when you started the vehicle. If you have not pulled codes or made a repair than turning off the light with a scan tool capable of reading abs data will only result in the light coming back on when the abs module still sees the fault present when you start the vehicle the next time. The first thing to do is find out what codes are present. Then focus on that part of the abs system. If you know the code or find out what the code is post it and I'll help you figure it out.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Any good parts store like Autozone, Advance, etc... can reset your AWD and low tire lights. The abs is sensing a problem with your anti lick brake system - they normally do a "self test" when you start up and reset themselves if "All Systems Go". RE: ABS check wheel sensors etc, and a note on others if reset is done and lights/alarms returns then you have a problem within those systems.

TCS And 4wd use the abs wheel sensors to engage and disengage so if there is a slight fault in the abs sensor system TCS will be disabled and the 4wd will either not engage or disengage depending on the drive position set at time of fault that is what the lights are telling you
Get the sensor system checked out from the abs rings on the axles to the sensors and wiring to the abs pump controller

check wires and connections for the abs sensors for damaged or loose connections abs and traction control are connected

if the abs light is on and stays on there is a problem with the system,there should be a code present,if it was functioning properly the light would go off when u started moving,you should have the abs system scanned and start from there,hope this helps

The system resets every time you start the car. If the ABS light stays illuminated then you have some sort of fault.

ur brain in the car needs to be reset if that does not work u might have to replace ur abs system u can take ur car to a local auto zone or advance auto and they can reset it and see if there is a error code with the light also some times the longer the light stays on or refuses to reset says there is a problem with u abs system