Question about 1995 Jeep Grand Cherokee

3 Answers

1999 JEEP GRAND CHEROKEE LAREDO

For some reason my stock alarm just keeps going off, lights flashing and horn blowing back to back. How do I disarm the alarm?

Posted by on

  • 6 more comments 
  • jtwally Dec 03, 2008

    same problem as this guy.. pluys it starts and then dies sometimes and then will run fine the next day

  • kerri_trost Dec 06, 2008

    I have the same problem. Any help?

  • kisha_muriel Dec 11, 2008

    What I did was pulled the horn fuse out and went without a horn for a couple of days (which is dangerous) and put it back in and now it doesn't go off. Not professional help but it worked.

  • Anonymous Mar 18, 2014

    how can i disarm the alarm so i can drive and start my jeep?

  • Anonymous Mar 26, 2014

    What is wrong and how do i fix this?

  • Anonymous Mar 26, 2014

    I have a 2008 gmc yukon xl. What is wrong with this vehicle and how do I fix this?

  • Anonymous Mar 30, 2014

    Alarm keeps going off after I lock doors

  • Anonymous Mar 30, 2014

    Alarm keeps going off after I lock my doors how do I core this problem

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

I have a 95 jeep grand cherokee lerado from time to time my alarm goes off i dont have a remote 4 my alarm but i found out that if you put the key in the driver door and unlock it. it will reset the alarm!!!!!

Posted on Dec 12, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same issue... It was a broken door switch... Replaced it for about $7... No more issue

Posted on May 28, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 60,667 Answers

Most likely this is the alarm switch in the drivers door, if it malfunctions the alarm thinks the door has been opened without a key.

Posted on Dec 09, 2008

1 Suggested Answer

Mikey108
  • 475 Answers

SOURCE: ALARMS

Insert key into drivers door lock and turn the key to unlock

Posted on Nov 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep alarm goes off for no reason after a few minutes


IT is probably just letting you know that it has received the lock signal and has secured the vehicle. Horn beps or clearence lights flask

Feb 03, 2013 | 1999 Jeep Grand Cherokee

3 Answers

How to permanently disarm alarm on 1995 Jeep Grand Cherokee Laredo


#1 solution for this is to " BUY A GM PRODUCT" & save your money on costly repairs of these chrysler & JEEP (amc) vehicles!

Apr 25, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Jeep grand cherokee alarm system


The 1995 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Nov 25, 2011 | 1995 Jeep Grand Cherokee

1 Answer

1997 Jeep grand cherokee laredo with 4.0 starts and stops immediatley will not run. also horn blows like alarm has gone off


The VTSS (Vehicle Theft Security System) might be armed. To dissarm insert and rotate the key on the driver door lock or the passenger door lock or the liftgate door lock. You can also disarm it by pushing the button on the keyless control unit.

May 31, 2010 | 1997 Jeep Grand Cherokee

1 Answer

1999 Grand Cherokee Limited Jeep anti-theft system had shut all electronics down and engine will not start. what can I do to reset the system....


The 1996 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE.

Also, remember that here can find the Jeep Grand Cherokee Service & Repair Manual.
Hope help with this.

May 03, 2010 | 1999 Jeep Grand Cherokee

2 Answers

How doyou disarm the factory alarm system in a 1994 jeep grand cherokee my alarm system keeps shutting down the whole car it is a real pain to get it started again i just want to totally shut the alarm...


The security alarm system on the 1994 Jeep Cherokee arms itself on any normal exit from the vehicle, i.e. ignition off, open door, lock door with power door locks, close door. If the doors are locked with the key, it does not arm.
If the battery is disconnected, then reconnected, the alarm system will go into powerup alarm mode. The lights will flash, but the horn will not blow.
The alarms can be disarmed by a keyless vehicle remote or by unlocking either of the front doors or the read lift gate with the key. If the key method does not work with any of those three entrances, there is a problem either with the input to the alarm module or the module itself.
There is a switch in both front doors and the tailgate which is activated by manualy unlocking those doors. The alarms can be disabled by permanently grounding the wire going from either of those switches to the alarm module, but this will remove all theft protection.
The best thing to do is to find out why the system is going off in the first place. It could just be a glitch, a loose connection that can be fixed fairly easily and keep your theft protection intact.

Glenn

Feb 23, 2010 | 1994 Jeep Grand Cherokee

1 Answer

How can I reset my Factory Alarm on my Jeep it wont run


Alarm Module Reset Procedure
NOTE: This information applies to a Vehicle Theft Security System (VTSS) that was armed when the battery was disconnected and reconnected.
When the armed VTSS senses that the battery has been disconnected and reconnected, it enters its power-up mode. In the power-up mode the alarm system remains armed following a battery failure or disconnect. If the VTSS was armed prior to a battery disconnect or failure, the system will have to be actively or passively disarmed following a battery reconnection.
The power-up mode will also apply if the battery goes dead while the system is armed and battery jump-starting is attempted. The engine no-run feature will prevent the engine from starting until the alarm system has been actively or passively disarmed.
Passive disarming of the Vehicle Theft Security System (VTSS) occurs when the vehicle is unlocked using the key to unlock either front door or the lift gate. Active disarming of the VTSS occurs when the vehicle is unlocked by depressing the Unlock button of the Remote Keyless Entry (RKE) transmitter.
Once the alarm has been activated (horn sounding, lights flashing, and the engine no-run feature), either disarming method will deactivate the alarm.
Depressing the Panic button (if equipped) on the RKE transmitter will also disarm the VTSS, but the horn will sound and the lights will flash for about three minutes as part of the Panic feature. The horn and lights can be stopped by pressing any of the RKE transmitter's buttons or driving the vehicle above 15 mph.

Jan 28, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Disarm malfunctioning alarm system jeep cherokee 1999


try to find a fuse and take it out it may have one just a guess

Dec 28, 2008 | 1999 Jeep Grand Cherokee

1 Answer

ALARMS


Insert key into drivers door lock and turn the key to unlock

Nov 19, 2008 | 1999 Jeep Grand Cherokee

1 Answer

Disarming alarm system


if the horn is on and the light blinking with the alarm all what you have to do is close all the doors, then luck it and unluck it with the key on the drivers door.

May 27, 2008 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

1,282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...