Question about 1991 Toyota Camry

1 Answer

91 camray 2.0 4cyl. wont start after driving for 20 min.

After driving the car for a short time and it reaches normal temps and you shut it off and go to start it back up it wont turn over. all dash lights work and everything else but no starter action! I can push start the car and it will start and run,or if the car sits for say 30 min it will start again. So, is a circut getting hot or something? the starter when it does work sounds completely normal, how about the switch at the clutch petal it seems like that ****** has to be cramed to the floor kinda hard, could that be a problem? Where should i start?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 109 Answers

I would start by have the starter itself checked. Electrical resistance may be increased by warmer temperatures.

Posted on Nov 19, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2004 dakota-after driving 20-30 min in 80 degree outdoor temps the truck wont restart as if it isnt getting fuel. Problem never occurs in cooler temps.After a short time it will restart and runs normally...

check for hot fuel lines causing a vapour lock situation. move any lines away from heat sources or insulate with fibre glass cloth
if it is a carby unit , the problem can sometimes be overcome by placing a fuel filter in the line just next to the carby

Feb 12, 2015 | 2004 Dodge Dakota

1 Answer

Motor shuts down when reaching normal operation temp

Sounds like the mass air flow sensor or the air intake temperature sensor. Sometimes just wiping out the throttle body/air intake can make all the difference

Good Luck and Happy Motoring

Jun 22, 2017 | 2000 Dodge Durango

1 Answer

Will crank sensor cause the car to kill when it gets normal operating temp and then 20 or 30 min later start up again

Check the ignition module and coils alot of times the module went its going out will do that.When it gets warm the car will shut off and sometimes it will start back up and sometimes it won't.

Apr 22, 2012 | 1996 Chrysler Cirrus

2 Answers

My 1999 villager heater is not working you get a little heat the higher the engine rpm. and i have got the heater to work and its so hot you can't hardly hold your hand next to it. but then when you take...

Could be the heater valve is not opening very far. Could be the heater core is mostly plugged with rust. Could be the thermostat is not closing. Do you have a temp gauge on the dash? Does the engine reach normal temp in about two miles of driving?

Jan 28, 2011 | 1999 Mercury Villager

3 Answers

2000 vw cabrio runs normal and shuts down, takes 5 to 20 minutes to restart, engine cranks but doesnt start, changed ignition coil, pulled diagnostic codes getting short to ground codes on cylinder...

On some models, the Engine Control unit has a power supply relay. These relays some times get internal dry solder points. After driving for some time the the solder will get hot and separate. When it cools down it makes contact again. You will have to replace this relay or open it up and re- solder the solder joints. The relay is usually located on the main relay station in position 3. the relay station is located behind the right dash panel.[right hand drive vehicles]. You may need to refer to a manual for your specific model to find the exact location of the relay.

Jun 04, 2010 | 2000 Volkswagen Cabrio

1 Answer

I have a 1991 buick regal stalls and shut off after warming up

egr valve is not opening up when the engine reaches it normal operating temperture

Feb 07, 2010 | 1991 Buick Regal

1 Answer


The BMW have divices to mesure the temperature check the cooland that you using and the oil of the car, also check if the car temperature goes up fast when you turn on the car.

Feb 02, 2010 | 2003 BMW 325

2 Answers

First thing in the (cold) mornings heater wont work. water gauge flux's up and down weird . then about 20 mins into driving its warms up

Your engine coolant is what your heater gets the heat from. You need to start your car and let it warm up for awhile before any heat will come. This is how most cars heaters work. Yours sounds like it is working fine; most cars take a little while to warm up.

Hope this helps!

Dec 07, 2009 | 1992 Toyota Paseo

1 Answer

91 Taurus stauling problem

Check your fuel pressure thru out the rpm. If irratic or drops hard then its the fuel pump.

Jan 18, 2009 | 1987 Chevrolet Chevette

Not finding what you are looking for?
1991 Toyota Camry Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides