Question about 2005 Hummer H2

Open Question

05 hummer h2 sut- short circuit board washer fluid

I have trouble with circuit board washer fluid, when pull switch is off position it's spray water, and when it on position water stop spray but wiper is runing. I need to replace this circuit board can't find where it locate, I call dealer they won't tell me they want me to bring the car down to them. Please help if any body know where it's located.

Thanks
Svatdy

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 2003 HUMMER H2

Had the same problem. i have to re-place my front wiper motor they are all connected.

Posted on Feb 25, 2009

  • 1 Answer

SOURCE: I just got my 2007 hummer h2 sut, but I don't know how to turn on

The fog lights run by default during the day in the "auto" position. To activate the headlights and the fog lights you need modify the jumper position in the fuse box for the lights. "see fuse box diagram"

Posted on Jun 26, 2009

iambanshee74
  • 3489 Answers

SOURCE: i have a 2004 h2 hummer and my wipers and sprayer

they have a controll module afixed to the wiper motor itself. these modules have been an issue for gm for some time. they are very simple to replace and "usually" fix the issue.

Posted on Nov 02, 2009

  • 1 Answer

SOURCE: I need to remove the luggage racks from my 2007 Hummer h2 SUT

I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Posted on Dec 27, 2009

dttech
  • 4803 Answers

SOURCE: The reduce engine power message

The Powertrain Control Module (PCM) is shutting down your throttle body control for some reason and limiting how much throttle you can apply. The only way to find out why it is doing this is to scan the PCM for Diagnostic Test Codes (DTCs) and diagnose any existing codes accordingly. It is very likely to be caused by a fault in your throttle position sensor or accelerator pedal position sensor circuits.

There is a Technical Service Bulletin (TSB) for your vehicle which covers a known problem with reduced engine power and sets DTC P2138. The known problem is that the Accelerator Pedal Position (APP) sensor circuits are being infiltrated by water intrusion into a connector and causing erratic voltage readings at the PCM. It is TSB reference # 07-06-04-019D

Posted on Jul 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Theft lock


You can't. You need to see the dealer to have the system scanned for faults.

Nov 15, 2012 | 2005 Hummer H2 SUT

2 Answers

The reduce engine power message keeps coming on, giving limited power when driving does anyone know what the proble could be with my 2007 hummer H2 SUT.


The Powertrain Control Module (PCM) is shutting down your throttle body control for some reason and limiting how much throttle you can apply. The only way to find out why it is doing this is to scan the PCM for Diagnostic Test Codes (DTCs) and diagnose any existing codes accordingly. It is very likely to be caused by a fault in your throttle position sensor or accelerator pedal position sensor circuits.

There is a Technical Service Bulletin (TSB) for your vehicle which covers a known problem with reduced engine power and sets DTC P2138. The known problem is that the Accelerator Pedal Position (APP) sensor circuits are being infiltrated by water intrusion into a connector and causing erratic voltage readings at the PCM. It is TSB reference # 07-06-04-019D

Jul 18, 2011 | 2007 Hummer H2 SUT

1 Answer

What's the capacity of the rear diff, I want to change the fluid. 05 Hummer H2 SUT


actually just fill till it comes out of the hole but generally will hold less than 2 quarts. make sure that you have the correct diff fluid and any additives that it requires. dealer can get you the correct additive. cheers

Dec 30, 2009 | 2005 Hummer H2

1 Answer

I need to remove the luggage racks from my 2007 Hummer h2 SUT


I have the same vehicle and was able to remove mine with the following steps: 1) remove light behind each rear of luggage rack rail using phillips screwdriver (one screw each side). 2) remove molding underneath each light using T20 torx driver (2 screws each side). 3) Loosen cross rails nobs. 4) Side cross rails off of roof.

Nov 27, 2009 | 2007 Hummer H2 SUT

1 Answer

I have a 2004 h2 hummer and my wipers and sprayer


they have a controll module afixed to the wiper motor itself. these modules have been an issue for gm for some time. they are very simple to replace and "usually" fix the issue.

Oct 25, 2009 | 2005 Hummer H2

1 Answer

I just got my 2007 hummer h2 sut, but I don't know how to turn on


The fog lights run by default during the day in the "auto" position. To activate the headlights and the fog lights you need modify the jumper position in the fuse box for the lights. "see fuse box diagram"

Apr 05, 2009 | 2007 Hummer H2 SUT

2 Answers

Hummer H2 rear wiper and sprayer came on by itself


It sounds like the wiper control module. The wipers on my 2003 did the same thing. After I pulled the fuse for the rear wiper, the front wipers started acting up as well. I had to pull fuses to stop them too. There is a recall on 2003 H2's for this issue. The cover of the wiper module on 2003s for the allows rain/water to get into the module. The cover will be replaced for free, however, in my case since the module was full of water and my wipers were not working, they replaced the module for free also. Not sure how much it would cost to replace on a 2005.

Dec 21, 2008 | 2005 Hummer H2

1 Answer

2003 HUMMER H2


Had the same problem. i have to re-place my front wiper motor they are all connected.

Dec 08, 2008 | 2003 Hummer H2

1 Answer

Hummer H2 SUT DTC Code C0563


C0563 - Calibration ROM Checksum Error
Not sure what it means but thats what I found when I looked it up

Oct 27, 2008 | 2005 Hummer H2

Not finding what you are looking for?
2005 Hummer H2 Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hummer Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Hummer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...