Question about 1996 Chevrolet Suburban

1 Answer

Fuel leakage my 96 suburban has a vortec system and is leaking between the filter and the intake i know it's the fuel line cause i can see it but where can i get it repaired or get the part?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 93 Answers

If its the actual line you'll have to get from the dealer. Dorman makes a fuel line repair kit but its a few hundred $.

Posted on Nov 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

VORTec 5.7L. backfires at startup and now it goes to full throttle...why


These vortec engines are prone to leak fuel from fuel pressure regulators inside the intake manifold ,an from injector pop it valves . How to replace the spider injector on Cheyv motor 4 3 or 5 7 liter check out this guys video

Dec 02, 2015 | 1997 Chevrolet Suburban

1 Answer

Hard to start keeps cranking then fires over and engine flutters but still doesnt start till 2 more times then when you take off you give it gas and it bougs down and no power pops then after it warms up...


check for codes, if none then check fuel pressure and volume with a gage. pressure should be in the area of 35lbs unless this is throttle body which is about 15/18lbs pressure, if this is a vortec motor the pressure is 55lbs. the volume should be about 1 liter in 15 seconds. the vortec injection systems have a problem with the spider fuel lines that go to each injector cracking/breaking causing no fuel supply and leaking into the intake manifold and not going into the cylinders.

Aug 23, 2014 | 1999 GMC Suburban

2 Answers

Head gasket or intake manifold gaste again 96 k1500 5.7 vortec. starts runs idles and drives rough it likes to **** while trying to drive almost as if it wants to stall out. i put my scanner on it and


The website has software that looks for obscene words.
I would think a compression test would show if the cylinder is having mechanical problems. And yes the intake or head gasket could be leaking again, especially if the intake or head were warped or cracked.
Have you checked fuel pressure ?
Does the spark plug for cylinder 5 show signs of coolant leaking into the cylinder ?

Feb 09, 2013 | 1996 Chevrolet K1500

1 Answer

95 S10 blazer 4.3 vortec skipping code po172 and po300 possible solutions


P0172 system too rich bank 1. P0300 random multiple misfire. All are a common symptom of either bad fuel pressure regulator or leaking injector. Need to pull off intake plenum (upper) You should visibly see a clean side or part of intake manifold (lack of carbon buildup) Reconnect fuel lines. Energize fuel pump (turn on key to run) Most likely you will see fuel dripping out of rear (fuel pressure regulator) or nylon lines to each cylinder (fuel injectors). Once you see which is leaking will need to replace. Once they are repaired will need to clean or replace spark plugs & change oil & filter.

Jun 26, 2010 | 1995 Chevrolet Blazer

3 Answers

Strong gas smell and idles rough. did tune up. no


look at the fuel lines and injectors for signs of leakage.

Feb 14, 2010 | 1997 Chevrolet K1500

3 Answers

I own a 96 chevy k1500 5.7 l vortec and have a no 5 cyl misfire


It could be a faulty fuel injector, try running a fuel injector cleaner through your fuel system. At worst the poppet nozzle has gone bad and will need to be replaced, you can buy the poppet nozzle it self individually at Auto Zone or buy upgrade MFI system which is much better and less pron to fuel leaking room a cracked poppet line or nozzle which will cause what you have described.

Feb 03, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

96 gmc vortec will not start


I AM LOOKING AT TIMING ISSUES OR INTAKE MANIFOLD LEAK.OR EGR VALVE STUCK OPEN.

Dec 30, 2009 | 1996 GMC Sierra

2 Answers

How to manually get a trouble code out of a 95 blazer with vortec


The vortec motor has been known for the so caller spider assembly which is the fuel injection set up inside the intake manifold going bad.The regulator starts leaking wich puts extra fuel into the motor.If that is it you should change the whole assembly.

Nov 30, 2008 | 1995 Chevrolet Blazer

1 Answer

Random misfiring on pistons on a 1996 chevy suburban


1st thing to check is the intake manifold for vacuum leaks, also check and make sure the EGR valve is not leaking when it is closed, to check the intake buy a can of carb spray and sray around the top of the engine, if a leak is present there will be a very noticeable change when the spray is near the vacuum leak. To check the EGR Valve start the engine cold, wait a minute or 2 then spray water on the EGR, if it steams up the water it is leaking exhaust into the engine, this will cause a rough run as well.

Sep 09, 2008 | 1996 Chevrolet Suburban

Not finding what you are looking for?
1996 Chevrolet Suburban Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...